Dell S25V- Manuals

Installing the Hardware 7 Attach a Ground Cable to the System CAUTION: To prevent electrical shock, make sure the switch is grounded properly. If you do not ground your equipment correctly, excessive emissions can result. Use a qualified electrician to ensure that the power cables meet your local el...

Installing the Hardware 9 Installing XFPs CAUTION: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the chassis and its components. WARNING: Follow all warning labels when working with optical fibers. ...

10 Installing the Hardware Power Up Sequence Supply Power and Power Up the System There is no power switch. Supply power to the unit only after it is mounted. CAUTION: To prevent electrical shock, make sure the switch is grounded properly. If you do not ground your equipment correctly, excessive emi...

12 Installing the Hardware CAUTION: Electrostatic discharge (ESD) damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the system and its components. Power Supplies On the S25N, S25V, and S25P systems, either the AC or DC power supplie...

Installing the Hardware 13 Specifications Chassis Physical Design Environmental Parameters Parameter S25N/V Specifications S25P Specifications Height 1.73 inches (4.4 cm) 1.73 inches (4.4 cm) Width 17.32 inches (44.0 cm) (19" rack-mountable) 17.32 inches (44.0 cm) (19" rack-mountable) Depth ...

14 Installing the Hardware Power Requirements Installing Power Supplies The S25N, S25V, and S25P are shipped with power supplies installed and are not hot-swappable. ISO 7779 A-weighted sound pressure level S25N: 42.0 dBA at 73.4°F (23°C) S25V: 42.9 dBA at 73.4°F (23°C) 45.1 dBA at 73.4°F (23°C) Par...

Installing the Software 15 2 Installing the Software Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. You must move linearly through the command modes, with the exception of the end command which takes you directly to EXEC Privilege mode; the exit command moves you up one comma...

18 Installing the Software Default Configuration A version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the chassis, however the system is not configured when you power up for the first time (except for the default hostname, which is Force10 ). You must configure the system using t...

20 Installing the Software Configure a Username and Password In FTOS, you can assign a specific username to limit user access to the system. Configure the Enable Password The EXEC Privilege mode is accessed by the enable command. Configure a password as a basic security measure. When using a console...

Installing the Software 21 Create a VLAN The Default VLAN is part of the system startup configuration, and is by default, VLAN 1. You may make another VLAN the Default VLAN. The Default VLAN cannot be deleted, disabled, or configured (you cannot assign it an IP address), and only untagged interfaces...

22 Installing the Software Assign an IP address to a VLAN NOTE: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default vlan-id vlan-id command. Connecting the Chassis to the Network Once you have completed th...