Edimax ER-5390S - Manuals - manualsarea.com

Page 2 - CAUTION; : The phone jack cannot be connected to telephone system.; FCC COMPLIANCE STATEMENT

This equipment generates and uses radio frequency energy and if not installedand used properly, that is, in strict accordance with the instructions provided witht h e e q u i p m e n t , m a y c a u s e i n t e r f e r e n c e t o r a d i o a n d T V r e c e p t i o n . T h eequipment has been teste...

Page 3 - Contents

Chapter 1 Introduction ....................................1 Chapter 2 Features & Specifications ..............2 Chapter 3 Package Contents ...........................3 Chapter 4 Physical Description .......................4 Chapter 5 Installation ......................................6 Chapter ...

Page 4 - Introduction; MHz; RESET TURBO

1 1 Introduction Congratulations on your purchase of Edimax’s 9-port desktop Ethernet 10Base-Thub - ER-5390S. This hub is specifically designed to provide simple, reliable andeconomical solution in small Ethernet 10Base-T networks. With eight RJ-45 and one BNC ports, ER-5390S supports up to eight wo...

Page 5 - Features & Specifications; port for mixed media network environment.

2 2 Features & Specifications (1) Features n Comply with IEEE 802.3 10Base-2 and 10Base-T Ethernet Standards. n Support eight RJ-45 connectors for 10Base-T connection and one 10Base-2 BNC port for mixed media network environment. n Built-in uplink port for easy connection to another hub using re...

Page 6 - Package Contents; -port desktop Ethernet Hub

3 3 Package Contents n 9-port desktop Ethernet Hub n One external power adapter n One T-Connector n User’s manual 3 Figure 3-1 Package contents PowerCollision LNK/RxPartition Rx 9-Port 10Mbps Ethernet Hub 1 BNC D I M A X 2 3 4 5 6 7 8 L A N P R O F E S S I O N L Partition

Page 7 - DIMAX; Physical Description

PowerCollision LNK/RxPartition Rx 9-Port 10Mbps Ethernet Hub 1 BNC DIMAX 2 3 4 5 6 7 8 L A N P R O F E S S I O N L Partition 4 4 Physical Description (1) Panel 4 Figure 4-1 Panel description 8 7 6 5 4 3 2 1 Uplink O U T IN Power LED Collision LED Link/Receive LED Partition LED BNC Port Uplink Port R...

Page 9 - Installation; Operating Environment

5 5 Installation 1. Operating Environment ER-5390S must be installed and operated within the limits of specified operatingtemperature and humidity (see previous section under Specifications). Do not placeobjects on top of the unit. Do not obstruct any vents at the sides of the unit. Do notposition t...

Page 11 - Power LED is not lit; the DC power jack is firmly plugged into the power socket of the hub.; LNK/Rx LED is not lit after connecting to an active workstation; they are turned ON.; Partition LED is lit; Ethernet device which causing excessive errors.

6 6 Trouble-shooting 1. Power LED is not lit l Check if the external power adapter is plugged into the power outlet. Make sure the DC power jack is firmly plugged into the power socket of the hub. 2. LNK/Rx LED is not lit after connecting to an active workstation l Check the power switch of the netw...

Page 12 - Collision LED is constantly flashing; source of the collision.

5. Collision LED is constantly flashing l Remove all the network cables; connect the cables back one by one to isolate the source of the collision. l Check the network cable, inferior cable quality will result in excessive collision and error packets. [!] Contact your dealer if problem persist. 9