Bogen 54-2141-01B 0608 - Manuals

Page 2 - Contents

Contents Introduction ....................................................................................................................................................................... 3Using This Manual ..............................................................................................

Page 3 - Available Accessories

Introduction The Bogen Enhancer is an infrared wireless microphone system offering professional performance andoperating features. Infrared transmission is used to reduce room-to-room interference while sending a sig-nal from a presenter’s microphone to a dual-channel receiver. The receiver works in...

Page 4 - System Features; BCWR Dual-Channel Wireless Microphone Receiver

System Features BCWR Dual-Channel Wireless Microphone Receiver • Dual Receiver, Simultaneous 2-Channel Operation for 2 Transmitters (Ch. A, Ch. B)• Infrared (IR) Signal Reception LED Indicators• Channel A/B Mixed Audio Output RCA-type Connector• Separate Channel A and Channel B Volume Controls• Two ...

Page 5 - BCWR Receiver; Connecting the Audio Output; Connecting the BCIRS IR Sensors; Powering the Receiver

BCWR Receiver POWER INPUT 16V AC Connecting the Audio Output The BCWR Receiver provides an unbalanced, line-level mixed output to the RCA Jack (3) . This can be connected to a mixer or a P.A. system using the supplied RCA to RCA audio cable. The audio of bothChannels A and B are mixed together at th...

Page 6 - Installation

BCIRS Infrared (IR) Sensors Operation The IR Sensors act as "antennae" for your infraredwireless microphone system. A multiple array ofwide-angle IR-sensitive LEDs (behind the frontpanel receptors) receive the infrared signal emittedby your IR Transmitter. Connect each BCIRS Sensorto the rea...

Page 7 - Operation; ON/LOW Battery LED Indicator; BCWBT Body-Pack Transmitter

Transmitter Setup Slide down the Battery Compartment Cover ( 1 ) , as shown, exposing the battery compartment. Insert 2 fresh AA alkaline batter-ies or the optional BCBRBP Battery Pack NiMH rechargeable batter-ies while observing the correct polarity as marked. Set the Channel Selector Switch (2) to...

Page 9 - BCWHT Handheld Microphone Transmitter

Transmitter Setup Unscrew and remove the Battery Compartment Cover ( 1 ) by sliding it down off the microphone to expose the battery holder. Insert 2 fresh AA alkaline batteries or the optional BCHRBP Battery Pack NiMHrechargeable batteries, while observing the correct polarity as marked, and screw ...

Page 10 - Specifications; BCWHT Handheld Microphone Transmitter:

Specifications BCWR Receiver: Mode Infrared Frequency Modulated Receiving Channels Dual-Channels A & B Carrier Frequency Ch. A: 2.0 MHz; Ch. B: 2.6 MHz Audio Frequency Response 60 Hz- 1 2 kHz S/N Ratio > 90 dB Audio Mix Output 400 mV Range (line-of-sight) Up to 30 ft. Controls Power ON/OFF (f...