Ducky DMFE20O - Manuals

LOD 滑鼠工作高度 Report Rate 滑鼠 USB 回報率 底部另有 2 個三段式撥動開關 DPI 調整按鈕

調整直線修正 (開/關) 滾輪燈光指示依序為 滾輪指示 DPI 燈色 3 秒後，回到與當前燈效。 切換感應器解析度(DPI)數值 調整 USB 回報率 (125/500/1000Hz) 調整工作高度 (L/D/H) 底蓋內建三段式滑動開關 L = 低 / D = Default ( 預設值 ) / H = 高 底蓋內建三段式滑動開關上至下順序為 125 / 500 / 1000 Hz ， 出廠預設為中間值 500 Hz 預設為關閉 開啟 / 關閉的方式 : A. DPI 鍵按住 + 第 5 鍵 1 下放開後， 整隻滑鼠閃白燈 2 下，代表開啟或關閉完成。 再次操作則為關閉，整隻滑鼠閃紅燈２下。...

燈光操作說明 按住 DPI 鍵 + 第 4 鍵 1 下放開後， 燈效即開始作切換混色 波浪模式 呼吸模式 彩色循環模式 雨滴模式 互動模式 光暈模式 煙火模式 極光模式 單色燈模式 自定義模式 關閉燈光 DPI鍵 第4鍵 + =

自定義燈光模式操作說明 按住 DPI 鍵 ( 此時 DPI 不會跳段 ) + 按住中鍵 3 秒後， 整隻滑鼠閃白燈 3 下，即開始自定義燈光模式 右手模式為例 第 5 鍵 第 4 鍵 第 7 鍵 第 6 鍵 (下一色) (上一色) (確認鍵) (儲存結束鍵)

The 5th button The 4th button The 7th button (Fn key) The 6th button (Switch key) Function Mode + The 4th button = Press Fn key(The 7th button) The 5th button End Home Right button Left button Middle button Right-Hand mode

Rate=Report rate = Report rate is measured in Hz. If a mouse has a 125 Hz polling rate it reports its position to the computer 125 times every second—or every 8 milliseconds. A 500 Hz rate means that the mouse is reporting its position to the computer every 2 milliseconds. Bottom switches and button...

Exclusive/ Ascended cable SR structure Ascended angle of the cable 7.91° Which is consistent with the pulling power when we use the mouse. The working feeling will be as smooth as we use the mouse bungee. 7.91

Back switches function LOD L D H Rate(Hz) 125 500 1000 DPI

AS: Angle Snapping(Enable/Disable) Default : Right-Hand Mode (No function on the 6th& 7th button) DPI value : Use the DPI button at the botton to directly switch the preset value DPI indicator lights on scroller in sequence: Scroller LED will indicate the DPI value for 3 seconds, later it return...

Static color mode Right-Hand mode By default, it is set to red. To cycle though the 8 colours, hold the 4th button and press the 6th button. The colors will cycle through this order: Red->Orange->Yellow->Green->Blue->Purple->Pink->White The color will automatically save. the 4th...

LED customization operation Hold the DPI button + the middle button for 3 seconds, the mouse will flash white light 3 times then the LED customization mode will be started. Right-Hand mode the 5th button (previous color) the 4th button (next color) The 7th button (save & finish key) The 6th butt...

the 5th button (previous color) the 4th button (next color) The 7th button (save & finish key) The 6th button (confirm key) Description : 1. After entering the LED customization mode the 3 individual sections will light up the defaulting white color. The first section will flash once in every se...