Dell HK-595 - Manuals

Usage less for all controls. No changes will be made to the mode setting if you turn beyond 360 degrees. Vol -To increase or decrease the speaker volume, press the Mode button until the LED below Vol is lit. Then turn the F/X control knob clockwise to increase the volume or counterclockwise to decre...

Usage jack, the speaker system is muted and the center and surround levels will be disallowed. Thus, when toggling through speaker modes, the system will skip the center and surround modes. Treble, bass and volume modes will remain active. Diagnostics In order to facilitate optimal system setup, dia...

Setup Back to Contents Page Setup: Harman/Kardon HK-595 Speaker System Unpacking the speakers • Connecting the speakers to your multichannel sound card • Connecting the speakers to your stereo sound card • Placement of speakers Unpacking the speakers Carefully open the box containing the HK-595 spea...

Setup multichannel connection file:///D|/hk595/setup.htm (2 of 5)11/16/2004 3:47:30 AM

Setup stereo connection file:///D|/hk595/setup.htm (3 of 5)11/16/2004 3:47:30 AM

Setup Placement of speakers All stereo information is heard from the satellite and control speakers. The satellites are magnetically shielded and can be placed close to a computer monitor without distorting the image. For optimal stereo imaging, the satellites should be separated by a distance equal...

Troubleshooting Back to Contents Page Troubleshooting: Harman/Kardon HK-595 Speaker System Troubleshooting • Getting Help Troubleshooting SYMPTOM POSSIBLE PROBLEM SOLUTION NOTE No sound from Speakers No power to unit. Make sure wall power outlet or power strip has power. Make sure all switches for o...

Troubleshooting screwdriver to rotate the fuseholder a quarter turn in the direction of the arrow. See the Specifications section for a description of the fuse. Is the control/right satellite of your HK-595 speaker system plugged in correctly? Ensure that the control speaker DIN connector is pushed ...

Troubleshooting Too much bass or treble. Treb and/or Bass level is set too high. Adjust Treb and/or Bass settings or restore defaults by holding down the Mode button for three seconds. Subwoofer emits a loud hum or buzzing noise. Input cables not properly plugged in. Check input cable connection. Sp...

Specifications Back to Contents Page Specifications: Harman/Kardon HK-595 Speaker System Dimensions • Power Manufacturer Harman International Model number HK-595 Drivers (satellite) Two mid-range and one tweeter Drivers (subwoofer One 6 inch woofer Power (satellite) 10 watts per satellite at 10% THD...

Specifications Subwoofer 13 inches Input Impedance >5K Signal-to-Noise ratio 80 dB Frequency Response 30Hz-20KHz Input Sensitivity 400mV RMS for rated power output Fuse type See back of subwoofer NOTE: Before replacing fuse, remove AC power plug from the wall outlet. To replace fuse, twist fuse c...

Regulatory Back to Contents Page Regulatory FCC Statement and Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a re...