Dimplex DF2608 - Manuals

Model Number 3 Model Number Warning Label Important Instructions If you have any questions regarding our products please havethe product model number and serial numbers available uponcalling Dimplex customer service or technical support. Tolocate the model and serial number labels see below. Recordt...

4 Site Selection and Preparation This section provides instructions for selecting a location andpreparing the site to install the fireplace into your Dimplexmantel surround. 1. Select a suitable location that is not susceptible tomoisture and is away from drapes, furniture and hightraffic. 2. For ea...

5 Fireplace Installation Install the fireplace assembly into the mantel. (refer to mantelassembly instructions) NOTEA 15 AMP, 120 VOLT circuit is required. A dedicated circuit ispreferred but not essential in all cases. A dedicated circuitwill be required if after installation the circuit breaker tr...

6 Option #1 The power cord can be run from behind the trim and alongthe wall to an outlet near the fireplace. Option #2 A new outlet can be installed inside the framingconstruction.Plug the unit into a 15Amp/120Volt outlet. If the corddoes not reach, you may use anextension cord rated for a minimum ...

7 Resetting the Temperature Cutoff SwitchThis unit is equipped with a thermostat which controls thetemperature of the room by turning the heater on and off. A E B C D Operation Electric Fireplace Manual ControlThe manual controls for the fireplace are behind the accesspanel located at the bottom of ...

8 The heater is protected with a safety device to preventoverheating. Should the heater overheat, an automatic cut outwill turn the heater off and it will not come back on withoutbeing reset. It can be reset by switching the ON/OFFSWITCH to OFF and waiting 5 minutes before switching theunit back on....

9 Maintenance WARNINGDisconnect the power before attempting any maintenance orcleaning to reduce the risk of fire, electric shock or damageto persons. Light Bulb Replacement Allow at least 5 minutes for the light bulbs to cool beforetouching them to avoid accidental burning of the skin. Thelight bul...

10 To access the lower light bulb area: 1. Slide fireplace out of mantel 2. Lay unit on it’s back for safe removal of front glass. 3. Remove 4 Phillips screws from the right side of trim. 4. Slide glass to right side of fireplace to remove. 5. Pull the front edge of the plastic ember bed or plasticg...

11 NOTE Ensure the logset is installed tightly under the back ledge toprevent light leakage. Upper Light Bulb Requirements Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 15 watt rating. DO NOT EXCEED 25 WATTS PER BULBTo access the upper light bulb area: 1. Slide...

12 Two Year Limited Warranty Products to which this limited warranty applies This limited warranty applies to your newly purchasedDimplex electric fireplace. This limited warranty applies onlyto purchases made in any province of Canada except forYukon Territory, Nunavut, or Northwest Territories or ...