Directed Electronics G38106 - Manuals

Page 2 - The performance of your new; PrecisionPower; Dealer for technical assistance. If you

INTRODUCTION Thank you for your purchase of this PowerClass ® Component Loudspeaker System from PrecisionPower ™ . Our engineers have combined state of the art materials such as foamed prolypropylene cones and vapor-deposit titanium dometweeters with cutting edge industrial design to achieve competi...

Page 4 - Step 1: Determine where the speaker will be mounted. Make sure

REAR DECK MOUNTING In rear deck installations, check the operation of the trunksuspension springs or tension bars. These tension bars can movewhen opening and closing the trunk and can exert a great deal offorce against anything that obstructs their movement, such as aspeaker basket or motor assembl...

Page 5 - Step 6: Using the plastic grille ring as a template, mark the; mounting holes with a pen.; Step 8: Pull the wire through the speaker opening and connect to

Step 6: Using the plastic grille ring as a template, mark the mounting holes with a pen. Step 7: Pre-drill mounting holes using a 1/8" drill bit. WARNING: Window mechanisms and electrical wires and otherexpensive car parts have a nasty habit of hiding where youleast expect. CHECK BEFORE YOU DRIL...

Page 6 - INSTALLING THE TWEETER; SURFACE MOUNTING

5 NOTE: To remove the trim ring from the tweeter housing: 1. Rotate the trim ring a few degrees in a clockwise direction until you feel a detent. 2. Remove the trim ring by lifting it straight up. INSTALLING THE TWEETER SURFACE MOUNTING Step 1: Determine the tweeter mounting location, then route the...

Page 7 - FLUSH MOUNTING INTO REMOVED PANELS; wires from the crossover to the tweeter location.

FLUSH MOUNTING INTO REMOVED PANELS Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Mark the center point of the tweeter location. Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-...

Page 8 - FLUSH MOUNTING INTO MOUNTED PANELS

FLUSH MOUNTING INTO MOUNTED PANELS Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Mark the center point of the tweeter location. Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-...

Page 9 - INSTALLING THE CROSSOVER

Step 8: Screw the bolts in until the tweeter housing is firmly mounted to the panel. (Make sure the arrow at the rear ofthe tweeter housing is pointing in the desired direction.) Step 9: Insert the tweeter into the housing and attach trim ring. INSTALLING THE CROSSOVER Step 1: Find a location for th...

Page 10 - SPECIFICATIONS; Model

PC PASSIVE CROSSOVER (COVER REMOVED) SPECIFICATIONS Model PC 525S PC 650S Nominal Impedance 4 ohms 4 ohms PowerContinuous/Peak 50/100 watts 60/120 watts Frequency Response 90 Hz–20kHz 90 Hz–20kHz Sensitivity(2.83v @ 1w/1m) 92 db 92 db WooferMounting Depth 2-7/8” 2-15/16” WooferMounting Diameter 4-3/...

Page 11 - Warranty; LIMITED TWO YEAR CONSUMER WARRANTY:; WARRANTY OF

Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product shouldit prove to be defective in workmanship or material under normal use, for a period of twoyears from the date of purchase from the dealer as indicated by the date ...