Bose 535 - Manuals

English - 5 Contents Welcome Thank You ............................................................................................................ 6Unpacking ........................................................................................................... 6 System Setup Control console bo...

6 - English Welcome Thank You Thank you for choosing a Bose ® LIFESTYLE ® system for your home. This guide provides step-by-step instructions for setting up your new system. There are two phases to the setup process: Physical setup phase: Placing the system components and connecting them together. I...

English - 7 System Setup 1 1 Control console box What you need from box 1: What you need from the power cord box: A. Place the control console on a flat, stable surface near your TV. Control console Note: Until your system is completely installed, it may be helpful to keep the control console positi...

System Setup 8 - English B. Plug one end of the HDMI ® cable into an HDMI INPUT connector on your TV. If an HDMI cable is already connected to an HDMI input on your TV, you can use this one. Just disconnect the other end. C. Plug the other end of the HDMI cable you are using into the connector label...

System Setup English - 9 D. Plug one end of the audio input cable into the control console connector labeled Audio OUT . Make sure the flat surface with the arrow on the plug faces up.Leave the other end of the cable on the floor. You will be asked to connect it while setting up the contents of the ...

System Setup 10 - English 2 Acoustimass ® module box What you need for the following steps: A. Place the Acoustimass module on the floor at the same end of the room as the TV. Make sure there is a live AC (mains) power outlet nearby. Acoustimass module B. Lay the module on its side and locate the co...

System Setup English - 11 CAUTION: DO NOT stand the Acoustimass ® module on its front or back end. C. Plug the free end of the audio input cable into the Media Center connector on the Acoustimass module.Make sure the flat surface with the arrow faces the front of the module. Media center D. Remove a...

System Setup 12 - English 3 Speaker box What you need for the following steps: System speakers (one set of the three types shown) Jewel Cube ® speakers (4) Left or right, front or rear speaker (1) Center front speaker Direct/Reflecting ® cube speaker arrays (4) Left or right, front or rear speaker (...

System Setup English - 15 F. Locate the speaker position markings on the free ends of the speaker cables. Speaker position marking (L, C, R, LR, or RR) G. Using the speaker position markings, run each cable out to its respective speaker as in the following setup example of a room. Front speakers Rea...

System Setup 16 - English H. Connect the speaker cable to the type of speaker you have. For Jewel Cube ® speakers: Insert the plug into the speaker connector. For Direct/Reflecting ® and Virtually Invisible ® single cube speakers: Press the button and insert the wires. Connect the red-collared wire ...

System Setup English - 17 4 Interactive box What you need for the following steps: Remote control with batteries ADAPTiQ ® audio calibration headset IMPORTANT!Before you start, make sure your speakers and Acoustimass ® module are in their final positions.Do not connect any devices to the control con...

System Setup 18 - English D. Press the power button on the control console to turn on your system.Because the system is in a low power state when in standby, it takes several seconds to start. When the system status indicator changes from blinking to steady green, your system is ready to use. Status...

System Setup English - 19 Other Box 4 items The remaining items in Box 4 may or may not be required to set up your LIFESTYLE ® system. For more information on using these accessories or adding other devices to your system at another time, see the operating guide. Operating guide USB flash drive (for...

System Setup 20 - English Applying rubber feet When placing the Acoustimass ® module on bare floors, you can attach the included rubber feet to the bottom of the module for greater stability and to protect your floor. Bottom panel Rubber feet Vibration can cause speakers to move, particularly if pla...

System Setup English - 21 If you have setup problems If you experience any difficulties during the setup process, such as an unrecog- nized device remote or a connection error, you can reactivate the interactive setup mode at any time and correct or change part of your system setup. See “Using the S...