Dell Studio One P687X- Manuals

  Replacing the Battery   1. Follow the procedures in Before You Begin .   2. Insert the new battery into the socket with the side labeled "+" facing up and then snap the battery into place.   3. Reconnect the cables to the connectors HDD_POWER and SATA_1 (see System Board Components ).   4....

Back to Contents Page   Computer Cover Dell Studio One 19/1909 Service Manual    Removing the Computer Cover    Replacing the Computer Cover         Removing the Computer Cover   1. Follow the procedures in Before You Begin .     2. Place the computer face down on a flat surface.   3. Starting at th...

Back to Contents Page   Support Assembly Dell Studio One 19/1909 Service Manual    Removing the Support Assembly    Replacing the Support Assembly       Removing the Support Assembly   1. Follow the instructions in Before You Begin .   2. Remove the hard drive (see Removing the Hard Drive ).   3. Re...

  Replacing the Support Assembly   1. Follow the instructions in Before You Begin .   2. Reconnect the following cables to the LCD panel: l   LVDS cable from LVDS connector l   touch pad cable from the touch pad connector l   touch panel cable from the touch panel module   3. Replace the fourteen sc...

Back to Contents Page   Drives Dell Studio One 19/1909 Service Manual    Removing the Hard Drive    Replacing the Hard Drive    Removing the Optical Drive    Replacing the Optical Drive   Removing the Hard Drive   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Rem...

  10. Remove the four screws securing the optical drive to the optical drive carrier.   11. Slide the optical drive out of the optical drive carrier.   Replacing the Optical Drive   1. Follow the procedures in Before You Begin .   2. Prepare the optical drive for installation and check the documenta...

Back to Contents Page   Processor Fan and Heat Sink Dell Studio One 19/1909 Service Manual    Removing the Heat Sink    Replacing the Heat Sink    Removing the Processor Fan    Replacing the Processor Fan         Removing the Heat Sink     1. Follow the procedures in Before You Begin .   2. Remove t...

    1. Follow the procedures in Before You Begin .   2. Clean the thermal grease from the bottom of the heat sink and reapply it.   3. Align the screws on the processor heat sink with the screw holes on the chassis.     4. Use the marked sequence on the processor heat sink to tighten the four captiv...

6. Lift the processor fan away from the computer and place it in a secure location.   Replacing the Processor Fan   1. Follow the procedures in Before You Begin .   2. Connect the processor fan cable to the connector (CPU_FAN1) on the system board.   3. Replace the three screws securing the processo...

Back to Contents Page   Inverter Dell Studio One 19/1909 Service Manual    Removing the Inverter    Replacing the Inverter     Removing the Inverter   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. Remove the shield (see Removin...

  Replacing the Inverter   1. Follow the procedures in Before You Begin .   2. To replace the inverter, connect the two cables from the LCD panel to the inverter.   3. Connect the inverter cable to the system board connector (INVERTER).   4. Replace the two screws that secure the inverter to the cha...

Back to Contents Page   Microphone Dell Studio One 19/1909 Service Manual    Removing the Microphone    Replacing the Microphone     Removing the Microphone   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. Remove the shield (see...

Back to Contents Page   Processor Dell Studio One 19/1909 Service Manual    Removing the Processor    Replacing the Processor       Removing the Processor   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. Remove the shield (see R...

  Replacing the Processor   1. Follow the procedures in Before You Begin .   2. Lift the release lever to the release position so that the socket is ready for the new processor.     3. Unpack the new processor.   4. If the release lever on the socket is not fully extended, move it to that position. ...

Back to Contents Page   Power Supply Unit Dell Studio One 19/1909 Service Manual    Removing the Power Supply Unit    Replacing the Power Supply Unit           Removing the Power Supply Unit   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Co...

  Replacing the Power Supply Unit   1. Follow the procedures in Before You Begin .   2. Replace the four screws that secure the power supply unit to the chassis.   3. Connect the power supply unit cable to the connector (ATX_POWER1) on the system board.   4. Connect the power plug cable to the power...

Back to Contents Page   Shield Dell Studio One 19/1909 Service Manual    Removing the Shield    Replacing the Shield     Removing the Shield   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. To remove the shield loosen the eight ...

Back to Contents Page   Side I/O Panel Dell Studio One 19/1909 Service Manual    Removing the Side I/O Panel    Replacing the Side I/O Panel   Removing the Side I/O Panel   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. Remove t...

  Replacing the Side I/O Panel   1. Follow the procedures in Before You Begin .   2. To replace the side I/O panel, route the cables back into position and connect them to the connectors (F_AUDIO and SIDE_BOARD_1) on the system board.   3. Slide the side I/O panel towards the clamps until it is firm...

Back to Contents Page   Speakers Dell Studio One 19/1909 Service Manual    Removing the Right Speaker    Replacing the Right Speaker    Removing the Left Speaker    Replacing the Left Speaker     Removing the Right Speaker   1. Follow the procedures in Before You Begin .   2. Remove the computer cov...

Back to Contents Page   Stand Dell Studio One 19/1909 Service Manual    Removing the Stand    Replacing the Stand     Removing the Stand   1. Follow the procedures in Before You Begin .   2. Remove the computer cover (see Removing the Computer Cover ).   3. Remove the shield (see Removing the Shield...

Back to Contents Page   System Board Dell Studio One 19/1909 Service Manual    Removing the System Board    Replacing the System Board   The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the computer. The replacement kit for the system board includes ...

  11. Lift the system board out of the chassis.   Replacing the System Board   1. Follow the instructions in Before You Begin .   2. To replace the system board place the system board back in the chassis.   3. Replace the five M2.5 x 5-mm screws that secure the system board to the chassis.   4. Repl...

Back to Contents Page   System Fan and Heat Sink Assembly Dell Studio One 19/1909 Service Manual    Removing the System Fan and Heat Sink Assembly    Replacing the System Fan and Heat Sink Assembly         Removing the System Fan and Heat Sink Assembly   1. Follow the procedures in Before You Begin ...

  10. Lift the assembly away from the system board and place it in a secure location.   Replacing the System Fan and Heat Sink Assembly   1. Follow the procedures in Before You Begin .   2. To replace the system fan and heat sink assembly, connect the system fan cable to the connector (SYS_FAN1) on ...

Back to Contents Page   System Setup Dell Studio One 19/1909 Service Manual    Overview    Clearing Forgotten Passwords    Clearing CMOS Settings    Flashing the BIOS   Overview Use system setup to: l   Change the system configuration information after you add, change, or remove any hardware in your...

  Boot Sequence This feature allows you to change the boot sequence for devices.   Boot Options Processor L2 Cache Displays the processor L2 cache size. Memory Installed Indicates the amount of installed memory in MB. Memory Available Indicates the amount of memory available in MB. Memory Speed Indi...

l   Hard Drive — The computer attempts to boot from the primary hard drive. If no operating system is on the drive, the computer generates an error message. l   CD/DVD Drive — The computer attempts to boot from the CD/DVD drive. If no CD/DVD is in the drive, or if the CD/DVD has no operating system,...

  6. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.   7. Wait for approximately five seconds to clear the password setting.   8. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.   9. Replace the stand (see Replacing the Stand ).   10. Replace...

  7. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.   8. Wait for approximately five seconds to clear the CMOS setting.   9. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.   10. Replace the back I/O panel (see Replacing the Back I/O Panel )...

  8. Double-click the file icon on the desktop and follow the instructions on the screen.   Flashing the BIOS From a CD   1. Turn on the computer   2. Insert the BIOS upgrade CD, and restart the computer. Follow the instructions that appear on the screen. The computer continues to boot and updates t...

Back to Contents Page   Technical Overview Dell Studio One 19/1909 Service Manual    Inside View of Your Studio One    System Board Components     Inside View of Your Studio One   System Board Components WARNING: Before working inside your computer, read the safety information that shipped with your...

Back to Contents Page   Webcam Dell Studio One 19/1909 Service Manual    Removing the Webcam    Replacing the Webcam       Removing the Webcam   1. Follow the instructions in Before You Begin .   2. Remove the system board (see Removing the System Board ).   3. Remove the support assembly (see Remov...