Casablanca W-85 - Manuals - manualsarea.com

Page 3 - Wall Control; SINGLE W-85 INSTALLATION

3 ® 3 INSTALLING THE W-85 WALL CONTROL W-85 CONTROL INSTALLATION 1. Use only the Casablanca W-85 wall control. 2. Do not use any additional control with your Inteli- Touch 3 fan (for example, dimmer, or fan speed control). 3. Do not use more than one fan per wall control. 4. No other light fixtures ...

Page 4 - DUAL W-85 INSTALLATION; DIP SWITCHES

4 ® 3 T o c o n t r o l t h e f a n a n d l i g h t s f r o m t w o l o c a t i o n s ( a t h r e e - w a y c i r c u i t ) , u s e t w o W-85 wall controls.1. Remove the screws and switch plate from the existing switch box and the screws holding the switch in the switch box. 2. Pull the existing sw...

Page 5 - OPERATION © POWER; OPERATION SPEED CONTROL; To vary the light brightness:; OPERATION LIGHTS; Light Operation

5 ® 3 OPERATION © POWER The button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. The button must be left on to retain a previously set fan speed or light level. OPERA...

Page 6 - CHANGING FREQUENCY SETTING; NOTE: All fans leave the factory set to; AUTOMATIC DEMONSTRATION PROGRAM; To enter the demonstration program:

6 ® 3 CHANGING FREQUENCY SETTING NOTE: All fans leave the factory set to “1111” You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately. DIP SWITCHES DIP SWITCHES SET TO ‘1111’ (Factory Setting) DIP SW...

Page 8 - PROGRAM; OFF for at least 5 seconds.

8 ® 3 OPERATION FAN-MINDER ™ PROGRAM The Fan-Minder feature will add to your comfort when used in the bedroom. The program reduces the speed of the fan each two-hour interval to compensate for cooling night air. To enter the Fan-Minder Program: 1. Turn the OFF for at least 5 seconds. 2. Turn the ON....

Page 9 - IN THE WALL BEZEL REPLACEMENT; W-85 Wall Control Bezel Replacement installation; To avoid possible electrical shock, make cer-

9 ® 3 IN THE WALL BEZEL REPLACEMENT WALL CONTROL AND HARDWARE (not to scale) W-85 Wall Control Bezel Replacement installation as follows - (In the Wall Replacement): Step 17a. Locate the two (2) screws holding the switch plate too the wall control and remove the cover plate as shown in Figure #1. St...

Page 10 - CONTINUED

10 ® 3 Figure #4 Figure #3 WHITE BEZEL ALMOND BEZEL RUBBER KEY PAD RUBBER KEY PAD LOCATING PINS (4) LOCATING PINS HOLES(4) W-85 Wall Control Bezel replacement: - CONTINUED Step 17c. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #3 and remove rubber key pad from ...

Page 12 - TROUBLESHOOTING TIPS

12 ® 3 Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance. TROUBLESHOOTING TIPS This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) t...