Empire Comfort Systems SR-30 - Manuals

Page 2 - TABLE OF CONTENTS

16942-5-0907 Page 2 Important Safety Information ............................................................................... 3 Safety Information for Users of LP Gas ............................................................... 4 Introduction ......................................................

Page 3 - WARNING; THIS IS A HEATING APPLIANCE; DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.; IMPORTANT SAFETY INFORMATION

16942-5-0907 Page 3 • An unvented room heater having an input rating of more than 6,000 Btu per hour shall not be installed in a bathroom. • An unvented room heater having an input rating of more than 10,000 Btu per hour shall not be installed in a bedroom or bathroom. • Due to high temperatures, th...

Page 4 - SAFETY INFORMATION FOR USERS OF LP-GAS

16942-5-0907 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. You must ﬁnd out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detec...

Page 7 - GAS SUPPLY

16942-5-0907 Page 7 The gas line can be routed either through the ﬂoor or wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of ﬂoor joists and the valve and union used for servicing. Gas Supply Check all local codes for requirements, e...

Page 10 - WALL MOUNT INSTALLATION

16942-5-0907 Page 10 When facing the front of the appliance the following minimum clearances to combustible construction must be maintained. Left side 8 inches (203mm). Right side 8 inches (203mm). Do not install in alcove or closet. Rear wall 0 inches (0mm). Ceiling 36 inches (914mm). Minimum verti...

Page 12 - OPTIONAL FLOOR STAND INSTALLATION

16942-5-0907 Page 12 1. Align clearance holes on ﬂoor stand with screw holes on bottom of heater, as shown in Figure 14. 2. Attach ﬂoor stand to heater with (4) screws provided with ﬂoor stand. 3. Connect the gas line. *Floor stand can not be used in a bathroom or bedroom installation. SR-6 must be ...

Page 13 - FOR YOUR SAFETY READ BEFORE LIGHTING; ing property damage, personal injury or loss of life.; LIGHTING INSTRUCTIONS

16942-5-0907 Page 13 FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a ﬁre or explosion may result caus- ing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow t...

Page 14 - MAIN BURNER FLAME CHARACTERISTICS

16942-5-0907 Page 14 SR-6 Main Burner Flame (Figure 15) The main burner ﬂame will have a red-orange glow over the sur- face of the ceramic plaque. The red-orange glow on the surface of the ceramic plaque will have a pattern in the shape of a number 1. The perimeter of the ceramic plaque [approximate...

Page 15 - PILOT FLAME CHARACTERISTICS

16942-5-0907 Page 15 The correct ﬂame will be blue and will extend beyond the thermocouple. The ﬂame will surround the thermocouple just below the tip. A slight yellow ﬂame may occur where the pilot ﬂame and main burner ﬂame meet. Figure 17 Oxygen Depletion Sensor Pilot (Figure 16) When the pilot ha...

Page 16 - APPLIANCE MAINTENANCE

16942-5-0907 Page 16 1. Spark electrode does not produce spark. a. Spark electrode broken - replace. b. Ignitor wire may not be attached to spark electrode - attach. c. Ignitor wire damaged - replace. d. Piezo ignitor defective - replace. 2. Spark electrode produces spark but pilot does not light. a...

Page 17 - PARTS LIST

16942-5-0907 Page 17 USE ONLY MANUFACTURER'S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through the distributor. Parts can be shipped directl...

Page 23 - OPTIONAL BLOWERS; for Unvented Room Heaters SR-18 and SR-30; OPTIONAL BLOWER INSTALLATION INSTRUCTIONS

16942-5-0907 Page 23 INSTALLING OPTIONAL BLOWER SRB-18 OR SRB-30 If heater is installed onto the wall, in order to install the optional blower, the heater must be removed from the wall. If heater is installed on op- tional ﬂoor stand there is adequate access area available to install the optional bl...

Page 24 - OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)

16942-5-0907 Page 24 Wiring The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electri- cal Code, ANSI/NFPA 70, if an external electrical source is utilized. This appliance is equipped with a three-prong [g...