Bunn 44306 - Manuals - manualsarea.com

Page 4 - USER NOTICES; Hot Water

4 USER NOTICES The notices on this dispenser should be kept in good condition. Replace unreadable or damaged labels. 00656.0001 As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be ...

Page 5 - DUAL VOLT TOGGLE SWITCH

5 ELECTRICAL REQUIREMENTS WARNING - The dispenser must be disconnected from the power source until specified in Initial Set-Up. Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. 208 & 240 volt ac models Note: This electrical service consist...

Page 6 - PLUMBING REQUIREMENTS - ALL EXCEPT OHW

6 INITIAL SET-UP - H5E, H5X, H5-PC, H10X, Element CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions.1. Connect dispenser to the power source and turn on water supply. 2. Place Master ON/OFF switch in the ON pos...

Page 7 - OHW

INITIAL SET-UP - H5M CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Remove the upper rear panel and rotate the control thermostat knob fully coun- terclockwise to the “OFF” position and replace the panel...

Page 8 - OPERATING CONTROLS - PORTION CONTROL ONLY; BUTTON; ADJUSTING DISPENSE VOLUMES

OPERATING CONTROLS - PORTION CONTROL ONLY (a) VOLUME SELECTOR BUTTONS Press and release the button corre- sponding to the Small, Medium, or Large volume, to select the desired amount of water to be dispensed. Pressing a different button after a cycle has been initiated does not change the volume in ...

Page 9 - LEVEL 1 PROGRAMMING; the display matches the model you are working with.; Continued

9 PROGRAMMING - H5-E, H5-PC, H5X, H10X When power is applied to the dispenser, the display located on the bottom of the main circuit board will show the software version for 5 seconds, and then it will show the model number (see chart below) it will then go to (-). While the tank is filling, the dis...

Page 10 - LEVEL 2 PROGRAMMING; H1 - DISPENSE TEMPERATURE LOCKOUT - PORTION CONTROL ONLY; Press and release the center button once more to advance to H2.; H2 - F° OR C° SELECTION

10 PROGRAMMING - H5-E, H5-PC, H5X, H10X Continued LEVEL 2 PROGRAMMING H1 - DISPENSE TEMPERATURE LOCKOUT - PORTION CONTROL ONLY (WILL NOT DISPLAY ON OTHER MODELS) 1. To enter Level 2 Programming, press and hold the center button until H1 ap- pears on the display (approximately 6 seconds) then release...

Page 14 - DRAINING THE DISPENSER - OHW; Gently remove one of the grommets from the tank lid.; CLEANING

14 DRAINING THE DISPENSER - OHW CAUTION - The dispenser must be disconnected from the power source throughout these steps.1. Disconnect the dispenser from the power source and allow dispenser to cool. 2. Tilt dispenser forward over sink. 3. Open faucet. 4. Continue tilting dispenser forward over sin...