Bogen C60 - Manuals - manualsarea.com

Page 2 - IMPORTANT

Notice Every effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subject to change. Important Safety Information WARNING: To Reduce The Risk of Fire Or Electric Shock, Do Not Expose This Apparatus To Rain Or Moisture. ...

Page 3 - Contents

Contents Page PANEL DESCRIPTIONS..................................................................................................2-3 Classic Series Front Panel..................................................................................................................2Classic Series Rear Panel...

Page 4 - Panel Descriptions; Classic Series Front Panel

Panel Descriptions Classic Series Front Panel 1 . MIC 1 Level Control Individual level control for a dedicated microphone input. 2. MIC2/AUX 1 Mode Switch Switch selects either the MIC2 or AUX 1 connection as the active input. 3. MIC2/AUX 1 Level Control Individual level control for a dedicated micr...

Page 5 - Classic Series Rear Panel

Panel Descriptions Classic Series Rear Panel 1 . Amplifier Output Screw terminal strip containing all available speaker outputs. 2.Tape/Booster RCA unbalanced signal level/output. 3. WMT 1 A RCA output connection for Bogen’s 600-ohm balanced line matching transformer Model WMT 1 A. 4. AUX Terminal S...

Page 6 - Installation; Package Contents; Ventilation

Installation Package Contents • Classic Series Amplifier • Instruction Manual Ventilation When using a shelf or table mount, the amplifier should stand alone with no equipment on top of it or belowit. If the amplifier must be stacked with other equipment, care must be taken to ensure that all the mi...

Page 7 - Connections; Input Connections; Output Connections

Connections Input Connections Microphone Connections These inputs are for two low-impedance balanced dynamic microphones.Connect cable shield to center screw marked "GND." Auxiliary The AUX inputs provide unbalanced RCA inputs for connection toexternal signal-level equipment. AUX Muting For ...

Page 8 - Operation; Front Panel Controls

Operation Front Panel Controls Power The front panel ON/OFF switch applies power to the amplifier and is illumi-nated when power is ON. Input Volume Controls Each input module may be individually controlled by its corresponding volumecontrol knob. MIC2, AUX 1 Mode Switch Activates the corresponding ...

Page 9 - Rear Panel Controls

7 Operation Rear Panel Controls TEL Volume Control The TEL VOLUME control on the rear panel adjusts the TEL input’s paginglevel. It does not affect the microphone level. Rotate the control counter-clockwise to decrease the level. Rotate the control clockwise to increase thelevel. VOX SENSitivity Con...

Page 10 - Specifications

Power Output (RMS) C35: 35W C60: 60W C 1 00: 1 00W Frequency Response & Distortion Transformer † : 70 - 1 6 kHz (± 2 dB) @ 1 % max. 4-Ohm Direct Output: 20 - 20 kHz (± 1 dB) @ 0.5% max. Hum and Noise MIC Input: 55 dB below rated output AUX Input: 70 dB below rated output TEL Input: 70 dB below r...

Page 11 - Troubleshooting

Troubleshooting 9 PROBLEM CONDITION CAUSE NO SOUND Power Switch Indicator is OFF. • Amplifier not plugged in.• AC outlet dead.• Power switch off.• Circuit breaker tripped. Power Switch Indicator is ON. • No signal from source.• Volume turned down.• Speakers not connected correctly.• Link jumper not ...

Page 12 - Accessories; Warranty

Bogen Classic Series Amplifiers are warranted to be free from defects in material or workmanship for two (2) years from the dateof sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use, becomesdefective will be repaired or replaced by...