Emerson 16C26S-010- Manuals

Page 2 - ELECTROCUTION HAZARD; WARNING; TABLE OF CONTENTS

2 RULES FOR SAFEINSTALLATIONAND OPERATION Please read instructions before installing and using theElectronic Air Cleaner. This will help you obtain the fullbenefit from the Electronic Air Cleaner you have selected. WARNING ! ELECTROCUTION HAZARD Shut off power at fuse panel beforeservicing. Failure ...

Page 4 - PREINSTALLATION; LOCATING THE AIR FILTER; DIRECTION OF AIR FLOW THROUGH THE

4 PREINSTALLATION facing the power door. Air flow direction must agree witharrow embossed on end of collecting cells. After installing the cell sections, install pre-filters in cabi-net tracks on the right. This will again place the pre-filterson the air entering side (on the same side as ionizingwi...

Page 5 - TYPICAL MOUNTING POSITIONS

5 TYPICAL MOUNTING POSITIONS BASEMENT FURNACE(LOWBOY) (Figure 6) Cleaner is mounted hori-zontally in return plenum,just above furnace. COUNTERFLOWFURNACE (Figure 7) Cleaner is mounted horizon-tally in return duct or plenum,just above furnace. HIGHBOY FURNACE(Figure 8) Side installation. Cleaneri s m...

Page 6 - INSTALLATION; REMOVE OLD FILTER AND DISCARD; Transition Fittings

6 INSTALLATION REMOVE OLD FILTER AND DISCARD (Figure 12) NOTE: This filter may be mounted in the furnace compart-ment. CLEAN BLOWER COMPARTMENT It is suggested that the furnace blower compartment,blower and blower housing be cleaned to ensure clean aircirculation. INSTALLATION The following is a typ...

Page 7 - WIRING INSTRUCTIONS

7 WIRING INSTRUCTIONS 7. With the cabinet installed, the air cleaner can now bewired to electrical input source. WARNING ! Installation of this unit must comply with localelectric codes or other applicable codes. Review and understand local codes prior to in-stallation. Failure to do so could result...

Page 8 - OPERATION; CLEANING THE CELLS; CAUTION

8 An alternate method for controlling the air cleaneroperation is to install an F859-0381 Air Flow Switch/Harness Kit (available separately) that switches powerto the air cleaner when airflow is detected. NOTE: The air cleaner should not be operating un-less the furnace blower is on. 11. With the ca...

Page 9 - REPLACING AN IONIZING WIRE; SPECIFICATIONS

9 3. Release the latch on top of power pack and pull thepower pack straight away from cabinet at the top.Then lift pack out of ledge at bottom edge of cabinet.Set power pack aside. 4. Remove the cell(s) and pre-filter(s) from cabinet.Using a solution of warm water and low sudsingdetergent, soak cell...

Page 10 - Unit functioning Normally; BASIC UST SERVICE GUIDE

10 SERVICE INDICATION SERVICE CHECKS ON/OFF switch “ON” Unit functioning Normally Blower ONOperating Light ON ON/OFF switch “ON” 1. Power is not being supplied to air cleaner. Blower ON A. Check fuse or circuit breaker. Operating Light OFF B. Ensure power pack is properly installed and latched. 2. C...

Page 11 - TECHNICAL REPAIR GUIDE; Collecting Cell

11 TECHNICAL REPAIR GUIDE All voltage measurements indicated can be made with ahigh voltage D.C. probe and a general purpose volt ohmmeter. For example: Simpson 260 or equivalent. NOTE: All tests to be performed with the Ozone Reduc-tion Jumper intact. NOTE: When servicing the power pack components,...

Page 12 - Ozone Reduction Jumper; OZONE REDUCTION

12 POWER SUPPLY CHECKOUT PROCEDURE 1. Turn power switch to the “OFF” position and removethe power pack from cabinet. 2. Place power pack on a well insulated workbench.Connect meter negative (-) lead to the sheet metalchassis and the high voltage probe to high voltagecontact on back cover of power pa...

Page 13 - NOTES

Page 14 - REPAIR PARTS

Page 15 - PARTS LIST FOR ELECTRONIC AIR CLEANERS

15 ITEM NO. DESCRIPTION PART NUMBER 16C28S-010 1 Cabinet N/A 2 Pre-Filter • F825-0337 3 Collecting Cell • F811-0321 4 Junction Box Cover F838-0072 5 * Screw #6 x 3/8 ------ 6 Connector, Female F818-0053 7 Power Pack Assembly F858-0921 8 Cell Handle F832-0039 9 Ionizing Wire F843-0500 10 Light F844-0...

Page 16 - NOTICE TO CONSUMERS; Electronic Air Cleaner

White-Rodgers Division, Emerson Electric Co. 9797 Reavis Road, St. Louis, MO 63123-5398 314-577-1300 • FAX 314-577-1517 www.white-rodgers.com Controlling America’s Indoor Comfort NOTICE TO CONSUMERS White-Rodgers Electronic Air Cleaner Dear Consumer; White-Rodgers would like to thank you for purchas...