Dell 1150 - Manuals

Back to Contents Page   Microprocessor Module Dell™ Inspiron™ 1150 Service Manual   Removing the Microprocessor Module         1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the keyboard . 3.   Remove the EMI shield . 4.   Remove the microprocessor therm...

Back to Contents Page   Display Dell™ Inspiron™ 1150 Service Manual    Display Assembly    Display Bezel    Display Panel    Display Latch Assembly   Display Assembly     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the hard drive . 3.   Remove the CD ...

11.   Lift the display assembly up and out of the computer base.   Display       Display Bezel     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the keyboard . 3.   Remove the display assembly . 4.   Use a plastic scribe to pry the two screw covers and ...

  6.   Starting at the bottom of the display panel, use your fingers to separate the bezel from the top cover and lift the inside edge of the bezel away from the top cover.   Display Panel   Removing the Display Panel     1.   Follow the instructions in " Before Working Inside Your Computer ....

1.   Connect the top flex-cable connector to the display panel connector. 2.   Connect the bottom flex-cable connector to the inverter connector. 3.   Lay the display panel in the top cover. 4.   Route the display-feed flex cable so that it rests in the notch located in the bottom edge of the top co...

Back to Contents Page   EMI Shield Dell™ Inspiron™ 1150 Service Manual    EMI Shield   EMI Shield     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the keyboard . 3.   Remove the one M2.5 x 8-mm screw (labeled "M2.5x8") that secures the EMI shie...

Back to Contents Page   Hard Drive Dell™ Inspiron™ 1150 Service Manual   Removing the Hard Drive           1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Turn the computer over, and remove the two M2.5 x 5-mm hard drive screws.       3.   Slide the hard drive o...

Back to Contents Page   Keyboard Dell™ Inspiron™ 1150 Service Manual   Removing the Keyboard     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Use a small flat-blade screwdriver or plastic scribe to lift the notched right edge of the hinge cover, and pry the c...

  5.   Lift the top of the keyboard out of the computer base, and pull the keyboard out at an angle (towards the display). 6.   Grasp the keyboard flex cable near the connector, and pull up on the flex cable to disconnect it from the interface connector on the system board. 7.   Remove the keyboard ...

Back to Contents Page   Palm Rest Dell™ Inspiron™ 1150 Service Manual    Palm Rest   Palm Rest     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the hard drive . 3.   Remove the CD or DVD drive . 4.   Remove the keyboard . 5.   Remove the EMI shield . 6...

Back to Contents Page   Pinout Assignments for I/O Connectors Dell™ Inspiron™ 1150 Service Manual    USB Connector    Video Connector   USB Connector       Video Connector       Back to Contents Page   Pin Signal 1   USB5V+ 2   USBP – 3   USBP+ 4   GND Pin Signal Pin Signal 1   CRT_R 9   5V+ 2   CRT...

Back to Contents Page   Speakers Dell™ Inspiron™ 1150 Service Manual   Removing the Speakers       The speakers are located on the left and right corners of the front of the base plastics. Take note of the speaker cable routing so that you can replace the cables properly under or between their routi...

  Installing the Speakers 1.   Slide the speakers down into the base plastics.       2.   Route the speaker cables under or between their routing clips. 3.   Connect the speaker connector to the system board. Back to Contents Page   NOTICE: Ensure that the speaker cables are under or between their r...

Back to Contents Page   System Board Dell™ Inspiron™ 1150 Service Manual   Removing the System Board       The system board's BIOS chip contains the Service Tag sequence, which is also visible on a barcode label on the bottom of the computer. The replacement kit for the system board includes a CD th...

20.   Lift the front of the system board out and away from the base plastics.   Installing the System Board 1.   Insert the video connector on the replacement system board through the back of the base plastics. 2.   Replace the two hex nuts that secure the video connector to the base plastics. 3.   ...

Back to Contents Page   System Components Dell™ Inspiron™ 1150 Service Manual         Back to Contents Page   CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty. NOTICE: Unless o...

Back to Contents Page   Microprocessor Thermal-Cooling Assembly Dell™ Inspiron™ 1150 Service Manual   Removing the Microprocessor Thermal-Cooling Assembly     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Remove the keyboard . 3.   Remove the EMI shield . 4.  ...

Back to Contents Page   Memory, CD or DVD Drive, Modem, and Mini PCI Card Dell™ Inspiron™ 1150 Service Manual    Memory    CD or DVD Drive    Modem    Mini PCI Card   Memory   Removing the Memory Modules       1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Turn...

    Installing the Memory Modules   1.   Align the notch in the module edge connector with the tab in the connector slot. 2.   Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinst...

  4.   Press the lever next to the memory module connectors in the direction of the arrow on the lever (towards the drive) to release the drive.     5.   Pull the drive out of the bay.   Installing the CD or DVD Drive 1.   Slide the new drive into the bay until the drive is fully seated. 2.   Replac...

1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Turn the computer over, loosen the captive screw (labeled "C") in the modem/Mini PCI card cover, and lift the cover away from the computer.     3.   Remove the two M2 x 3-mm screws securing the modem to the...

4.   Replace the cover and tighten the captive screw.   Mini PCI Card   Removing the Mini PCI Card     1.   Follow the instructions in " Before Working Inside Your Computer ." 2.   Turn the computer over, loosen the captive screw (labeled "C") in the modem/Mini PCI card cover, and li...

4.  Use your fingertips to carefully spread apart the securing taps on each end of the Mini PCI card connector until the card pops up.  5.   Lift the Mini PCI card out of its connector.   Installing the Mini PCI Card     1.   Align the Mini PCI card with the connector at a 45-degree angle, and press...