DCS DS224 - Manuals

WATER CONNECTION Recommended HOT (Maximum 140°F/60°C). Supplied hose to suit 3 / 8 ” male compression fitting. WATER SOFTENER MODELS Refer to your DishDrawer® User Guide for how to set up your water softener. WATER PRESSURE DRAIN CONNECTION Drain Hose Joiner to suit Ø 3 / 4 ” ± 5 / 64 ” and Ø 5 / 8 ...

SINGLE MODELS OPTION 1 DishDrawer® and Standpipe Ø1 1 / 2 ” (38mm) with Air Gap. OPTION 2 DishDrawer® with Waste Disposal. MAX height t o t op of AIR BREAK (c ount e rt op or wall-mount ed) 37 3 / 8 ” (950mm) v v MMMM v v MMMM 6 PLUMBING OPTIONS R NOTE: Prefinished Model is shown. There is no variat...

PLEASE NOTE: Your model of DishDrawer ® may differ from the model shown in the installation diagrams. Installation is similar for all models for either Single or Double models. Information referring to Single models only is highlighted in blue. Installation diagrams have been simplified to enable cl...

SINGLE MODELS ONLY Check the position of the chassis is still where marked on the cavity, before securing the product. There are four 5 / 8 ” (16mm) round holes, two on the left and two on the right hand side in the sound insulation. These provide access to the mounting tabs. To secure the product t...

R INSTALLATION INSTRUCTIONS STEP 5: ELECTRICAL CONNECTION To refit the tub, make sure both of the latches at the rear of each drawer runner are facing forward. Ensure hoses are hooping upward. Place the tub on the half open drawer runners and close the drawer. Important! Before refitting the tub, be...

Attach the Drain Hose Support to the cabinetry (with the screw supplied) to prevent siphoning and to keep the drain hose(s) from kinking. If required, the Drain Hose(s) may be trimmed to a suitable length. 29 1 / 2 ” - 34 3 / 4 ” (750mm - 882.5mm) 29 1 / 2 ” - 34 3 / 4 ” (750mm - 882.5mm) DishDrawer...

On the chosen groove cut down the vertical ribs at the centre and the ends using a knife. Cut along full length with a knife. Turn Toe Kick over, bend and then cut from front. Sand or scrape bottom edge to remove rough patches. Important! Before cutting ensure the Toe Kick is positioned on a wooden ...

R INSTALLATION INSTRUCTIONS Be sure product is level, securely fastened to the cabinetry and opens and closes freely. The DishDrawer® must be free to close with no resistance from the cabinetry. Be sure the inlet hose to valve connection is tightened a further half turn after seal contact. Be sure a...