Page 2 - TABLE OF CONTENTS
i 620904402 TABLE OF CONTENTS Page MAINTENANCE 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DAILY (OR AS REQUIRED) 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . WEEKLY (OR AS REQU...
Page 3 - MAINTENANCE; DAILY; installed on the unit at all times.; CLEANING INSTRUCTIONS; DISPENSER; CLEANING EXTERIOR SURFACES
1 620904402 MAINTENANCE The following dispenser maintenance should be performed at the intervals indicated: DAILY (or as required) Remove foreign material from vending area drip tray to prevent drain blockage. WEEKLY (or as required) Clean vending area. Check for proper water drainage from the vendi...
Page 4 - BEVERAGE SYSTEM; COLD PLATE
2 620904402 C. Wash cup rest with soap solution and rinse in clean water. Install the cup rest into the drip tray. D. Clean all exterior surfaces with soap solution and rinse in clean water. 2. CLEANING INTERIOR SURFACES CAUTION: When pouring liquid into the hopper, do not exceed the rate of 1/2 gal...
Page 5 - DISPENSING VALVES
3 620904402 E. Using a cloth, wash down the surfaces of the cold plate and plastic cover with soap solution. F. Install and properly position the cover on the cold plate. G. Install the splash panel in the reverse order it was removed. H. Rinse cold plate surface by pouring potable water through hop...
Page 6 - Do not use a wire brush
4 620904402 c. Submerge all disconnects (gas and liquid) in the soap solution and then clean them using a nylon bristle brush. ( Do not use a wire brush ). Rinse with clean water. d. Using a plastic pail, prepare approximately five (5) gallons of sanitizing solution. e. Rinse the B-I-B disconnects i...
Page 7 - TROUBLESHOOTING; in locating the defect.
5 620904402 WARNING: If repairs are to be made to a product system, remove quick disconnects from the applicable product tank, then relieve the system pressure before proceeding. If repairs are to be made to the CO 2 system, stop dispensing, shut off the CO 2 supply, then relieve the system pressure...
Page 8 - ing of beverage system.
6 620904402 Trouble Probable Cause BEVERAGES NOT SWEET ENOUGH. A. Empty syrup tank.B. Faucet brix requires adjusting. BEVERAGES NOT COLD (UNITS WITH BUILT-IN COLD PLATE). A. Unit standing with no ice in hopper -- no ice in cold plate cabinet. Contact your local syrup or beverage equipment distributo...
Page 9 - PARTS LIST / EXPLODED VIEW
Page 11 - CABINET SECTION PARTS LIST
9 620904402 CABINET SECTION PARTS LIST Index No. Part No. Name 1 21491 Gate Slide 2 22081R Gate Restrictor 3 Not Used 4 **29303R Plate, Motor Mounting 5 15346 Agitator Assy 6 620021201 Cover, Rear Wrapper 7 629080213 Lower Panel Assy (For Drip Tray) 629080215 Lower Panel Assy (Z Model) 8 620020101 S...
Page 14 - FIGURE 2. ELECTRICAL BOX ASSEMBLY EXPLODED VIEW; ELECTRICAL BOX ASSEMBLY; Item
12 620904402 1 4 5 16 7 9 10 11 12 13 14 15 17 18 RIGHT SIDE L2L1 COM COM NONO NC NC FRONT 2 FIGURE 2. ELECTRICAL BOX ASSEMBLY EXPLODED VIEW ELECTRICAL BOX ASSEMBLY Item No. Part No. Name 1 620019001 Electrical Box 2 620019101 Reflector Panel 3 Not Used 4 30514 Clamp, Capacitor, 120 Volt 620308102 C...
Page 15 - SOLENOID ASSEMBLY; FIGURE 3. SOLENOID ASSEMBLY
13 620904402 SOLENOID ASSEMBLY 10 9 13 12 11 15 7 4 1 3 5 5 2 8 6 14 FIGURE 3. SOLENOID ASSEMBLY Item No. Part No. Name 1 28173 Arm, Gate Lift 2 50754 Bearing, Gate Arm 3 32957 Solenoid, 120 Volt 33397 Solenoid, 220-240 Volt 4 28172 Plate, Solenoid Mounting 5 50752 Isolator 6 70015 Hex Nut, No. 10-3...
Page 16 - DRAIN; TO COLD PLATE
14 620904402 DRAIN 1 1 1 1 2 3 3 4 TO COLD PLATE DRAIN ELBOW 1 TO COLD PLATE DRAIN ELBOW FIGURE 4. COLD PLATE DRAIN FOR Z STYLE UNITS Item No. Part No. Name 1 70750 Hose Clamp 2 53170 Drain Tube 3 51280 Elbow 4 53293 Coupler
Page 17 - WARRANTY; IMI Cornelius Offices
15 620904402 IMI CORNELIUS INC . O NE C ORNELIUS P LACE A NOKA, MN . 55303 --6234 T ELEPHONE (800) 238 --3600 F ACSIMILE (612) 422 --3232 WARRANTY IMI Cornelius Inc. and Remcor Products Company warrant that all equipment and parts are free from defects in material and workmanship under normal use an...