Eagle ID 128 - Manuals - manualsarea.com

Page 2 - All screens in this manual are simulated.

2 Eagle ElectronicsPO Box 669Catoosa, OK 74015 TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS INTRODUCTION .............................................................................................. 3SPECIFICATIONS ..........................................

Page 3 - Transmitter

3 SPECIFICATIONSDimensions ...................... 5.9" W x 5.35" H x 3.4" DInput Voltage .................... 10 - 15 vDCCurrent Drain ................... 150 ma (lights off) ........................... 250 ma (lights on) Transmitter Frequency .......... 192 kHzOutput Power ..... 275 wat...

Page 6 - GOOD LOCATION

6 4. If possible, route the transducer cable away from other wiring on the boat. Electrical noise from engine wiring, bilge pumps, and areators canbe displayed on the sonar’s screen. Use caution when routing the trans-ducer cable around these wires. 2. Slide the transducer between the two ratchets. ...

Page 9 - Fish Arches

9 6. Route the transducer cable to the sonar unit. Make cer tain to leave some slack in the cable at the transducer as shown at the bottom ofthe previous page. If possible, route the transducer cable away fromother wiring on the boat. Electrical noise from the engine’s wiring, bilgepumps, VHF radio ...

Page 10 - POWER CONNECTIONS -PERMANENT MOUNT UNITS ONLY

10 POWER CONNECTIONS -PERMANENT MOUNT UNITS ONLY IMPORTANT! INSTALL THE TRANSDUCER BEFORE WIRING THE POWER CABLE! The Fish ID 128 works from a 12 volt DC system only. For the best results,run the power cable directly to the boat’s battery. Keep the power cableaway from other boat wiring, especially ...

Page 15 - OPERATION

15 NOTE: Turning the unit off erases all user settings and it returns to thesystem defaults. For example, if you turn the lights on, then turn the unit off,the next time you turn the unit on, the lights will be off, since the defaultsetting for the lights is off. MENUSThis sonar unit uses menus to g...

Page 20 - ALARMS

20 ALARMS FISH ALARMThe Fish Alarm sounds a tone when a fishsymbol appears on the screen. To use thefish alarm, press a menu key until the “FISHALARM” menu appears on the screen. Nowpress the up arrow key to turn the alarm on.Repeat the above steps to turn the alarm off. SHALLOW ALARMThe shallow ala...

Page 31 - WARRANTY REPAIR WILL BE HONORED ONLY IN THE COUNTRY; How to Obtain Service; Accessory Ordering Information

31 How to Obtain Service (Canadian Customers Only) We back your investment in quality products with quick, expert service and genuine Eaglereplacement parts. If you need service or repairs, contact the Eagle Factory CustomerService Department at the toll-free number listed below. A technician may be...

Page 32 - or call; replacement parts. If you're in the United States and you

32 Eagle Electronics may find it necessary to change or end our shipping policies, regulations,and special offers at any time. We reserve the right to do so without notice. Accessory Ordering Information To order accessories such as power cables or transducers, please contact: 1) Your local marine d...