EdgeStar AP410HS - Manuals

Parts Front view 1. Control panel 2. Adjustable louvers 3. Carry handles 4. Caster wheels Rear view 1. Air inlet 2. Exhaust port 3. Power cord hooks 4. Caster wheels 5. Drain plug (a plastic drain cap covers a rubber stopper) 5

Accessories Owner’s manual and warranty card Drain hose Exhaust hose Rectangular vent connector Round adapter Drain tray Carbon filter Cap for round adapter Plastic window kit and screws Remote and batteries 6

Installation Installing the exhaust hose In order to be used effectively, the exhaust hose must be mounted to the back of the unit. 1. Make sure the rectangular vent connector is fitted to one end of the exhaust hose and fit the round adapter to the other end. 2. Insert the rectangular vent connecto...

Control panel LED indicators 1. “ST” = Set Temperature When this light is lit (when the TEMP. UP or TEMP. DOWN buttons are pressed), the LED display shows the temperature that the unit is set to cool or heat to. 2. “RT” = Room Temperature When this light is lit the LED display shows the current ambi...

If this light is flashing, the internal condensate tank is full and the unit has shut itself off. Empty the tank to restart the unit. See the Drainage section for more information on performing this operation. Buttons 1. “TEMP. UP” = Adjusts Temperature Up This button raises the thermostat temperatu...

Remove the batteries from the remote control if you are not going to use it for several weeks or more. Caution: Do not abuse the remote control. Do not expose the remote control to direct sunlight or leave it next to a radiator or another source of heat. Do not mix different types of batteries in th...

Regulating airflow direction To adjust airflow, the louvers on this portable air conditioner can be adjusted up and down and from right to left. To adjust the horizontal louvers, gently move them up or down as desired. To adjust the vertical louvers, move the handle at the bottom of the louvers. 15

Manual drainage When the portable air conditioner is in cooling or dry mode, it will dehumidify the air. The water dehumidified from the air will be collected in an internal reservoir. This water will be used to help cool the compressor and it will be evaporated and exhausted out the exhaust hose. T...

5. Empty the drain tray. 6. Repeat steps 1-5 as necessary. Direct drainage 1. Remove the drain cap and rubber plug from the drain. 2. Connect the drain hose to the drain. The drain hose can be extended if needed. The portable air conditioner will now drain through the drain hose. Please note that th...

Installing the charcoal filter 1. Grasp the filter frame (it slides in and out of the top back of the portable air conditioner) and pull up until it slides completely out of the unit. 2. Lay the filter frame on a flat surface, and remove the plastic grid from the filter frame. 3. Lay the charcoal fi...

Troubleshooting If the portable air conditioner is not working properly, it is usually due to a minor problem that the user can handle. Before calling customer service, refer to the following chart for troubleshooting: Problem Possible Causes Solutions The plug is not properly installed into a power...

"E5" shows in the LED display. The overheating protection sensor has detected a fault. Contact customer service. "E7" shows in the LED display. The water reservoir is full. Drain the water reservoir. Limited warranty: This EdgeStar product is warranted to be free from defective workm...