Edimax AR-7025Um - Manuals - manualsarea.com

Page 3 - Hardware Indicators; LED Descriptions; Hardware Installation; LINE

2 1. Hardware Indicators 1.1 LED Descriptions z When modem is establishing the connection, the LED will be blinking. z When modem is connected, the LED will be on steadily. 1.2 Front Panel Connect this connector with Type-B end of USB cable. 1.3 Rear Panel Connect this connector with RJ-11 cable. 2....

Page 4 - Driver Installation; Before You Start; Note: Required if not using default value; Installing USB ADSL Modem; “Found New Hardware

3 4. Driver Installation 4.1 Before You Start The following information may be required for software installation. Contact your DSL service provider before proceeding with software installation. • IP Address Settings – the software installation process allows the server to dynamically assign IP Addr...

Page 6 - “Other”; go to

5 Step 3: Click “Install Driver”, and then select the country you are at, PS. If your country is not on the list, please click “ * ” to next page. Select “Other” , and then go to Step 10 to set your modem.

Page 7 - “User Name, Password and Password Confirm”; then click

6 Step 4: After country selecting, the window below will appear. Select the appropriate ISP, and then click “ `` ” to next page. Step 5: Enter your account “User Name, Password and Password Confirm” then click “ `` ” to next page,

Page 12 - modem settings. All settings here are default, it; might not; correct settings for your; “Accessing; to modify the settings.

11 b) After you select the connection type, the window below will appear, and then confirm modem settings. All settings here are default, it might not correct settings for your connection, double check your ISP for the settings and go to “Accessing Communication Settings on Windows” to modify the se...

Page 13 - Accessing Communication Settings on Windows; From your PC desktop, click; Start; The “; Communication Settings; ” Window will be displayed. Make the necessary

12 4.3 Accessing Communication Settings on Windows Step 1: From your PC desktop, click Start Æ Program Æ Conexant DSL Modem Æ Configure . Step 2: The “ Communication Settings ” Window will be displayed. Make the necessary changes to the VPI, VCI, Encapsulation type and/or Modulation type and click “...

Page 14 - Reboot; window will appear. Remove all disks from their drives, select; computer now”

13 Step 3: The system must be rebooted to have the new settings take effect, therefore the Reboot window will appear. Remove all disks from their drives, select “Yes, reboot the computer now” , and click Close to reboot. PS. For the detail information, please refer to the manual in the provided CD.

Page 15 - FCC Caution

14 F F e e d d e e r r a a l l C C o o m m m m u u n n i i c c a a t t i i o o n n C C o o m m m m i i s s s s i i o o n n I I n n t t e e r r f f e e r r e e n n c c e e S S t t a a t t e e m m e e n n t t FCC Part 68 This equipment complies with Part 68 of the FCC Rules. On the bottom of this equi...