Bosch 119 - Manuals

4 - ENGLISH www.boschappliances.com MATERIALS SUPPLIED DISHWASHER INSTALLATION KIT (Clear Bag) D. Toe Panel Screws (8mm) (2) E. Mounting Brackets (1L & 1R) F. Mounting Bracket Screws (2) G. Rubber Connection Hose (1) and Drain Hose Clamps (2) SHU 6800 Models • Dishwasher Installation Kit (1) and...

ENGLISH - 5 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com A C B Select a location as close to the sink as possible for ready access to water and drain lines. Most of the installation work is done before the dishwasher is moved into place.Any built-in dishwasher must be fully enclosed o...

6 - ENGLISH www.boschappliances.com PLUMBING PREPARATION 1. I n o r d e r t o r e d u c e r u n n i n g t i m e , B o s c h r e c o m m e n d s 1 4 0 ° F w a t e r i n l e t temperature. Your dishwasher will perform equally as well at 120° F water temperature, but the run time will be extended. Hot ...

ENGLISH - 7 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com ELECTRICAL PREPARATION • Cut a 1” (25.4mm) diameter hole in the cabinet (in area of Figure 9 B). For wood cabinets, sand the hole until smooth. For metal cabinets, cover the edge with a grommet. • Run flexible cable (as codes pe...

8 - ENGLISH www.boschappliances.com PLACING THE DISHWASHER Placing the Dishwasher The profile strips on the sides of the dishwasher allow the dishwasher to fit into a cabinet opening with a width of 24” (610 mm) to 24-1/4” (616 mm). Before sliding the dishwasher into the cabinet opening: • Straighte...

ENGLISH - 9 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com DRAIN HOSE CONNECTION Drain Hose • Before beginning, turn off the water supply! • The access hole for the drain hose should be 1.25” (32 mm) diameter. • Use the hose clamps and rubber connection hose (Figure 3) to connect the dr...

10 - ENGLISH www.boschappliances.com HOT WATER CONNECTION Openings for water lines must be installed in the marked areas as shown i n F i g u r e s 8 a n d 9 t o a v o i d interference with the dishwasher frame or other components. • If using a solder joint instead of a com- pression fitting, be sur...

ENGLISH - 11 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com ELECTRICAL SUPPLY CONNECTION • Install strain relief or conduit connector into opening on J-box. • Strip the insulated wires, being extremely careful not to strip too much insulation. • Insert and securely fasten into strain re...

12 - ENGLISH www.boschappliances.com If you have an SHI model, an integrated model, you will have additional mounting hardware and a folded template sheet with installation instructions comprised of pictograms. In North America the black, white and stainless steel models of the integrated series (SH...

ENGLISH - 13 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com Figure 19 DOOR PANEL INSTALLATION *Note: Do not exceed 30 5/16” (770mm) for the overall front panel length. SEE FOLDED PANEL INSTALLATION TEMPLATE SHEET FOR STEP BY STEP INSTRUCTIONS ON HOW TO INSTALL YOUR DISHWASHER PANEL(S). ...

14 - ENGLISH www.boschappliances.com Figure 23 Figure 22 After installation of the dishwasher, open and close the door several times to make sure that it does so with ease. If the door closes too quickly or if the door falls open, the spring tension needs to be adjusted. To Adjust the Spring Tension...

ENGLISH - 15 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com SHU 6800 Series Base and Toe Panel Installation Steps BASE AND TOE PANEL Assembly Steps • Place J-Box Cover on J-Box, insertand tighten screw (Figure 26). • Drop screws inside holes in base part. • Slip Base Part under and up f...

16 - ENGLISH www.boschappliances.com TOE PANEL AND HANDLE SHU 9910/9920/8800/8810 Handle Assembly The SHU 9900 model has a handle that needs to be assembled onto the door panel. Reference installation kit and instructions provided with the handle. Refer to Figures 29 and 30. 1 1. Figure 28 2. Figure...

ENGLISH - 17 ENGLISHENGLISHENGLISHENGLISHENGLISH www.boschappliances.com LEAVE INSTALLATION INSTRUCTIONS AND USE & CARE MANUAL WITH OWNER. Final Checklist Check Electrical Requirements. Be sure you have correct electrical supply and recommended grounding method. Turn on the hot water shut-off va...