Dewalt DCS573BW606 - Manuals

English 4 Lower Guard Function Safety Instructions a ) Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be b...

English 5 BATTERIES AND CHARGERS The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below and then follow charging procedures outlined. When ordering replacement battery packs, be sure to include the catalog number and vol...

English 6 For example, Shipping Wh rating might indicate 3 x 40 Wh, meaning 3 batteries of 40 Watt hours each. The Use Wh rating might indicate 120 Wh (1 battery implied). Fuel Gauge Battery Packs (Fig. B) Some D e WALT battery packs include a fuel gauge which consists of three green LED lights that...

English 7 • Do not place any object on top of the charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom ...

English 8 hot/Cold Pack Delay When the charger detects a battery pack that is too hot or too cold, it automatically starts a Hot/Cold Pack Delay, suspending charging until the battery pack has reached an appropriate temperature. The charger then automatically switches to the pack charging mode. This...

English 9 OPERATION WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. Installing and Removing the Battery Pack (Fig. D) nOTE: For ...

English 10 Fig. F 8 16 Fig. G LOOSEN (counterclockwise) 7 14 11 TIGHTEN (clockwise) 6 To Replace the Blade (Fig. F, G) 1. To loosen the blade clamping screw  8  , depress the blade lock button  11  and turn the saw spindle with the blade wrench  14  until the blade lock engages and the blade stops r...

English 12 Bevel Angle Adjustment (Fig. A, J) The full range of the bevel adjustment is from 0° to 57°. The quadrant is graduated in increments of 1°. On the front of the saw is a bevel angle adjustment mechanism consisting of a calibrated quadrant and a bevel adjustment lever  10  . To set the saw ...

English 13 Cutting (Fig. M) Place the wider portion of the saw shoe on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. As an example, Figure M illustrates the RIGHT way to cut off the end of a board. Always clamp work. Don’t try to h...

English 14 Accessories WARNING: Since accessories, other than those offered by D e WALT , have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only D e WALT recommended accessories should be used with this product. Recommend...

D e WALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286 (NOV16) Part No. xxxxx DCS570 Copyright © 2016 D e WALT The following are trademarks for one or more D e WALT power tools: the yellow and black color scheme, the “D” shaped air intake grill, the array of pyramids on the handgrip, th...