Page 2 - Start by Reading These Important Safety Instructions; Tools Required; door
1 The Protector System must be used for allinstallations where the closing force as measuredon the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operationof the Safety Reverse System or damage the garagedoor. After installation, ensure that the parts of the ...
Page 3 - Install stop bracket collar; The stop bracket collar should be installed on the; opposite; weight bar
2 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are onthe edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small dia...
Page 4 - Prepare Opener
3 Prepare Opener 5 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. Pull the release cord down and across to engage theball into the cup. The drive forks should now be able to be movedmanually. NOTE: To re-engage the opener, pull the relea...
Page 5 - Installation steps
4 Installation steps 6 FOR RIGHT HAND INSTALLATIONS (REFER SECTION 5, page 3) 1. Ensure that the opener position jumper (wire connector) is in place (refer section 5, page 3). 2. Place the opener in manual release mode (refer section 5, page 3). 3. Open the roller door fully. For safety, tie a rope ...
Page 6 - If it is necessary to cut the rope, heat seal the cut end; Release cable; Operating the Manual Release; To disengage the opener
Pinning the Door 9 Use bolts or pop-rivets (not supplied) to hold the curtain tothe door drum. 1. Pull the release cord down and across to engage the ball into the cup. Close the door manually. Pull the release cord across and release to re-engage the opener. 2. Try to manually open the door with th...
Page 7 - Program your Opener & Remote; Delete all Remote Control Codes; Setting the Limits; Check that the opener is engaged.; or; Manual Limit setting
6 Program your Opener & Remote Please note your remote controls and wall plate havealready been programmed into your operator. Activate the opener only when door is in full view, freeof obstruction and properly adjusted. No one shouldenter or leave garage while door is in motion. Do notallow chi...
Page 8 - The; The opener will automatically detect the protector
7 Setting the Force The force, as measured on the closing edge of the door,should not exceed 400N (40kgf). If the closing force ismeasured to more than 400N, the Protector System mustbe installed. See section 14. The force setting regulates the amount of power required toopen and close the door. 1. ...
Page 9 - Accessories
8 CARE OF YOUR OPENER When properly installed, your opener will provide high performance with a minimum of maintenance. The opener does notrequire additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener isinstalled. Weather conditions may cau...
Page 10 - Troubleshooting; The garage door opens and closes by itself:; a trained door systems technician.
9 Troubleshooting 1. The opener doesn't operate from either the green start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box.• Have you disabled all door locks? Review installation instruction warnings on page ...
Page 11 - OPERATION OF YOUR OPENER; The green start button; Opening the Door Manually:; The Opener Light Will Turn On:; MAINTENANCE OF YOUR OPENER
10 OPERATION OF YOUR OPENER Your opener can be activated by any of the followingdevices: • The green start button Hold the button down until door starts to move. • The Wall Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmi...
Page 12 - GARAGE DOOR OPENER WARRANTY; The warranty is strictly limited to the reparation or; D e c l a r a t i o n o f C o n f o r m i t y
GARAGE DOOR OPENER WARRANTY Chamberlain warrants to the first retail purchaser of this productthat the product shall be free from any defect in materials and/orworkmanship for a period of 24 full months (2 years) from thedate of purchase. Upon receipt of the product, the first retailpurchaser is und...