Bosch EX36 - Manuals

Corner-mount No-grip Camera Safety | en 7 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 1.2 Bosch Contact Information If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and for shipping instructions. USA R...

8 en | Description Corner-mount No-grip Camera F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc. 2 Description The EX36(N) Night Vision Camera has been designed with tilt on its faceplate to allow corner mounting and t provide better angle views in small rooms. The housin...

10 en | Installation Corner-mount No-grip Camera F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc. 3 Installation 3.1 Initial Preparations – Determine the operating voltage at the installation site. – Determine the optimum location for the camera. Refer to Section 3.4 Mou...

Corner-mount No-grip Camera Installation | en 11 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 4. Ensure that the polycarbonate windows in the faceplate are not scratched. Figure 3.1 Faceplate Removal Figure 3.2 below shows the interior layout of the EX36(N) camera as...

12 en | Installation Corner-mount No-grip Camera F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc. Figure 3.2 Layout of Modules 3.3 Input Power Connections The camera unit is pre-connected with an electrically isolated power board for 24 VAC or 12 VDC operation with no wi...

Corner-mount No-grip Camera Installation | en 13 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 Figure 3.4 Board Connections, LED Voltage Regulator Board (VRB) 3.4 Mounting the Camera Housing 1. Select a suitable location that is protected from accidental damage, tampe...

Corner-mount No-grip Camera Installation | en 15 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 6. Mount the housing using the supplied mounting screws. 7. Ensure that the power and video cables are not crimped or stressed after the camera has been mounted. 3.5 Camera ...

16 en | Installation Corner-mount No-grip Camera F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc. 3.6 LED Adjustments (EX36N only) If you must make adjustments to the LEDs, follow the steps below. Refer to Figure 3.7 below for more details. Figure 3.7 LED Array Adjustmen...

Corner-mount No-grip Camera Installation | en 17 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 3.7 Lens Replacement There is an extra 3.6 mm lens supplied with the unit and one extra focusing hex key. To replace the standard 2.5 mm lens with the supplied 3.6 mm replac...

Corner-mount No-grip Camera Technical Information | en 19 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 4 Technical Information 4.1 Troubleshooting - Camera PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION No video Power supply: connections Check input power connections at th...

20 en | Technical Information Corner-mount No-grip Camera F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc. 4.2 Troubleshooting - LEDs Horizontal scan lines, rolling up or down Ground looping on video cable Check the coax cable shield is not touching ground (for example, ...

Corner-mount No-grip Camera Technical Information | en 21 Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02 4.3 General Specifications Specifications are subject to change without notice. CCD Sensor 1/3 in. - IR Optimized Video Signal Output 1 V p-p, 75 Ohm LED Type (EX36...