Empire Comfort Systems DV-210-7SG - Manuals

Page 2 - TABLE OF CONTENTS

12433-7-0107 Page 2 SECTION PAGE Important Safety Information ......................................................................................................................3Safety Information for Users of LP Gas ...................................................................................

Page 3 - THIS IS A HEATING APPLIANCE; DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.; IMPORTANT SAFETY INFORMATION

12433-7-0107 Page 3 • Due to high temperatures the appliance should be located out of trafﬁc and away from furniture and draperies. • Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. • Young children should be...

Page 4 - SAFETY INFORMATION FOR USERS OF LP-GAS

12433-7-0107 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. You must ﬁnd out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detec...

Page 5 - REQUIREMENTS FOR MASSACHUSETTS

12433-7-0107 Page 5 REQUIREMENTS FOR MASSACHUSETTS For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust ve...

Page 6 - National Fuel Gas Code ANSI Z223.1/NFPA; INTRODUCTION

12433-7-0107 Page 6 Introduction Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of a direct vent wall furnace.Instructions to Installer 1. Installer must leave instruction manual with owner after installation. 2. Installer mus...

Page 7 - Locating Gas Supply

12433-7-0107 Page 7 Locating Gas Supply The gas line can enter the unit either through the ﬂoor or outside wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of ﬂoor joists and the valve and union used for servicing. Note: Never use pla...

Page 9 - Installing a Vent Near a Window Ledge, Other Type of Projection

12433-7-0107 Page 9 3" (76mm) diameter ﬂue outlet tube. Attach vent cap to outside wall plate with (3) #10 x 1/2" (13mm) screws provided. 5. Reassembly and resealing vent-air intake system is completed. Installing a Vent Near a Window Ledge, Other Type of Projection or on Siding (vinyl, alum...

Page 11 - PILOT; LIGHTING INSTRUCTIONS

12433-7-0107 Page 11 1. STOP! Read the safety information above.2. Set the thermostat to lowest setting.3. Turn off all electric power to the appliance (if appli- cable). 4. Remove control access panel (front panel).5. Push in gas control knob slightly and turn clockwise to "OFF". NOTE: Knob...

Page 12 - PILOT FLAME CHARACTERISTICS

12433-7-0107 Page 12 On the main burner, the burning gas forms a primary ﬂame and a secondary ﬂame. The primary ﬂame is blue and about 3/16" (5mm) high. The secondary ﬂame is very pale blue, 3 inches (76mm) to 5 inches (127mm) high. Dust in the combustion air will produce an orange ﬂame. Do not ...

Page 13 - TROUBLESHOOTING

12433-7-0107 Page 13 1. Lit match goes out as it enters lighter port. a. Certain wind conditions will blow out match. Ignite match, and as it ﬂares, thrust match through opening. b. Open nearby door or window and relight pilot. 2. Pilot ﬂames but goes out when knob is released. a. See Lighting Instr...

Page 15 - PARTS VIEW

Page 16 - Cleaning the Blower Wheel

12433-7-0107 Page 16 DVB-1 For Direct Vent Wall Furnaces DV-210-(7, 9)SG and DV-215-(7, 9)SG BLOWER MOUNTING TAB Cleaning the Blower Wheel In some areas, such as near bedrooms and on ﬂoors with a hard surface, the blower wheel will be ﬁlled with lint very quickly. A visual check of the blower wheel ...

Page 17 - SERVICE NOTES