2 Important Safety Instructions WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and install...
Page 3 - Product Dimensions
3 14.02 in. (356.2 mm) 78.75 in. (2000.1 mm) 80.37 in. (2041.4 mm) 4.99 in. (126.7 mm) 5.02 in. (127.4 mm) 38.77 in. (984.8 mm) 15.23 in. (386.8 mm) 6.6 in. (167.52 mm) 1.21 in. (30.65 mm) 41.60 in. (1056.5 mm) 55.52 in. (1410.1 mm) 1.67 in. (42.3 mm) 2.4 in. (60.9 mm) 28.07 in. (712.9 mm) Front Vie...
Page 4 - Tools Required for Installation; Included InstallationHardware
4 1/8 in. (wood) 1/2 in. (drywall) 8 mm (concrete) 6 mm (concrete – AF6 toggler) 7/16” Wrench #8 X 1/2” Screw (7) 1/4” Washer (3) #8 x 3/4” Screw (1) #8-10 Wall Anchor (10) Screen Bracket (5) #8 x 1” Screw (10) 1/4” x 1-1/2” Lag Screw (3) Screen (1) Wall Bracket (1) Cable Cover Clip (2) Cleaning Clo...
Page 5 - Figure 1; Installation
5 1. Determine desired height of image (measured from floor) (Figure 1). 2. Determine desired center of image area (Figure 1).3. Measure 4-1/16” up from desired height (top) of image and 4” to the right of center of screen and mark location (Figure 1). 4. Determine location of studs behind drywall.5...
Page 7 - Figure 4
7 IR Sensor Power Projector Signal Cable Projector Power Cord Figure 4 Figure 5 Installation (continued) 10. Install the (3) screen brackets using: Wood or steel studs: (3) supplied #8 x 1” screws. Concrete wall or no studs: (3) supplied #8-10 wall anchors and (3) supplied #8 x 1” screws. 11. Instal...
Page 8 - Figure 6
8 13. Mount screen onto wall bracket by hooking into the back groove of the screen frame (Figure 6). NOTE: The bumpers on the back side of the screen/whiteboard are used to maintain planarity when pressure is applied to the projection surface during usage. If the bumpers are obstructing installation...
Page 9 - Figure 9
9 Installation (continued) Figure 9 Figure 11 Figure 10 Attach marker tray to frame with (2) screws into the side channel. Safety Screw 17. Secure marker tray to right side of screen frame at desired height by using (2) of the supplied #8 x 1/2” screws into the side channel of the screen frame (Figu...
Page 12 - Installation Video
CW88R Rev. A0024695 Rev00 • Go to http://downloads.chiefmfg.com/MANUALS- I/PTDRV-I.pdf for translated instructions. • Entre en http://downloads.chiefmfg.com/ MANUALS-I/PTDRV-I.pdf para obtener las instrucciones traducidas en su idioma. • Bedienungsanleitungen in Ihrer Sprache finden Sie auf http://d...