Bosch E2600 - Manuals - manualsarea.com

Page 3 - Table of contents

Table of contents 1 Before you begin 4 1.1 Learn about management methods 4 1.2 What you need for assembly 4 2 Device view 6 3 Install the mounting rails 7 4 Install the controller-drive tray 8 5 Secure the controller-drive tray 9 6 Connect the cables 10 7 Turn on the DC power 13 8 Turn on the AC po...

Page 4 - Before you begin

Before you begin For warnings and detailed installation instructions, refer to the E2600 DSA E-SeriesInstallation manual and additional documentation in the Online Product Catalog on http://www.boschsecurity.com > Video > Digital Recording and Storage > Disk Arrays (NetworkAttached) > DS...

Page 6 - Device view; Controller-Drive Tray – Rear View

Device view Controller-Drive Tray (12 Drives) – Front View ! 1 2 3 4 5 6 Figure 2.1: Front View E2600 1 Standby Power LED 4 Service Action Required LED 2 Power LED 5 Locate LED 3 Over-Temperature LED 6 Drive Canister Controller-Drive Tray – Rear View 1 2 Figure 2.2: Rear View E2600 1 Controller Cani...

Page 7 - Install the mounting rails

Install the mounting rails You can install the drive tray into an industry-standard cabinet.There must be a minimum depth of 76 cm (30 in.) between the front EIA support rails and therear EIA support rails.1. Position the mounting rails in the cabinet.– If you are installing the mounting rails above...

Page 8 - Install the controller-drive tray

Install the controller-drive tray ! Warning!Risk of bodily injury , Two persons are required to safely lift the component. 1. With the help of one other person, remove the controller-drive tray from the shipping box. 2. With the help of one other person, slide the rear of the controller-drive tray o...

Page 9 - Secure the controller-drive tray

Secure the controller-drive tray ! Warning!Risk of bodily injuryDo not use equipment in the cabinet as a shelf or work space. 1. Secure the screws in the top mounting holes and the bottom mounting holes on eachside of the controller-drive tray. 2 1 1 2 Figure 5.1: Controller-Drive Tray (12 Drives) 1...

Page 10 - Connect the cables

Connect the cables ! Warning!Risk of exposure to laser radiationDo not disassemble or remove any part of a Small Form-factor Pluggable (SFP) transceiverbecause you might be exposed to laser radiation. In this step, you will connect the E2600 controller-drive tray to the host or hosts, and then youwi...

Page 13 - Turn on the DC power

Turn on the DC power i Notice!DC power is an option that is available for use with your E2600 controller-drive tray and drivetrays. If you choose to have –48 VDC power available, you need a qualified service person toinstall the equipment that provides special DC power connectors to each power-fan c...

Page 15 - Turn on the AC power

Turn on the AC power 2 1 You must follow the power sequence in the order shown for turning on AC power tocontroller-drive trays and drive trays that use AC power. To establish power redundancy fortrays with two power supplies, use at least two different power distribution units (PDUs) inthe cabinet....

Page 16 - Install and configure the storage array

Install and configure the storage array For the basic setup use the VRM Configuration Manager software. For detailed informationrefer to the Configuration Manager operating manual.For advanced features refer to the SANtricity configuration and installation manual.All necessary documentation can be f...