Dell 1400- Manuals

Hard disk drive indicator patterns Figure 3. Hard disk drive indicators 1. hard disk drive activity indicator (green) 2. hard disk drive status indicator (green and amber) 3. hard disk drive Hard disk drive- status indicator pattern (RAID Only) Condition Blinks green two times per second Identify ha...

Hard disk drive- status indicator pattern (RAID Only) Condition Blinks green for three seconds, amber for three seconds, and turns off in six seconds. Rebuild aborted Back-panel features and indicators Figure 4. Back-panel features and indicators Item Indicator, Button, or Connector Description 1 Po...

NOTE: At least one EMM must be installed in the enclosure. If only one EMM is installed in the enclosure, it must be installed in the primary EMM bay and a blank must be installed in the secondary EMM bay. See Installing an EMM blank . Figure 5. Enclosure Management Module Item Indicator, Button, or...

Power indicator codes Figure 6. Power indicator codes Item LED Icon Color State 1 DC power Green • ON — Normal operation. Power supply is connected to DC power and the power switch is on. The power supply module is supplying DC power to the array. • OFF — Indicates any one of the following: – The po...

2 Installing enclosure components Recommended tools You may need the following items to perform the procedures in this section: • Key to the system keylock• #2 Phillips screwdriver• Wrist grounding strap Front bezel (optional) Removing the front bezel 1. Using the system key, unlock the front bezel ...

Installing the front bezel 1. Hook the right end of the bezel onto the chassis. 2. Fit the free end of the bezel onto the system. 3. Secure the bezel with the keylock. Hard disk drives Safety: Models AMT, E03J, and E04J Models AMT, E03J, and E04J are intended for installation only in restricted acce...

Figure 8. Removing and installing a 3.5-inch hard disk drive blank 1. hard disk drive blank 2. release tab Installing a hard disk drive blank 1. If installed, remove the front bezel. See Removing the front bezel . 2. Insert the hard disk drive blank into the hard disk drive bay until the blank is fu...

Figure 9. Removing and installing a hard disk drive 1. release button 2. hard disk drive 3. hard disk drive carrier handle Installing a hard disk drive CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized i...

Figure 10. Removing and installing a hard drive into a 3.5-inch hard disk drive carrier 1. screws (4) 2. hard disk drive 3. hard disk drive carrier Installing a hard disk drive into a hard disk drive carrier 1. Insert the hard disk drive into the hard disk drive carrier with the connector end of the...

NOTE: Stacking the EMM will damage the sensitive EMI contacts Figure 12. Removing and installing an EMM 1. release lever 2. EMM 3. release tab Installing an EMM CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as aut...

AC power supply unit or cooling fan module Your enclosure supports two hot-swappable power supply unit or cooling fan modules. While the enclosure can operate temporarily with one module, both the modules must be present for cooling the enclosure. CAUTION: A single power supply unit or cooling fan m...

Installing an AC power supply unit or cooling fan module 1. Slide the power supply unit or cooling fan module into the chassis until the release tab clicks into place. 2. Connect the power cable to the power supply unit or cooling fan module and plug the cable into a power outlet. 3. Secure the powe...

DC power supply module back panel features Figure 16. DC power supply module back panel features Item Feature Description 1 Power supply release lever Unlocks the power supply module for removal from the storage array. 2 Connector on the power supply module Connects the power supply module to the DC...

Wiring the power cables WARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician must perform all connections to DC power and to safety grounds. Do not attempt connecting to DC power or installing grounds yourself. All electrical wiring must comply with applicable local or ...

Figure 19. Connecting the dc power cables 1. attached (trapped) finger screws 2. connector on the power supply cable 3. connector on the power supply module Removing a DC power supply WARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician must perform all connections to D...

Figure 20. Removing and installing a dc power supply module 1. release latch 2. power supply module 3. power supply module handle Installing a DC Power Supply Module WARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician must perform all connections to DC power and to saf...

Technical specifications NOTE: The following specifications are only those required by law to ship with your system. For a complete and current listing of the specifications for your system, go to dell.com/support . Power AC Power Supply (per power supply) Watt 600 W Heat dissipation NOTE: Heat diss...

Figure 21. Removing and installing the control panel 1. control panel 2. chassis 3. release tab Installing the control panel 1. Align the control panel with the slot on the enclosure. 2. Slide the control panel into the enclosure until the release tab clicks into place. 3. Install the hard disk driv...

Figure 23. Removing and installing the backplane 1. screws (5) 2. captive screws (2) 3. backplane Installing the backplane 1. Align the holes on the backplane with the holes on the enclosure. 2. Tighten the captive screw to secure the backplane to the chassis. 3. Replace the screws that secure the b...

3 Troubleshooting your enclosure Safety first—for you and your enclosure CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service...

• If the AC power LED is not lit, check the power cord and power source into which the power supply is plugged. – Connect another device to the power source to verify if it is working.– Connect the cable to a different power source.– Replace the power cable. If the problem is not resolved, see Getti...

6. Ensure that all the cables are attached correctly according to the enclosure mode you selected. For more information about enclosure modes, see Dell Storage MD1400 and MD 1420 Enclosure Hardware Deployment guide . 7. If you reseated the cables, reboot the host server. If the problem persists, see...

4 Getting help Contacting Dell NOTE: Dell provides several online and telephone-based support and service options. If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill, or Dell product catalog. Availability varies by country ...

Back to Contents Page   Camera Module Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing and Replacing the Camera Module   Removing and Replacing the Camera Module       1. Follow the instructions in Before You Begin .   2. Remove the display bezel (see Removing the Display Bezel ). ...

Back to Contents Page   Coin-Cell Battery Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Coin-Cell Battery    Replacing the Coin-Cell Battery         Removing the Coin-Cell Battery   1. Follow the procedures in Before You Begin .   2. Turn the computer over.   3. Loosen the c...

Back to Contents Page   Microprocessor Module Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Microprocessor Module    Replacing the Microprocessor Module   Removing the Microprocessor Module         1. Follow the instructions in Before You Begin .   2. Loosen the three captiv...

    5. Lift the microprocessor module straight up and out of the ZIF-socket.   Replacing the Microprocessor Module       1. Follow the instructions in Before You Begin .     2. Follow the instructions in Removing the Microprocessor Module .     3. Align the pin-1 corner of the new microprocessor mod...

Back to Contents Page   Microprocessor Thermal-Cooling Assembly Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Microprocessor Thermal-Cooling Assembly    Replacing the Microprocessor Thermal-Cooling Assembly   Removing the Microprocessor Thermal-Cooling Assembly       1. Foll...

Back to Contents Page   Display Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Display Assembly    Replacing the Display Assembly    Removing the Display Bezel    Replacing the Display Bezel    Removing the Display Panel    Replacing the Display Panel   Removing the Display A...

  12. Slide the media buttons board left to release it from the grips and lift the media buttons board.   13. Rotate the LCD assembly upward for easy removal.   14. Lift the display assembly straight up and out of the computer.   Replacing the Display Assembly       1. Follow the instructions in Bef...

5. Carefully route the Mini-Card antenna cables through the cable guide on the base of the computer.   6. Connect the Mini-Card antenna cable connectors.   7. Replace the media buttons board by sliding it in place.   8. Tighten the screw to secure the media buttons board.   9. Connect the display ca...

  5. Lift the cable securing tab and gently pull to disconnect the camera module cable from the connector.   6. Gently lift the bottom of the display panel up, then slide the display panel forward to remove it from the display cover.   7. Remove the six M2 x 3-mm screws (three on each side) securing...

Back to Contents Page   Fan Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Fan    Replacing the Fan   Removing the Fan       1. Follow the instructions in Before You Begin .   2. Remove the system board (see Removing the System Board ).   3. Remove the three M2.5 x 5-mm screw...

Back to Contents Page   Intel ® Turbo Memory Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the FCM    Replacing the FCM The Intel Turbo Memory also called Flash Cache Module (FCM), is an internal flash drive that helps improve the performance of your computer.   Removing the FCM...

Back to Contents Page   Hard Drive Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Hard Drive    Replacing the Hard Drive           Removing the Hard Drive   1. Follow the procedures in Before You Begin .   2. Turn the computer over.   3. Remove the system battery: a.   Slide ...

  6. Remove the two screws securing the hard drive to the hard drive assembly.   7. Slide out the hard drive from the hard drive assembly.     Replacing the Hard Drive   1. Remove the new drive from its packaging. Save the original packaging for storing or shipping the hard drive.     2. Slide the h...

Back to Contents Page   Keyboard Cover Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Keyboard Cover    Replacing the Keyboard Cover         Removing the Keyboard Cover   1. Follow the procedures in Before You Begin .   2. Open the display as far as it will open.     3. Inser...

Back to Contents Page   Keyboard Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Keyboard    Replacing the Keyboard         Removing the Keyboard   1. Follow the procedures in Before You Begin .   2. Remove the keyboard cover (see Removing the Keyboard Cover ).   3. Remove the...

Back to Contents Page   Memory Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Memory Module    Replacing the Memory Module You can increase your computer memory by installing memory modules on the system board. Install only memory modules that are intended for your computer. ...

  Replacing the Memory Module     1. Align the notch in the module edge connector with the tab in the connector slot.   2. Slide the module firmly into the slot at a 30-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall ...

Back to Contents Page   Communication Cards Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing a WLAN Card    Replacing a WLAN Card    Removing a Mobile Broadband or WWAN Card    Replacing a WWAN Card If you ordered a wireless Mini-Card with your computer, the card is already install...

  Replacing a WLAN Card       1. Insert the WLAN card connector into the system board connector labeled "WLAN" at a 45-degree angle by aligning the notch on the WLAN card to the slot on the system board connector.   2. Press down the other end of the WLAN card and tighten the screw securing ...

  6. Lift the card from the computer at a 45-degree angle.   Replacing a WWAN Card       1. Insert the W W A N card connector into the system board connector labeled "WWAN" at a 45-degree angle by aligning the notch on the WWAN card to the slot on the system board connector.   2. Press down ...

Back to Contents Page   Modem Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing and Replacing the Modem   Removing and Replacing the Modem     1. Follow the procedures in Before You Begin .   2. Turn the computer over, loosen the three captive screws on the modem cover, and then rem...

Back to Contents Page   Optical Drive Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Optical Drive    Replacing the Optical Drive     Removing the Optical Drive   1. Follow the procedures in Before You Begin .   2. Turn the computer over.   3. Remove the locking screw from th...

Back to Contents Page   Palm Rest Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Palm Rest    Replacing the Palm Rest   Removing the Palm Rest       1. Follow the instructions in Before You Begin .   2. Remove the optical drive (see Removing the Optical Drive ).   3. Remove t...

  8. Disconnect the touch pad cable. Use a plastic scribe to release the locking clips on both sides of the system board connector, and then gently pull to disconnect the touch pad connector from the system board connector.   9. Disconnect the LED board cable.   10. Moving from left to right, carefu...

Back to Contents Page   Pin Assignments for I/O Connectors Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    USB Connector    Video Connector    S-Video TV-Out Connector    IEEE 1394 Connector   USB Connector   Video Connector   S-Video TV-Out Connector   Pin   Signal 1 USB5V+ 2 USBP – 3 USB...

Back to Contents Page   Speakers Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the Speakers    Replacing the Speakers   Removing the Speakers       1. Follow the instructions in Before You Begin .   2. Remove the system board (see Removing the System Board ).   3. Disconnect the...

Back to Contents Page   System Board Dell™ Inspiron™ 1420/Dell Vostro™ 1400  Service Manual    Removing the System Board    Replacing the System Board   Removing the System Board     The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the ...

  18. Take out the system board and keep it aside.   19. Disconnect the modem cable from the system board.   20. With the rear of the computer facing you, gently lift the system board assembly from the left side, then slide the system board assembly to the left and lift up on the right side to raise...