Carrier INDUCED COMBUSTION FURNACES 58RAP- Manuals

Page 3 - Fig. 3—Position of Pilot to Burner

Fig. 1—Downflow, Standing-Pilot, Fixed-Speed, Non-Condensing Furnace Component and Conversion Label Location A95457 BLOWERCOMPARTMENTDOOR GAS VALVE BURNER HOLD–DOWN BRACKET CONVERSIONRESPONSIBILITYLABEL CONVERSION RATING PLATE GAS CONTROL CONVERSION LABEL MANIFOLD BURNERS CLEARANCE LABEL FURNACE RAT...

Page 4 - Reconnect pilot supply tube and thermocouple to gas valve.; PROCEDURE 3—CONVERT GAS VALVE; Be sure main gas and electrical supplies to furnace are off.; PROCEDURE 4—CHECK INLET GAS PRESSURE; Be sure main gas and electric supplies to furnace are off.; CONVERSION KIT RATING PLATE - CARRIER CORP.; FUEL USED: PROPANE GAS; Fig. 5—Burner Orifice

CAUTION: DO NOT redrill burner orifices. Improper drilling (burrs, out-of-round holes, etc.) can cause excessive burner noise and misdirection of burner flames. This can result in flame impingement of the burners and heat exchangerscausing failure. Obtain new orifices if orifice size must be changed...

Page 5 - PROCEDURE 6—SET GAS INPUT RATE

4. Turn on furnace power supply. 5. Turn gas supply manual shutoff valve to ON position. 6. Turn furnace gas valve control knob to PILOT position and depress. 7. Check pilot tube connections for gas leaks. 8. Turn furnace gas valve control knob to OFF position and wait 5 minutes. 9. Light pilot in a...

Page 6 - Fig. 6—Honeywell Gas Valve

6. Light pilot in accordance with furnace lighting instructions. 7. Turn furnace gas valve control knob to ON position. 8. Set room thermostat to call for heat. 9. Check manifold pressure tap plug for gas leaks when main burners ignite. 10. Check for correct burner flame. (See Fig. 7.) 11. Observe u...

Page 7 - PROCEDURE 7—APPLY LABELS; making conversion are required.; PROCEDURE 1—INSTALL MAIN BURNER ORIFICES; Turn off furnace gas and electrical supplies.; Location

PROCEDURE 7—APPLY LABELS NOTE: See Fig. 1 or 2 for label location. 1. Fill in Conversion Responsibility Label (326755-205) and apply to inside furnace casing as shown. Date, name, and address of organization making conversion are required. 2. Apply Gas Control Conversion Label (326755-203) to gas va...

Page 8 - Remove and discard orifices from manifold.; PROCEDURE 2—CONVERT GAS VALVE; Be sure gas and electrical supplies to furnace are off.; PROCEDURE 3—CHECK INLET GAS PRESSURE; Attach manometer to inlet pressure tap on gas valve.; Fig. 10—Position of Ignitor to Burner

5. Remove burners from manifold. 6. Remove and discard orifices from manifold. 7. Refer to Fig. 4 to determine main burner orifice. Furnace gas input rate on rating plate is for installations at altitudes up to 2000 ft.In the U.S.A., the input rating for altitudes above 2000 ft must be reduced by 4 ...

Page 9 - Fig. 11—Redundant Automatic Gas Valve

3. Turn on furnace power supply. 4. Turn gas supply manual shutoff valve to ON position. 5. Turn furnace gas valve control switch or control knob to ON position. 6. Jumper R and W thermostat connections to call for heat. 7. When main burners have ignited, confirm that inlet gas pressure is between 1...

Page 10 - Check all threaded pipe connections for gas leaks.; follow this warning could result in personal injury or death.; Jumper R and W thermostat connections to call for heat.

4. Turn furnace gas valve control switch or control knob to ON position. 5. Check all threaded pipe connections for gas leaks. WARNING: NEVER use a match or other open flame to check for leaks. Use a soap-and-water solution. Failure to follow this warning could result in personal injury or death. 6....

Page 11 - PROCEDURE 5—SET GAS INPUT RATE; Set room thermostat to desired temperature.; PROCEDURE 6—APPLY LABELS; making this conversion are required.; GAS VALVE

PROCEDURE 5—SET GAS INPUT RATE The gas input rate for propane is the same as for natural gas. See furnace rating plate for input rate. The input rate for propane is determined bymanifold pressure only. The gas valve regulator must be set per pressure stated in Fig. 4. Furnace gas input rate on ratin...

Carrier INDUCED COMBUSTION FURNACES 58RAP- Manuals

Manuals:

User Manual Carrier INDUCED COMBUSTION FURNACES 58RAP

Summary

Carrier Manuals