Cambridge Audio Incognito BK10 - Manuals

Speaker cable Speaker cable PS10 AH10 Cat-5/5e cable BK10 KP10 EU The BK10 keypad can also be used as part of a full Incognito system, where it isplugged into an Incognito hub (AH10), perhaps with other Incognito accessoriessuch as a video switching unit (VH10) or local input module (LM10) fitted. S...

Avoid placing the keypad where there is line of sight to another keypad. In suchsituations both keypads may pick up the same commands from a remotecontrol and it will be difficult to control each zone independently. Avoid placing the BK10 where there is line of sight to the source equipment for thes...

REAR PANEL CONNECTIONS Speaker output Connect to a pair of speakers with tworuns of standard high-quality speakercable. Speakers of at least 88 dB SPLfor 1W @ 1 metre efficiency should beused with the BK10. Speakers from4–8 ohms can be used. Cat5 to BK10 A Cat-5 cable (terminated with an RJ45 jack p...

The six LEDs indicate the volume level of the BK10. The LEDsalso also display the source selectedwhen the source is changed and canalso show the status of some otherfunctions. For full instructions onvolume adjustment, source selection,sound adjustment and local sourceselection modes, refer to the‘O...

Volume down Press to decrease the volume or other sound adjustment. Source select (left) Use this key to select the current active source. IR window Point the Incognito LR10 Learning Remote towards this window. A smallflashing LED behind this window indicates operation. REMOTE CONTROL The BK10 can b...

OPERATING INSTRUCTIONS Volume adjustment Volume is adjusted using the volume up and volume down buttons on thekeypad or remote; this is indicated on the keypad by the intensity of the blueLED lights, there are four levels of intensity per LED. Source selection The Source left and right buttons allow...

Note: This feature is only available if the BK10 is part of a full Incognito multi-room system with one or two Local Input Modules (LM10) fitted. The local source selection mode will need to be activated to configure theBK10 correctly. This mode is only available when the Mode Switch is set to“AH10”...

Input impedance 45 k ohms Frequency response 20Hz – 20kHz +/- 1dB THD <0.2% @ 1W, 20Hz – 20 kHz S/N ratio > 80 dB ‘A’ weighted Volume control range - 80 dB, 36 steps Bass control range +/- 16 dB, 2 dB steps Treble control range +/- 16 dB, 2 dB steps Balance control range +/- 40 dB, 9 steps eit...

BK10 Table-top keypad Incognito table-top keypad 19 Cambridge Audio warrants this product to be free from defects in materials and workmanship(subject to the terms set forth below). Cambridge Audio will repair or replace (at Cambridge Audio’soption) this product or any defective parts in this produc...

Incognito BK10 www.cambridge-audio.com Part No. AP19601/1