Bose 601TM - Manuals - manualsarea.com

Page 2 - Bose; Kind of equipment: Loudspeaker; Series IV Direct/Reflecting; In accordance with EMC Directive 89/336/EEC and; Technical regulations:; Accredited by Bose Corporation

2 Oc tober 25, 2001 AM257731_00_V.pdf Customer Information Declaration of Conformity We, the offerer: Bose ® Corporation, The Mountain, Framingham, MA 01701-9168 USA Acknowledge our sole responsibility, that the product: Kind of equipment: Loudspeaker Type designation: 601 TM Series IV Direct/Reflec...

Page 3 - For your records; and

AM257731_00_V.pdf October 25, 2001 3 Contents Setting Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 4 - Figure 1; Unpacking the speakers; out of the reach of children.; Attaching the speaker grilles; Do not place objects into any opening on the speaker cabinets.

4 October 25, 2001 AM257731_00_V.pdf Setting Up Introduction Your 601 TM Direct/Reflecting ® speakers re-create a natural balance of reflected and direct sound energy for a lifelike, spacious performance. As with all Bose ® products, their design is meant to bring you high-quality concert-like sound...

Page 5 - Figure 3; they can be accidentally knocked over.; Choosing the speaker cord; wire or larger) is recommended for most applications. You can; Running the speaker cord through a wall or under a floor

AM257731_00_V.pdf October 25, 2001 5 Setting Up Placing the speakers The product label on the back of each speaker indicates LEFT or RIGHT. For best acoustic performance, place the left speaker on the left side as you face your speakers and place the right speaker on the right side. Keep the speaker...

Page 6 - Setting Up; Preparing the speaker cord; To prepare the ends of the cord, strip approximately; Making the connections; power mains. Failure to do so may result in damage to your system.; Tighten the knobs to secure the wires.

6 October 25, 2001 AM257731_00_V.pdf Setting Up Preparing the speaker cord Speaker cord consists of two insulated wires. The insulation around one wire is marked (striped, collared, ribbed, or may have writing on it). This marked wire is always positive (+). The plain wire is always negative (–). Th...

Page 7 - For use in home theater; For rear or surround speakers

AM257731_00_V.pdf October 25, 2001 7 Setting Up Checking the connections Check all the connections from the receiver to the left and right speakers. Make sure all the wires are connected in phase (+ to + and – to –). Correct any wiring problems before you plug in your receiver and turn it on. CAUTIO...

Page 8 - If you are experiencing problems with your 601; dealer to arrange for service. Refer to the address list

8 October 25, 2001 AM257731_00_V.pdf Reference Information Troubleshooting If you are experiencing problems with your 601 TM speakers: 1. Turn off the amplifier or receiver and check all the connections between the speakers and the amplifier or receiver. 2. Check your amplifier or receiver owner’s g...

Page 9 - Features; Customer service

AM257731_00_V.pdf October 25, 2001 9 Reference Information Technical information Features • Direct/Reflecting ® speaker technology • Stereo Everywhere ® speaker technology • Proprietary bass reproduction • Automatic protection circuitry • Syncom ® computer quality control Speaker driver complement •...

Page 10 - Reference Information

10 October 25, 2001 AM257731_00_V.pdf Reference Information