Electrolux ELFW7437AG - Manuals

6 FEATURES drum light door r eversibility 3 compartment dispenser Adaptive Dispenser™ detergent pack option pur e rinse optic whites hand wash whitest whites allergen sanitize stain tr eatment perfect steam wrinkle r elease fast wash 300 Series no yes yes no no no no no no no no no no no no 400 Seri...

8 PRE-INSTALLATION REQUIREMENTS Water supply requirements Grounding requirements Drain system requirements Grounding type wall receptacle Power cord with 3-prong grounded plug Do not, under any circumstances, cut, remove, or bypass the grounding prong. 1. The washer MUST be grounded. In the event of...

9 PRE-INSTALLATION REQUIREMENTS Installation in a recess or closet If washer and dryer are installed in the same closet, door ventilation is required: A minimum of 120 square inches (774.2 cm²) of opening, equally divided at the top and bottom of the door, is required. Louvered openings should be lo...

10 Louvered Door 120 sq. Inches min. Louvered Opening MIN. INSTALLATION CLEARANCES - Inches (cm) Sides Rear Top Front Alcove/ recess 0" (0 cm) 0" (0 cm) 0" (0 cm) Open Closet with door vent 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.5 cm) Closet with wall vent 1" (2.5 cm) 1&...

11 PRE-INSTALLATION REQUIREMENTS Washer dimensions * Connection of water inlet hose on steam dryer adds 3/4 in. (2 cm) to installation depth. 1 Power supply cord length on washer approximately 60 inches (152.5 cm). 2 Drain hose length on washer approximately 59 inches (150 cm). 3 Power supply cord l...

12 INSTALLATION Unpacking the washer 1. Temporarily remove door tape. 2. Close door and reapply door tape. 3. Using a rug, blanket or piece of cardboard to protect the floor, carefully lay the washer on its back. 4. Remove styrofoam base and shipping plug and set them aside. 5. Carefully return the ...

14 Rubber Washers Must Be Present USE ONLY NEW HOSES Leveling the washer Connecting the water 1. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog the water valve screens and to determine which faucet is hot and which is cold supply. 2. Check ...

15 6. Tighten by hand until snug. Then tighten each supply connection another 2/3 turn with pliers. Do not bend, kink or pinch water inlet hoses. 7. Turn on the water and check for leaks. Anti-Siphon Disc 1. Verify the anti- siphon disc is in place. 2. Form a “U” shape on the end of the drain hose w...

16 INSTALLATION Removing door assembly 1. Completely open the door to expose all four hinge screws. 2. Remove all four hinge screws with #2 square bit driver. Save for reinstalling later. 3. Hold the door with one hand supporting the handle area and one hand supporting the hinge. While supporting th...

17 INSTALLATION 2 1 Reinstalling door lock and hole cover 1. Move the plastic cover to the other side of the front panel. Position the cover so the “hook” is at the bottom. Insert hook into lower slot, slide the cover down, and press upper retention tabs into opening until they snap into place. 2 1 ...

18 INSTALLATION Fine Thread x4 2 1 3 4 Connect to Notches 3. Make sure the alignment tabs reengage. Reinstalling door assembly 1. Insert the wiring harness terminal into the terminal cap and wrap the harness into the harness retainer. Verify reversed door operation 1. Test door for free, smooth swin...

19 ACCESSORIES AND REPLACEMENT PARTS Accessories MATCHING STORAGE PEDESTAL* White Pedestal - P/N EPWD257UIW Titanium Pedestal - P/N EPWD257UTT A storage pedestal accessory, specifically designed for this washer may be used to elevate the washer for ease of use. This pedestal will add about 15” (38 c...

20 CONTROLS AND SETTINGS This manual covers many models and not all cycles, options, or features listed are available on every model. Consoles shown above for reference only. Your model may differ. 400 SERIES HOT WARM COOL ECO COLD HEAVY NORMAL LIGHT EXTRA LIGHT HIGH MEDIUM LOW NO SPIN EXTENDED REFR...

21 These temperature, spin speeds, soil levels and options are available with the following cycles: WHITES HEA VY DUTY NORMAL 20 MIN F AST W ASH DELICA TES RINSE & SPIN CLEAN W ASHER TEMP HOT    NO OPTIONS A VAILABLE WITH THIS CYCLE. DO NOT LOAD ANY ITEMS IN DRUM DURING SYSTEM CLEAN CYCLE. WA...

22 These temperature, spin speeds, soil levels and options are available with the following cycles: WHITEST WHITES HEA VY DUTY NORMAL 18 MIN F AST W ASH DELICA TES RINSE & SPIN CLEAN W ASHER TEMP SANITIZE    NO OPTIONS A VAILABLE WITH THIS CYCLE. DO NOT LOAD ANY ITEMS IN DRUM DURING SYSTEM CL...

23 CONTROLS AND SETTINGS ECO COLD COOL WARM HOT SANITIZE EXTRA LIGHT LIGHT NORMAL HEAVY SOLID SOIL ALLERGEN PERFECT STEAM PURE RINSE STAIN TREAT II EXTENDED REFRESH CONTROL LOCK DELAY TIME TEMP SOIL SPIN OPTIONS SELECT DE-SELECT HOLD ‘SELECT’ 3s TO MUTE/UNMUTE NO SPIN LOW MEDIUM HIGH MAX RINSE &...

24 STA IN SOAK CYCLES ECO COLD COOL WARM HOT SANITIZE EXTRA LIGHT LIGHT NORMAL HEAVY SOLID SOIL NO SPIN LOW MEDIUM ALLERGEN PERFECT STEAM PURE RINSE STAIN SOAK EXTENDED REFRESH HIGH MAX TEMP SOIL SPIN OPTIONS SELECT DE-SELECT HOLD ‘SELECT’ 3s TO MUTE/UNMUTE CONTROL LOCK DELAY TIME S M A R T B O O S ...

25 Cycle selection Press the power button to turn on the unit. Then, turn the cycle selector in either direction or press the cycles button (dependent on model) to scroll to the desired cycle. The indicator light for that cycle will be illuminated. The estimated cycle time will appear on the LED dis...

26 LOAD LOAD TYPE CYCLE DESCRIPTION OPTIC WHITES White loads • SmartBoost action• longer agitation • optimized temperatures WHITEST WHITES White loads • longer agitation • higher temperatures WHITES White loads • longer agitation HEAVY DUTY Large heavily soiled loads • longer agitation • aggressive ...

27 As a precaution, the washer door remains locked when the water temperature reaches 130°F (55°C) allergen (on select models) Removes dust mites and dander from household objects. The temperature does increase on this setting. PODS ® is a registered trademark of Procter & Gamble Company, Cincin...

28 Cycle options Max (on select models), high , medium and low (on some models) spin speeds are available for each cycle. The spin speed and/or duration of final spin vary from model to model and cycle to cycle.Increasing the spin speed will extract more water, decrease drying time and conserve ener...

29  NOTE • Steam may not necessarily be visible inside drum during a steam wash cycle. • Steam may not be present during entire steam wash cycle. CONTROLS AND SETTINGS • Chocolate Stain wash time is extended with additional heating by boost heater. StainSoak (600 series washer) Similar to StainTrea...

30 Chime A signal will sound at the end of each cycle (and periodically during extended refresh ) if option is activated. To mute or unmute the chime, press and hold the select button for 3 sec. MIN CLOSE DOOR CALL SERVICE ANY STAIN BLOOD CHOCOLATE O O R D options select de-select hold ‘select’ 3 s ...

32 STEPS TIPS IMPORTANT 1. Sort laundry into loads that can be washed together. • Sort by recommended cycle and water temperature. • Separate white, light, and colorfast items from dark and non-colorfast items. • Separate items that shed lint from items that attract lint. Casual, synthetic, knit, an...

33 STEPS TIPS IMPORTANT 1. Add wash products to dispenser. • Water conditioners, detergent boosters and enzyme products may be added with detergent. • See Adding Laundry Products for de- tailed information on the use of the prod- uct dispensers. • See Adding Laundry Products for detailed information...

34 Use a low-sudsing, high efficiency detergent to prevent oversudsing in front load washers. Look for this symbol on the detergent label: For best results Detergent, stain treatment (on select models), liquid chlorine bleach and liquid fabric softener will be dispensed at the proper times in the cy...

36 Adding other wash products • Color-safe bleach, water conditioner, detergent booster and enzyme products may be added with detergent. • Put liquid products in the Main Wash - liquid detergent compartment or powder products in the Main Wash - powder detergent compartment. Stain treatment (on selec...

37 NORMAL OPERATING SOUNDS Normal operating sounds You may or may not hear the following sounds from your new washer: A. DRAIN HOSE The washer has a flexible drain hose to carry water from the washer to the stand pipe of your home. You will hear water flowing into your stand pipe. This is a normal p...

38 STAIN REMOVAL GUIDE To reduce the risk of fire or serious injury to persons or property, comply with the basic warnings listed below: • Read and comply with all instructions on stain removal products. • Keep stain removal products in their original labeled containers and out of children’s reach. ...

40 CARE AND CLEANING To help prevent odors or humidity accumulation leave the door open with the door stand ventilation feature (on select models) for a few hours after use or whenever the washer is not in use. Inside routine cleaning (preventative) To refresh or clean inside of washer To clean and ...

41 4. Rinse the drawer and inserts with hot tap water to remove traces of accumulated powders and liquids. Large amounts of fabric softener residue may indicate improper dilution or more frequent cleaning is required. 5. To clean the drawer opening, use a small brush to clean the recess. Remove all ...

42 CARE AND CLEANING Inside cleaning (aggressive) In cases where clean washer cycle along with care and cleaning of rubber gasket folds isn’t done, and severe odor or residue buildup have developed, follow the below cleaning procedure to help alleviate the problem. Cleaning procedure-washer drum Ens...

43 RV ANTIFREEZE Follow WINTERIZ- ING INSTRUCTIONS for cold weather storage and care. • When washing is completed, wipe top and sides of washer with a damp cloth. • Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers • If the cabinet becomes stained, clean with ...

44 Rubber Washers Must Be Present Replace Hoses Every 5 Years 1. Turn off the water supply to washer to avoid water leaks due to water pressure surges and unforeseen occurrences in the water supply. 2. Disconnect or unplug the electrical power to the washer. 3. Remove excess water from the dispenser...

45 PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Blue stains • Undiluted liquid detergent or fabric softener dispensed directly onto fabric. • If caused by detergent, mix 1 cup (240 ml) white vinegar with 1 qt (.95 L) water in plastic container. Soak 1 hour. Rinse. • If caused by fabric soft...

46 TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES Pilling(Fibers ball up and cling to fabric.) • Pilling is normal with synthetic and permanent press fabrics. This is due to abrasion from normal wear. • Use a lint brush or shaver to remove pills. • Use fabric softener in washe...

48 TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS NOISE (Please refer to Normal Operating Sounds) High pitch “jet engine” noise • A certain amount of motor whine is normal during the spin cycle. Rattling and clanking noise • Foreign objects such as coins or safety pins may be in drum or pump. • B...

51 LIMITED WARRANTY For the applicable warranty period as set forth below, as measured from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in ac...