Delta 22-540 - Manuals

6 UNPACKING AND CLEANING Carefully unpack the tool and all loose items from the shipping container(s). Peel protective film from the table surface.Remove and clean the protective coating from the cutterhead. Remove the protective coating from all unpaintedsurfaces. This coating may be removed with a...

7 ASSEMBLY INSTRUCTIONS Fig. 4 Fig. 5 Fig. 6 ASSEMBLING RAISING ANDLOWERING HANDLE 1. Assemble raising and lowering handle (A) Fig. 4, to shaft (B) and fasten in place with screw (C). NOTE: Make certain the flats of the handle and flat on shaft arealigned with each other. 2. Flip handle (A) upward a...

9 OPERATING CONTROLS AND ADJUSTMENTS Fig. 13 Fig. 14 Fig. 15 Fig. 16 STARTING ANDSTOPPING PLANER The “ON/OFF” switch (A) Fig. 13, is located on the frontof the planer motor. To turn the machine “ON”, move theswitch toggle (B) to the up position. To turn the switch“OFF”, move the switch toggle (B) to...

Fig. 17 Fig. 18 Fig. 19 Fig. 20 LEVELINGEXTENSION TABLES For optimum performance, the extension tables, one ofwhich is shown at (A) Fig. 17, must be level with theplaner table. To check the extension tables and adjust ifnecessary, proceed as follows: 1. Place a straight edge (B) Fig. 17, on the infe...

11 5. If an adjustment to one or both knives is necessary, slightly loosen the seven locking screws, six of which are shown at (C) Fig. 21, by turning the screws CLOCKWISE into the knife locking bar just enough to relieve stress in the cutterhead and not disturb the knife setting. 6. With setting ga...

Fig. 23 LIFTING STRAPS Your planer is provided with two lifting straps (A) Fig. 23,located on the top of the planer, for ease in transportingthe planer. OPERATIONS When using your machine, you may want to follow these few simple steps for achieving the best results possible. 1. Cross-cut to Length –...

13 MAINTENANCE Fig. 26 Fig. 27 Fig. 28 Fig. 30 Fig. 29 BRUSH INSPECTIONAND REPLACEMENT CAUTION: BEFORE INSPECTING THE BRUSHES, DIS-CONNECT THE TOOL FROM THE POWER SOURCE. Brush life varies. It depends on the load on the motor.Check the brushes after the first 50 hours of use for anew machine or afte...

Delta Building Trades and Home Shop Machinery Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns t...

The following are trademarks of PORTER-CABLE DELTA Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.):BAMMER ® , INNOVATION THAT WORKS ® , JETSTREAM ® , LASERLOC ® , OMNIJIG ® , POCKET CUTTER ® , PORTA-BAND ® , PORTA-PLANE ® , PORTER-CABLE ® , QUICKSAND ® , SANDTRAP ® , SAW BOS...