Desa CGP10T - Manuals - manualsarea.com

Page 2 - CONTENTS; SECTION; SAFETY; Safety Information continued on page 3; WARNINGS; Carbon monoxide poisoning may lead to death!; Early signs of carbon monoxide poisoning

2 103575 CONTENTS SECTION PAGE SAFETY INFORMATION Safety Information continued on page 3 WARNINGS IMPORTANT: Read this owner’s manual carefully and completely be-fore trying to assemble, operate, or service this heater. Improper use ofthis heater can cause serious injury or death from burns, fire, e...

Page 3 - Continued

3 103575 SAFETY INFORMATION Continued WARNINGS Continued WARNING: Any change to this heater or its controls can be dangerous. 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases. 2. Do not place propane/LP s...

Page 4 - American National Standards Institute, Inc.

4 103575 PRODUCT IDENTIFICATION PRODUCT FEATURES Safety Device This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS).The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shutsoff the heater if there is not enough fresh air. Piezo Ignition System This h...

Page 5 - WARNING; Confined and Unconfined Spaces; PROVIDING ADEQUATE VENTILATION; Unusually Tight Construction; ous water vapor retarder with a rating of one perm (6x10

5 103575 AIR FOR COMBUSTION AND VENTILATION WARNING ICON G 001 WARNING This heater shall not be installed in a confined space unlessprovisions are provided for adequate combustion and ventilationair. Read the following instructions to insure proper fresh air forthis and other fuel-burning appliances...

Page 6 - Determining if You Have a Confined or Unconfined Space

6 103575 AIR FOR COMBUSTION AND VENTILATION Continued DETERMINING AIR FLOW FOR HEATER LOCATION Determining if You Have a Confined or Unconfined Space Use this worksheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install heater plus any adjoini...

Page 7 - Figure 2 - Ventilation Air from Inside Building; AIR FOR; VENTILATION AIR; Ventilation Air From Inside Building

7 103575 Figure 2 - Ventilation Air from Inside Building Or Remove Door into Adjoining Room, Option 3 Ventilation Grills Into Adjoining Room, Option 2 12" 12" Ventilation Grills into Adjoining Room, Option 1 Continued AIR FOR COMBUSTION AND VENTILATION Continued WARNING If the area in which ...

Page 8 - Figure 3 - Ventilation Air from Outdoors; Ventilation Air From Outdoors

8 103575 Figure 3 - Ventilation Air from Outdoors OutletAir VentilatedAttic OutletAir InletAir Inlet Air Ventilated Crawl Space To Crawl Space To Attic AIR FOR COMBUSTION AND VENTILATION Continued Ventilation Air From Outdoors Provide extra fresh air by using ventilation grills or ducts. You must pr...

Page 9 - NOTICE; CHECK GAS TYPE; • external regulator (supplied by; LOCATING HEATER; This heater is designed to be mounted on a wall.; Never install the heater; If you install the heater in a home garage; CAUTION

9 103575 INSTALLING TO WALL NOTICE A qualified service person must install heater. Follow all local codes. CHECK GAS TYPE Use only propane/LP gas. If your gas supply is not propane/LP, do not installheater. Call dealer where you bought heater for proper type heater. INSTALLATION ITEMS Before install...

Page 10 - JOINING WALL; INSTALLING HEATER TO WALL; Marking Screw Locations; Determine where you will locate heater.; For convenience and efficiency, install heater; THERMOSTAT SENSING BULB

10 103575 INSTALLING TO WALL Continued Figure 5 - Mounting Screw Locations Mounting Screw Locations 8 7/8" Minimum To Maintain 6" Clearance From Wall 7 3/4" 20 1/4" Minimum To Maintain 3" Clearance From Floor FLOOR JOINING WALL INSTALLING HEATER TO WALL Marking Screw Locations 1....

Page 11 - Installing Two Mounting Screws; package is provided with heater.; Attaching to wall stud method; INSTALLING TO; Figure 7 - Popping Open Anchor Wings For Thin Walls

11 103575 Installing Two Mounting Screws Note: Wall anchors and mounting screws are in hardware package. The hardware package is provided with heater. Attaching to wall stud method For attaching mounting screw to wall stud1. Drill hole at marked location using 9/64" drill bit.2. Insert mounting ...

Page 12 - Installing Bottom Mounting Screw; Figure 11 - Installing Bottom Mounting Screw; Placing Heater On Mounting Screws; are in small portion of slots.; Figure 9 - Location Of Keyhole Slots On Back Panel Of Heater; Removing Front Panel Of Heater; Figure 10 - Removing Front Panel Of Heater

12 103575 Installing Bottom Mounting Screw 1. Locate bottom mounting hole. This hole is near bottom on back panel of heater (see Figure 11). 2. Mark screw location on wall.3. Remove heater from wall.4. If installing bottom mounting screw into hollow or solid wall, install wall anchor. Follow steps 1...

Page 13 - Figure 12 - External Regulator With Vent Pointing Down

13 103575 CONNECTING TO GAS SUPPLY NOTICE A qualified service person must connect heater to gas supply.Follow all local codes. The installer must supply an external regulator. The external regulator will reduceincoming gas pressure. You must reduce incoming gas pressure between 11 and 14inches of wa...

Page 14 - Figure 13 - Gas Connection; PRESSURE TESTING GAS SUPPLY PIPING SYSTEM; Test Pressures In Excess Of 1/2 PSIG; Connecting to Gas Sup-

14 103575 IMPORTANT: Hold pressure regulator with wrench when connecting it to gas piping and/or fittings. Figure 13 - Gas Connection * An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptablealternative to test gauge connection. Purchase the optional A.G.A. design-cert...

Page 15 - water to gas joints. Bubbles forming show a leak.; Test Pressures Equal To or Less Than 1/2 PSIG; PRESSURE TESTING HEATER GAS CONNECTIONS; internal joints for leaks.; CHECKING; Figure 14 - Manual Shutoff Valve; Figure 15 - Checking Gas Joints

15 103575 3. Pressurize supply piping system by either using compressed air or opening propane/LP supply tank valve. 4. Check all joints of gas supply piping system. Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak. 5. Correct all leaks at once. Test Pressures Equal ...

Page 16 - Figure 16 - Control Knob In The OFF Position; LIGHTING INSTRUCTIONS; FOR YOUR SAFETY READ BEFORE LIGHTING

16 103575 OPERATING HEATER IGNITOR PILOT LO OFF HI Control Knob Figure 16 - Control Knob In The OFF Position Ignitor Button A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area ...

Page 18 - TO TURN OFF GAS TO APPLIANCE; OPERATING; Shutting Off Heater; to the OFF position.; to the PILOT position.; THERMOSTAT CONTROL OPERATION

18 103575 TO TURN OFF GAS TO APPLIANCE OPERATING HEATER Continued Shutting Off Heater 1. Turn control knob clockwise Clockwise to the OFF position. 2. Turn off all electric power to the appliance if service is to be performed. Shutting Off Burner Only (pilot stays lit) 1. Turn control knob clockwise...

Page 19 - Check pilot flame pattern and burner flame pattern often.; PILOT FLAME PATTERN; Figure 18 - Correct Pilot Flame Pattern; If pilot flame pattern is incorrect, as shown in Figure 19; Figure 19 - Incorrect Pilot Flame Pattern

19 103575 INSPECTING BURNER Check pilot flame pattern and burner flame pattern often. PILOT FLAME PATTERN Figure 18 shows a correct pilot flame pattern. Figure 19 shows an incorrect pilotflame pattern. The incorrect pilot flame is not touching the thermocouple. This willcause the thermocouple to coo...

Page 20 - BURNER FLAME PATTERN; INSPECTING; Figure 20 - Correct Burner Flame Pattern; INCORRECT FLAME PATTERN; Figure 21 - Incorrect Burner Flame Pattern; If burner flame pattern is incorrect, as shown in Figure 21

20 103575 BURNER FLAME PATTERN Figure 20 shows a correct burner flame pattern. Figure 21 shows an incorrectburner flame pattern. The incorrect burner flame pattern shows yellow tipping ofthe flame. It also shows the flame higher than 1/2 the glass panel height. NOTICE Do not mistake orange flames wi...

Page 21 - ODS/PILOT AND BURNER ORIFICE; Air Passageways; Turn off heater and let cool before cleaning.; SHOOTING; Note: All troubleshooting; REMEDY

21 103575 CLEANING AND MAINTENANCE ODS/PILOT AND BURNER ORIFICE • Use a vacuum cleaner, pressurized air, or small, soft bristled brush to clean. CABINET Air Passageways • Use a vacuum cleaner or pressurized air to clean. Exterior • Use a soft cloth dampened with a mild soap and water mixture. Wipe t...

Page 25 - SPECIFICATIONS; When gas pressure is too low; SERVICE

25 103575 You may have further questions about installation, operation, or troubleshooting.If so, contact DESA International’s Technical Service Department at 1-800-323-5190. TECHNICAL SERVICE SPECIFICATIONS CGP10T and CGP10TL Btu (Variable) 5,000/10,000 Type Gas Propane/LP Only Ignition Piezo Press...

Page 26 - ILLUSTRATED PARTS BREAKDOWN

26 103575 ILLUSTRATED PARTS BREAKDOWN 10 12 11 1 2 3 4 5 6 7 9 8 10 13 14 15 16 17 18 23 24 27 14 22 20 26 25 19 25 21 12-2 12-1 ODS/PILOT CGP10T CGP10TL

Page 27 - PARTS LIST

27 103575 This list contains replaceable parts used in your heater. When ordering parts, followthe instructions listed under Replacement Parts on page 28 of this manual. PARTS LIST CGP10T CGP10TL KEY PART NO. NUMBER DESCRIPTION QTY. 1 098304-01 Screw, #10 x 3/8" 2 2 099467-02 Front Panel Assembl...

Page 28 - for parts replaced under warranty.; Parts Under Warranty; When contacting your dealer or DESA International, have ready:; Parts Not Under Warranty; When calling DESA International, have ready:; REPLACEMENT

28 103575 Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. Parts Under Warranty Contact authorized dealer from whom you purchased this product. If they cannotsupply original replacement part(s), call DESA International’s Technical...

Page 30 - NOTES

30 103575 NOTES _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ ____________________...

Page 32 - KEEP THIS WARRANTY; WARRANTY INFORMATION; LIMITED WARRANTY

KEEP THIS WARRANTY WARRANTY INFORMATION Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standardwritten warranty. We make no other warranty, expressed or im...