Electrolux EWW9043ADWA - Manuals

9 Drum Lifter Drain Pump Filter Door 2.2 Accessories To connect the drain hose on the edge of a sink. To close the holes on the rear side of the cabinet after the removal of the transit bolts. Plastic Caps Plastic Hose Guide Stainless Steel Washing Drum Drain Pump Filter Detergent/Softener Dispenser...

10 www.electrolux.com CONTROL PANEL 3. 3.1 Control Panel Description D E F G H I J K L M N O C B A A) B) Spin Speed Program Phase Indication Icon: C) D) Delay Start Icon Temperature ( corresponds to cold wash) Ultramix Phase Wash Phase Rinse Phase Spin Phase E) F) G) H) I) J) K) L) M) N) O) Door Loc...

12 www.electrolux.com 1) Energy Saver program with 40degC and 1400rpm is recommended for a full load of normally soiled cottons, and is the Water and Energy rating label program. Program; Temperature range 1200 rpm 4 kg – – – – 1 kg Type of load and soil level Max. Spin Speed Max. Load (Dry Clothes)...

13 3.4 Options 1) Vapour option can be combined with temperature 40°C to 90°C only. 2) Do not select a spin speed LOWER than that proposed by the appliance to avoid a too long drying time so saving energy. In any case the reduction of the spin speed is only possible after selecting drying. 3) This p...

17 To deactivate the function, press and hold “Prewash” touchpad about 2 seconds until the display shows the icon “ ”. Save Favourite ( ) Program 3.5 Settings This setting permits you to either enable or disable the buzzer at the end of the program. As an example, you might wish to disable this buzz...

18 www.electrolux.com BEFORE FIRST USE 4. Ensure that the electrical and water connections comply with the installation instructions. Put 2 litres of water in the detergent compartment for washing phase. This activates the drain system. 1. 2. 3. Select a Cottons cycle at 90 °C, without any laundry i...

19 ● ● DAILY USE - WASHING (Only) 5. Press the On/Off button to turn on the Wahser-Dryer. Turn the knob to set a program. The Wahser-Dryer will propose a temperature and automati- cally select the spin value provided for the program you have chosen. Check and remove objects (if there are any) that c...

If a program is not compatible with the drying option selected, the symbol “ ” will flash on display. After anti-crease phase finish, the door lock indicator “ ” goes off. The display will show “ ”. The display will show “ ” and “Anti Crease ( )” icon is lit.The door lock indicator “ ” is still on.T...

24 www.electrolux.com ● ● ● ● NOTE Load the laundry and add detergent and fabric softener. Make sure the load size does not exceed the maximum drying capacity of the machine. 1. Turn the knob to set a wash program which can select drying option (refer to Program Chart on page 11), according to your ...

25 WASHING HINTS 8. Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. 8.1 Sorting The Laundry 8.2 Temperatures 90°C Temp Soil level 60°C 50°C 40°C 30°C Cold For normally soi...

26 www.electrolux.com Oil based paint : moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains : moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust : oxalic...

27 DRYING HINTS 9. the washload to turn grey, greasy clothes. oversudsing, inadequate rinsing. reduced washing effect, Not enough detergent causes: Too much detergent causes: you are washing a small load, large amounts of foam during washing. the laundry is lightly soiled, Use less detergent if: As ...

28 www.electrolux.com 10. INTERNATIONAL WASH CODE SYMBOLS These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Bleach in cold water DO NOT bleach Bleaching Hand wash Max. wash temperature 95 °C Hot iron max. 200 °C Dry cleaning in all solvents Dry cl...

29 CARE AND CLEANING 11. You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Clean the appliance only with soa...

33 If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Emergency Drain 11.9 Frost Precautions Disconnect the main plug from the main socket. Turn off the water tap. 1. 2. Remove the water inlet hose....

34 www.electrolux.com 12.1 Possible Failures 12. TROUBLESHOOTING Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please check troubleshooting.Once the problem has been elimi...

38 www.electrolux.com In case of power failure or appliance failure, the appliance door remains locked. The wash program continues when power is restored. If the door remains locked in case of failure, it is possible to open it using the emergency unlock feature. Before opening the door: 12.2 Emerge...

44 www.electrolux.com This machine is designed to operate on a 220-240 V, single-phase, 50 Hz supply. 14.5 Electrical Connection “An incorrect power supply may void your warranty.” Check that your domestic electrical installation can take the maximum load required (refer page 39), also taking into a...

45 The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropyleneThis means that they can be recycled by disposing them properly in appropriate collection containers. To save water, energy and to help protect the environment, we recommend...