Comfort Glow CSPIPT - Manuals

Comfort Glow CSPIPT – Manual in PDF format online.

Manuals:

Manual

Manual Comfort Glow CSPIPT

Summary

Page 2 - Air for Combustion and Ventilation; section on page 5 of this manual.; State of Massachusetts:; wealth of Massachusetts.; TABLE OF CONTENTS

www.desatech.com 111487-01E 2 WARNING: Improper installation, adjustment, altera-tion, service or maintenance can cause injury or prop-erty damage. Refer to this manual for correct installation and operational procedures. For assistance or addi-tional information consult a qualiﬁed installer, servic...

Page 3 - SAFETY INFORMATION; Get fresh

www.desatech.com 111487-01E 3 SAFETY INFORMATION WARNING: This product con- tains and/or generates chemicals known to the state of California to cause cancer or birth defects or other reproductive harm. IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate o...

Page 4 - Continued; PRODUCT; Figure 1 - Typical Stove Cabinet Model; LOCAL CODES

www.desatech.com 111487-01E 4 4. This heater shall not be installed in a bedroom or bathroom. 5. Do not place stove directly on carpeting, vinyl tile or any combustible material other than wood. The stove must set on a metal or wood panel extending the full width and depth of the appliance. 6. Do no...

Page 5 - PRODUCT FEATURES; OPERATION; AIR FOR COMBUSTION; PROVIDING ADEQUATE VENTILATION; National Fuel; Unusually Tight Construction; Ventilation Air From Outdoors; Confined and Unconfined Space; The National Fuel Gas Code ANSI Z223.1/NFPA

www.desatech.com 111487-01E 5 PRODUCT FEATURES OPERATION This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic, dancing yellow ﬂames. This heater is designed for vent-free operation. State and local codes in som...

Page 6 - National Fuel Gas Code,; VENTILATION AIR; Ventilation Air From Inside Building; Section 5.3, Air for Combustion and Ventilation

www.desatech.com 111487-01E 6 DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION Determining if You Have a Conﬁned or Unconﬁned Space Use this work sheet to determine if you have a conﬁned or unconﬁned space. Space: Includes the room in which you will install heater plus any adjoining rooms with door- l...

Page 7 - Figure 2 - Ventilation Air from Inside; UNPACKING; Figure 4 - Unpacking Stove from Wooden

www.desatech.com 111487-01E 7 Ventilation Air From Outdoors Provide extra fresh air by using ventilation grills or ducts. You must provide two permanent openings: one within 12" of the ceiling and one within 12" of the ﬂoor. Connect these items directly to the outdoors or spaces open to the ...

Page 8 - INSTALLATION; Air; CHECK GAS TYPE

www.desatech.com 111487-01E 8 INSTALLATION NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your primary heating system. Do not install this heater as your pri- mary heat source. If you have a central heating system, you may run system’s circulating blower whi...

Page 9 - Figure 5 - Minimum Clearance to Walls; Front View; CONNECTING TO GAS SUPPLY; Installation Items Needed; Accessories

www.desatech.com 111487-01E 9 INSTALLATION Continued Figure 5 - Minimum Clearance to Walls and Ceiling (Stove May Vary Depending on Model) Front View Top View Side View 12" Minimum 12" Minimum 48" Minimum Ceiling Side Wall Side Wall Back Wall Side Wall Side Wall 12 " Minimum 12 "...

Page 10 - Figure 6 - Gas Regulator Location and; Back View; Figure 8 - Gas Connection

www.desatech.com 111487-01E 10 For propane/LP units, the installer must supply an external regulator. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incoming gas pres- sure, heater regulator d...

Page 11 - CHECKING GAS CONNECTIONS; Connecting to Gas; Figure 9 - Equipment Shutoff Valve

www.desatech.com 111487-01E 11 CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connections, internal and external to unit, for leaks after installing or servicing. Correct all leaks at once. WARNING: Never use an open ﬂame to check for a leak. Apply a noncorrosive leak detec- tion ﬂuid to ...

Page 12 - Gas Meter; INSTALLING ROD AND SCREEN; Rod; INSTALLING LOG SET; Unpacking

www.desatech.com 111487-01E 12 INSTALLATION Continued Figure 11 - Checking Gas Joints on Natural Gas Unit Gas Meter Equipment Shutoff Valve Control Valve Location INSTALLING ROD AND SCREEN 1. Insert rod through small rings located at top of screen (see Figure 12). 2. From back of stove, insert rod i...

Page 13 - OPERATING HEATER; FOR YOUR SAFETY

www.desatech.com 111487-01E 13 4. Wait ﬁve (5) minutes to clear out any gas. Then smell for gas, including near the ﬂoor. If you smell gas, STOP! Follow “B” in the safety information, column 1. If you donʼt smell gas, go to the next step. 5. Turn control knob counterclockwise to the PILOT position. ...

Page 14 - The correct pilot flame on natural gas units; Shutting Off Heater; INSPECTING BURNERS; CLEANING AND

www.desatech.com 111487-01E 14 OPERATING HEATER Continued Note: The correct pilot ﬂame on natural gas units will have a slight curve, but ﬂame should be blue and have no yellow or orange color. Figure 18 - Correct Pilot Flame Pattern (Propane/LP Shown) Thermocouple Pilot Burner Pilot Burner Thermoco...

Page 15 - Figure 20 - Injector Holder On Outlet; LOGS; ing Log Set

www.desatech.com 111487-01E 15 BURNER INJECTOR HOLDER AND PILOT AIR INLET HOLE The primary air inlet holes allow the proper amount of air to mix with the gas. This provides a clean burning ﬂame. Keep these holes clear of dust, dirt, lint and pet hair. Clean these air inlet holes prior to each heatin...

Page 16 - TROUBLESHOOTING; WARNING: Turn off heater and let cool before servicing. Only a; POSSIBLE CAUSE; Cleaning; OBSERVED PROBLEM

www.desatech.com 111487-01E 16 TROUBLESHOOTING WARNING: Turn off heater and let cool before servicing. Only a qualiﬁed service person should service and repair heater. CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS/pilot unit. Note: All troubleshooting it...

Page 18 - TANT; See Warning

www.desatech.com 111487-01E 18 TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas s...

Page 19 - When Gas Pressure Is Too Low; TECHNICAL SERVICE; PARTS UNDER WARRANTY; ACCESSORIES

www.desatech.com 111487-01E 19 SPECIFICATIONS CSBPT, CSPBPT, CSPIPT (Includes 111485-01 Burner Chassis) Btu (Variable) 16,000/30,000 Type Gas Propane/LP Only Ignition Piezo Pressure Manifold 8" W.C. Inlet Gas Pressure (in. of water) Maximum 14" Minimum* 11" Shipping Weight 265 lbs. * For...

Page 20 - ILLUSTRATED PARTS BREAKDOWN

www.desatech.com 111487-01E 20 14 16 3 4 15 5 11 6 12 7 10 15 8 9 1 17 2 18 18 18 13 ILLUSTRATED PARTS BREAKDOWN MODELS 111485-01 AND 111485-02

Page 21 - PARTS LIST; Replacement Parts

www.desatech.com 111487-01E 21 PARTS LIST This list contains replaceable parts used in your stove. For replacement parts see Replacement Parts on page 19 of this manual. KEY PART NUMBER NO. 111485-01 111485-02 DESCRIPTION QTY 1 104026-01 104026-01 Stove Log 1 2 098249-01 098249-01 Nut, M5 2 3 ** ** ...

Page 23 - PARTS CENTRALS; by providing original replacement parts and accessories; Tool & Equipment Company; All States; FBD; Parts Department

www.desatech.com 111487-01E 23 PARTS LIST This list contains replaceable parts used in your stove. For replacement parts see Replacement Parts on page 19 of this manual. PART NUMBER KEY CSB Series CSPB Series CSPI Series NO. (Black) (Porcelain Black) (Porcelain Ivory) DESCRIPTION QTY. 1 111698-07 11...

Page 24 - NOT A UPC; WARRANTY INFORMATION; KEEP THIS WARRANTY; Model; LIMITED WARRANTY

2701 Industrial DriveP.O. Box 90004Bowling Green, KY 42102-9004www.desatech.com 111487-01Rev. E06/05 NOT A UPC WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory.We reserve the right to amend these speci...