Dell I1200 - Manuals

    Screw Identification   When you are removing and replacing components, print this section as a tool to lay out and keep track of the screws. The placemat provides the number of screws and their sizes.     1   front 2   left 3   back 4   right   Optical Drive:   (1 each)       Hard Drive Door:   ...

Back to Contents Page   Flashing the BIOS Dell™ Inspiron™ i1200 and i2200 Service Manual    Flashing the BIOS From a Floppy Disk or a CD    Flashing the BIOS From the Hard Drive   If a BIOS-update program floppy disk or CD is provided with the new system board , flash the BIOS from a floppy disk or ...

Back to Contents Page   Microprocessor Module Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the Microprocessor Module    Installing the Microprocessor Module   Removing the Microprocessor Module         1.   Follow the instructions in " Before Working Inside Your Computer ." 2. ...

Installing the Microprocessor Module     1.   Align the pin-1 corner of the microprocessor module so that it points to the triangle on the system board, and insert the microprocessor module into the ZIF socket.   When the microprocessor module is correctly seated, all four corners are aligned at the...

Back to Contents Page   Display Dell™ Latitude™ 110L Service Manual    Display Assembly    Display Bezel    Display Panel   Display Assembly     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the keyboard . 3.   Disconnect the display ground wire from th...

      Display Bezel     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the display assembly . 3.   Use a plastic scribe to pry the six screw covers/display bumpers out of the screw holes on the front of the bezel. 4.   Remove the six M2.5 x 5-mm screws f...

    1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the display assembly . 3.   Remove the display bezel . 4.   Remove the four M2 x 3-mm screws from each side of the display panel. 5.   Lift the display panel out of the top cover. 6.   Press in both side...

Back to Contents Page   Hard Drive Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the Hard Drive    Installing the Hard Drive   Removing the Hard Drive             To replace the hard drive in the hard drive bay: 1.   Follow the procedures in " Before You Begin ." 2.   Turn the c...

Back to Contents Page   Keyboard Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the Keyboard    Installing the Keyboard   Removing the Keyboard     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Facing the back of the computer, use a small plastic s...

  6.   Lift the top of the keyboard out of the computer base, and pull the keyboard out at an angle toward the display to access the connector. 7.   Grasp the interface connector lever near the edge of the keyboard connector, and rotate the lever toward you to raise the interface connector lever. 8....

Back to Contents Page   Palm Rest Dell™ Inspiron™ i1200 and i2200 Service Manual     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the hard drive . 3.   Remove the optical drive. 4.   Remove the keyboard . 5.   Remove the display assembly . 6.   Remove ...

Back to Contents Page   Pinout Assignments for I/O Connectors Dell™ Inspiron™ i1200 and i2200 Service Manual    USB Connector    Video Connector   USB Connector       Video Connector       Back to Contents Page   Pin Signal 1   USB5V+ 2   USBP – 3   USBP+ 4   GND Pin Signal Pin Signal 1   CRT_R 9   ...

Back to Contents Page   Speakers Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the Speakers    Installing the Speakers   Removing the Speakers       The speakers are located on the left and right corners of the front of the base plastics. Take note of the speaker cable routing so that y...

  Installing the Speakers 1.   Slide the speakers down into the base plastics.       2.   Route the speaker cables under or between their routing clips. 3.   Replace the four M2.5 x 5-mm screws. 4.   Connect the speaker connector to the system board. Back to Contents Page   NOTICE: Ensure that the s...

Back to Contents Page   System Board Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the System Board    Installing the System Board   Removing the System Board       The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the compu...

    Installing the System Board 1.   Insert the video connector on the replacement system board through the back of the base plastics. 2.   Replace the two hex nuts that secure the video connector to the base plastics. 3.   Replace the two M2.5 x 5-mm screws that secure the system board to the base ...

Back to Contents Page   System Components Dell™ Inspiron™ i1200 and i2200 Service Manual         Back to Contents Page   CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty. NOTIC...

Back to Contents Page   Microprocessor Thermal-Cooling Assembly Dell™ Inspiron™ i1200 and i2200 Service Manual    Removing the Cooling Fan    Installing the Cooling Fan    Removing the Microprocessor Thermal-Cooling Assembly    Installing the Microprocessor Thermal-Cooling Assembly   Removing the Co...

  6.   Disconnect the two M2 x 3-mm screws and the fan power cable from the system board.   .   7.   Hold the fan by the plastic housing at an angle to lift it out of the system board.   Installing the Cooling Fan 1.   Align the cooling fan with the microprocessor thermal-cooling assembly on the sys...

.   3.   Align the EMI shield retention tabs with the retention-tab slots on the computer base and rotate the front until it lies flat. 4.   Replace the four M2.5 x 5-mm screws that secure it to the system board.         Removing the Microprocessor Thermal-Cooling Assembly     1   M2 x 3-mm screws (...

  7.   Pull up the microprocessor thermal-cooling assembly by the pull-tab to lift the assembly out of the system board.   Installing the Microprocessor Thermal-Cooling Assembly   1.   If you are installing a replacement microprocessor thermal-cooling assembly , remove the mylar that covers the ther...

Back to Contents Page   Memory, Optical Drive, Modem, and Mini PCI Card Dell™ Inspiron™ i1200 and i2200 Service Manual    Memory    Optical Drive    Modem    Mini PCI Card   Memory   Removing the Memory Module       1.   Follow the instructions in " Before Working Inside Your Computer ." 2. ...

  Installing the Memory Modules   1.   Align the notch in the module edge connector with the tab in the connector slot. 2.   Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstal...

2.   Remove the M2.5 x 8-mm screw from the indention labeled with a lock symbol ( ). 3.   Insert a screwdriver into the indention and push the notch on the metal tab to release the drive from the bay.     4.   Pull the drive out of the bay.   Installing the Optical Drive 1.   Slide the new drive int...

    Installing the Modem 1.   Connect the modem cable to the modem.   2.   Align the modem with the screw holes, and press the modem onto the connector on the system board. 3.   Install the M2 x 3-mm screw to secure the modem to the system board. 4.   Replace and tighten the captive screw on the opp...

  7.  Use your fingertips to carefully spread apart the securing taps on each end of the Mini PCI card connector until the card pops up.  8.   Lift the Mini PCI card out of its connector.       Installing the Mini PCI Card     1   antenna cable 2   metal securing tabs (2) 3   Mini PCI card connector...