Directed Electronics 320.3X - Manuals

5 © 2009 Directed Electronics. All rights reserved. Control Center Control CenterButton Control Center LED The control center, typically located on the upper part of the front windshield sends and receives commands or messages to and from your system. It consists of: The In-vehicle system antenna, f...

6 © 2009 Directed Electronics. All rights reserved. Using your System Commands and Confirmations Commands, basic or advanced, are used to activate system features and are performed by pressing one of the command buttons. Ba-sic commands control the most often used security features while ad-vanced co...

7 © 2009 Directed Electronics. All rights reserved. Remote Control Command table Button Level Direct Access x 1 LEVEL 1 x 2 LEVEL 2 x 3 LEVEL 3 x 4 LEVEL 4 Arm/Lock (Panic) Silent Arm Sensor Bypass Sensor Silent Arm Full Silent Arm Disarm/Unlock Silent Disarm Remote Valet Car Finder Remote Start*/ A...

8 © 2009 Directed Electronics. All rights reserved. Basic Commands (Direct Access) No ghost LED’s on Arm Press and release The alarm arms, doors lock (if connected), and the siren chirps and parking lights flash once. The arm LED and beeps play to confirm. If valet mode* is on, the doors lock and the ...

10 © 2009 Directed Electronics. All rights reserved. Advanced Commands: (Level 1) Press and release the button 1 time. The LED illuminates indicat- ing Level 1 Note: The transmit LED on the 1-way remote will flash in groups of 1 to indicate level 1. Silent Arm Press and release The alarm arms, doors ...

11 © 2009 Directed Electronics. All rights reserved. Advanced Commands: (Level 2) Press and release the button 2 times. The and aux LED’s illumi- nate indicating Level 2 Note: The transmit LED on the 1-way remote will flash in groups of 2 to indicate level 2. Sensor Bypass Press and release Performin...

12 © 2009 Directed Electronics. All rights reserved. off accordingly. The disarm LED and valet beeps play (1 for on, 2 for off) to confirm. AUX 2 Press and release AUX Activates (or if on, deactivates) the aux 2 output. The aux LED and on tones or off tones play to confirm. Arm Status Press and hold t...

13 © 2009 Directed Electronics. All rights reserved. Advanced Commands: (Level 3) Press and release the button 3 times. The , aux and rs/aux LED’s illuminate indicating Level 3. Note: The transmit LED on the 1-way remote will flash in groups of 3 to indicate level 3. Sensor Silent Arm* Press and rele...

15 © 2009 Directed Electronics. All rights reserved. Remote Control Configuration Remote Programming The Responder LE and 1-way companion remote controls have opera-tions that can be configured to a user’s personal preferences. The fol-lowing instruction will direct you through the available programmi...

16 © 2009 Directed Electronics. All rights reserved. Prepare the remote control Select the desired car 1 (default) or car 2 operation before proceed-ing. Press 1. and hold the button of the remote control for 8 seconds until the transmit LED turns on, and then release it (If programmed to operate tw...

17 © 2009 Directed Electronics. All rights reserved. Feature Button Press LED on LED off LED Flash LED Double Flash Page Mode AUX Paging On Paging Off Power Save1 Power Save 2 1-way companion remote control The 1-way remote will flash the transmit LED to indicate the setting. Feature Button Press LED...

18 © 2009 Directed Electronics. All rights reserved. Auto unlocking After turning the ignition off, a message to the Responder LE will unlock the keypad buttons until the next command is performed. If auto unlocking is not desired this message can be turned off by an authorized Directed dealer. Page...

19 © 2009 Directed Electronics. All rights reserved. Remote Beep Options: On, Off, Triggers Only The Responder LE will emit a beep as confirmation of button presses and command responses. When set to off, beeps are not emitted for any operations except programming. For triggers only, beeps will only ...

20 © 2009 Directed Electronics. All rights reserved. Alarm Features Normal Arm Protection Control center LED: The control center LED flashes as a visual indicator that your vehicle’s security system is active. Starter Kill: The Failsafe starter kill relay prevents the engine from starting Note May re...

21 © 2009 Directed Electronics. All rights reserved. Full Silent Arm Protection Sensor Warn-away, Sensor Full Trigger and Point of Entry activations will only send messages to the Responder LE remote control, with park-ing light flash and siren outputs defeated. Sensor Warn-away When the system senso...

22 © 2009 Directed Electronics. All rights reserved. Trigger Zone Fault Report When armed by remote command the system runs a status check of the alarm trigger zones. Faulty zones (usually caused by dome light delay or open trunk) are bypassed and reported via the control center LED and remote, whil...

25 © 2009 Directed Electronics. All rights reserved. Valet Mode Valet mode can be entered and exited by performing the remote valet command or manually using the vehicle key and the control button. When entered, the alarm functions are defeated while the conve-nience features still operate normally....

26 © 2009 Directed Electronics. All rights reserved. Out of Range Each time a command is performed the Responder LE will expect a command confirmation from the system. If a command confirmation is not received the and transmit LED’s flash and a long fault tone plays as an alert. No Remote Output Occasi...

28 © 2009 Directed Electronics. All rights reserved. System Expansion Options Controlling Two Vehicles (Car Select) The Responder LE and 1way companion remote can control systems in two different vehicles saving the need for multiple remote controls. This feature also allows for customized system co...

30 © 2009 Directed Electronics. All rights reserved. Battery Information The Responder LE remote is powered by 2 batteries (PN CR-2016) and the 1-way companion remote by 1 battery (PN CR-2032), that can be purchased at most retailers. When the battery begins to weak-en, the operating range will be r...

32 © 2009 Directed Electronics. All rights reserved. Turn both the unit 2. front and circuit board over, remove battery from clip and replace while observing the correct po-larity. With the front and circuit board still turned over, turn back portion 3. of unit onto both parts, reposition all parts ...

33 © 2009 Directed Electronics. All rights reserved. Glossary of Terms Document Terminology Control Module The “brain” of your system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the system’s func-tions. Respond...

34 © 2009 Directed Electronics. All rights reserved. Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol-lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including ...

35 © 2009 Directed Electronics. All rights reserved. Additional Information Interference All radio devices are subject to interference which could affect proper performance. Upgrades Any upgrades to this product must be performed by an authorized Directed dealer. Do not attempt to perform any unauth...

36 © 2009 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereaf-ter the “unit”), excluding witho...