Cuisinart SS-300- Manuals

5 Element 1 Water Any hot beverage is made up primarily of water. Often overlooked, the quality of the water is as important as the quality of the coffee, tea or cocoa. A good rule of thumb is that if your water doesn’t taste good from the tap, it won’t taste any better in your beverage. That’s why ...

features and Benefits 8 9 12 11 4 6 1a. Charcoal filter Holder 1b. Charcoal Water filter 2. reservoir Lid 3a. 10-ounce Water reservoir with cup markings at 6, 8, and 10 ounces 3b. Water Level Guide 4. Brewer Handle 5. Brewing Head 6. Brewing Chamber holds My K-Cup ® or the K-Cup ® Holder 7. Housing ...

8 Buttons and indicators Power Button (does not illuminate) Press to turn the Brewer on and off. add Water indicator Led Indicator will illuminate blue – Fill the water reservoir with cold water until it reaches just under the rim of the desired level – 6, 8, or 10 ounces on the Water Level Guide. K...

9 Setting Up Your Brewer initial Cleaning and first Brew Perform an initial cleaning before making your first beverage. follow these instructions but do not insert a K-Cup ® . 1. Plug the power cord into an independent, grounded outlet. Press the Power button to turn the unit on. 2. Press the Hot Wa...

10 4. Place the charcoal water filter in the holder and snap the holder cover closed. Be careful – improper placement can tear the filter skin (see figure). 5. Flush the filter and holder by running fresh water through the hole in bottom of compartment for 10 seconds. 6. Allow the filter to drain co...

11 9. Wait until all the water has drained into the brewer before lowering the brewer handle completely. 10. The Brew button LED will remain on, indicating the water is heating. note: If Brew button was not pressed before you added water to the water reservoir (Brew and Hot Water LEDs are still flas...

13 6b. Drop the assembled My K-Cup ® into the brewing chamber. There is no need to snap it into place. CaUtion: there are two sharp needles in the brewing chamber that puncture the K-Cup ® , one above and one below. to avoid risk of injury, do not put your fingers in the K-Cup ® brewing chamber. 7. ...

14 3. Cleaning the Exit Needle – The exit needle is located on the inside bottom of the K-Cup ® holder assembly. Should a clog arise because of coffee grounds, it can be cleaned using a paper clip or similar tool. Remove K-Cup ® holder and insert the paper clip to loosen the clog and push it out. Ca...

16 troUBLeSHootinG PROBLEM : SOLUTION: Brewer does not have power . Plug brewer into an independent outlet . Make sure the brewer is securely plugged in . Plug into a different outlet . Reset your home’s circuit breaker . Confirm the power has been turned on and the brew and hot water indicators are...