Page 2 - DISCLAIMER
PNR Series Installation Instructions 2 DISCLAIMER Milestone AV Technologies and its affiliated corporations andsubsidiaries (collectively "Milestone"), intend to make thismanual accurate and complete. However, Milestone makes noclaim that the information contained herein covers all details,c...
Page 3 - DIMENSIONS; Mount ing P atter n; PSBU INTERFACE BRACKET
Installation Instructions PNR Series 3 DIMENSIONS Mount ing P atter n 25 1.00 1.00 25 46 19.6 9 500 16.00 406 7.00 178 1.81 19.0 0 483 538 21.1 9 38 4 .18 1.50 .40 10 NOTE: PSBU INTERFACE BRACKET NOT SHOWN. THE PSBU INTERFACE BRACKET WILL ADD 1” IN DEPTHAND MAY AFFECT THE LOCATION OF THE DISPLAY ON ...
Page 5 - LEGEND
Installation Instructions PNR Series 5 LEGEND Tighten Fastener Apretar elemento de fijación Befestigungsteil festziehen Apertar fixador Serrare il fissaggio Bevestiging vastdraaien Serrez les fixations Loosen Fastener Aflojar elemento de fijación Befestigungsteil lösen Desapertar fixador Allentare i...
Page 6 - TOOLS REQUIRED FOR INSTALLATION
PNR Series Installation Instructions 6 TOOLS REQUIRED FOR INSTALLATION PARTS 7/32" (5.5mm) #2 9/16" A (1) [PNR assembly] B (2) [Cover] C (2) [End cap] D (2)[End cap] E (1)[Adjustment wrench] G (4) J (12) 5-1/2" Cable tie F (1)[Adjustment insert] H (4) 5/16 x 3-1/2" K (1) [PSBU bracke...
Page 7 - Installing Mount to Wall; Figure 1; Adjusting PNR Height; Figure 3
Installation Instructions PNR Series 7 Installing Mount to Wall WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SERIOUS PERSONALINJURY OR DAMAGE TO EQUIPMENT! It is the installer’sresponsibility to make sure the structure to which the mountis being installed is capable of supporting...
Page 8 - Installing Covers and End Caps; The covers and end caps have pressure fitting ends; Figure 4; Mounting the Display; IMPROPER INSTALLATION CAN LEAD TO; Figure 5
PNR Series Installation Instructions 8 Installing Covers and End Caps NOTE: The covers and end caps have pressure fitting ends that lock into place with each other. 1. Install cover (B) over the top bracket. (See Figure 4) 2. Install end caps (C and D) into the cover and top bracket.(See Figure 4) 3...
Page 9 - Cable Management; Figure 7; Cable tie
Installation Instructions PNR Series 9 Cable Management WARNING: IMPROPER INSTALLATION CAN LEAD TO SERIOUS PERSONAL INJURY OR DAMAGE TOEQUIPMENT! Make sure cables do not run through pinchpoints. 1. Thread cable ties (J) under cable clamps in mount arms.(See Figure 1) Figure 7 2. Route power/audio/vi...
Page 10 - Tension Adjustments; Vertical Tilt Tension Adjustment; Swivel Tension Adjustment; Roll Tension Adjustment
PNR Series Installation Instructions 10 Tension Adjustments Vertical Tilt Tension Adjustment 1. With display mounted, check for desired vertical tilt tension. 2. Adjust the Centris Select knob until desired vertical tilttension is obtained. (See Figure 9) 3. To lock the mount at the desired vertical...
Page 11 - Swing Arm Adjustments; Adjusting the Swing Arms Off-Center; Adjusting the Swing Arms Off Center
Installation Instructions PNR Series 11 Swing Arm Adjustments The dual swing arms are shipped installed in the center of thetop and bottom mounting brackets, which is the standardmounting configuration. The top and bottom mounting brackets have slotted holes,allowing for lateral adjustment of the du...
Page 12 - Swing Arm Tension Adjustment
PNR Series Installation Instructions 12 Swing Arm Tension Adjustment Swing arm tension is pre-set at the factory and is adjusted toaccommodate displays with weights near the top of the mount’scapacity. If smaller displays are used it may be difficult to reposition thedisplay after mounting. NOTE: Th...
Page 13 - Removing Display from Mount; The pin may have been used as a more permanent
Installation Instructions PNR Series 13 Removing Display from Mount 1. Remove bolt or padlock from faceplate (if used). NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and movefrom the lower holes to the upper holes. 2. Pull back on flag on upper mounti...
Page 16 - Europe; Franklinstraat 14, 6003 DK Weert, Netherlands; Asia Pacific; PNR Series; 016 Milestone AV Technologies
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344 P 800.582.6480 / 952.225.6000 F 877.894.6918 / 952.894.6918 Europe A Franklinstraat 14, 6003 DK Weert, Netherlands P +31 (0) 495 580 852 F +31 (0) 495 580 845 Asia Pacific A Office No. 918 on 9/F, Shatin Galleria18-24 Shan Mei Street...
