Bosch EX36-IP - Manuals - manualsarea.com

Page 3 - Important safety instructions; - For limited power source units, this power source must comply with

Page 5 - National Electrical; Permanently connected equipment -

EX36-IP | en 3 Bosch Security Systems Quick Install MAN36IPB Rev.0 | 2008.10 The full version Installation Manual is available on the enclosed CD-ROM and can be viewed and printed out with Acrobat Reader, which is also on the enclosed CD-ROM. This user guide is the intellectual property of BOSCH Sec...

Page 6 - Unpacking; Parts list; Initial Preparations; ) Determine the operating voltage at the installation site. The; Mounting the unit; Faceplate removal

4 en | EX36-IP MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems 1.1 Unpacking Parts list (items supplied with unit) - EX36IP Infrared Imager™ Assembly- Installation Instructions booklet- Allen Key- Software CD Items required for installation (not supplied with units)- Mounting hardware-...

Page 7 - ) Use the supplied “security” Allen wrench to remove the six screws; Layout of modules; Faceplate

EX36-IP | en 5 Bosch Security Systems Quick Install MAN36IPB Rev.0 | 2008.10 2.) Use the supplied “security” Allen wrench to remove the six screws holding the faceplate to the housing. 3.) Remove the square foam cushion attached to the camera lens.4.) Ensure the polycarbonate windows in the faceplat...

Page 8 - These mounting guidelines should be followed:

6 en | EX36-IP MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems This view shows the interior layout of the EX36IP Camera assembly after the faceplate has been removed. 2.3 Camera: Mounting and setup: Select a suitable location that protects the camera from accidental damage, tampering a...

Page 10 - LED; power if they are too bright or too dim. For; IR; power

8 en | EX36-IP MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems “ON” (850nm LEDs will have a slight red glow). Adjust the LED power if they are too bright or too dim. For IR power adjustment, rotate VR1. Clockwise is high and counter- clockwise is low. 2.4) Photocell adjustment The phot...

Page 11 - Camera-directional adjustments

EX36-IP | en 9 Bosch Security Systems Quick Install MAN36IPB Rev.0 | 2008.10 3.) Launch Configuration Manager or web-browser. 2. 4 Camera-directional adjustments Both the camera and the LED array can be adjusted for optimum picture quality. The camera lens can be tilted on its axis via two adjustmen...

Page 12 - ) Slide the lens foam over the camera lens. Make sure the foam is; Note; Use Infra-Red Pass filter to cover the lens during focusing to

10 en | EX36-IP MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems 2.) Attach the faceplate to the camera housing. Insert and tighten the 6 bolts. 3.) Power-up the camera and check its operation. 2.6 Camera re-assembly Make sure all wires are properly connected, all holes are sealed again...