BMW S 1000 RR - 2010- Manuals

9 Figure 11 Figure 12 Unscrew the radiator’s bracket off the engine block and both lambda sensors (Figure 11). 10. Remove the header tubes valve cable from servo motor (Figure 12). WARNING: do not turn the the servo motor wheel with force or the servo motor could be damaged!WARNING: do not disconnec...

www.akrapovic.com 10 Figure 13 Figure 14 Unscrew all nuts from the front header tube flanges (Figure 13). WARNING: make sure not to damage the radiator’s cooling fins! 12. Unscrew the market bolt on both sides of the motorcycle and remove the stock exhaust off the motorcycle (Figure 14, 15). WARNING...

www.akrapovic.com 12 Figure 16 Figure 17 INSTALLATION OF THE AKRAPOVIČ RACING OR EVOLUTION EXHAUST SYSTEMS: 1. Set up and hand tighten the sleeves together with the flanges and springs onto the cylinder head; make sure they are correctly oriented (Figure 16, 17). WARNING: do not fully tighten the fl...

9.8Nm 7ftlb 9.8Nm 7ftlb 29Nm 22ftlb 13 Figure 18 Figure 19 Insert the middle header tubes all the way into the sleeves together, attach the springs and tighten the middle flanges to a specified torque (Figure 18). WARNING: use anti-seize copper paste on all nut threads! 2. Tighten the lambda sensors...

www.akrapovic.com 16 Figure 24 Figure 25 For street legal Racing and Evolution only: remove the stock exhaust cables off the stock exhaust valve and install them back onto the exhaust valve servo motor (Figure 24). WARNING: make sure, that you don’t swap the two cables! WARNING: do not turn the the ...

9.8Nm 7ftlb 4.9Nm 3.6ftlb 17 For street legal Racing and Evolution only: set the cable adjusters on the middle of the cable bracket, as shown. Tighten the cable adjusters nuts to a specified torque (Figure 26). Figure 26 Figure 27 11. 10. For street legal Racing and Evolution only: tighten the carbo...

www.akrapovic.com 22 Nm 16 ftlb 18 Figure 28 12. Attach the additional Akrapovič stainless steel bracket to the stock right passenger footrest bracket, useing Akrapovič nut, bolt and washer (Figure 28, 29). Figure 29

Figure 30 19 Figure 31 Correctly position the carbon-fiber clamp and slide it onto the muffler - bear in mind the left offset of the carbon fiber clamp viewed from the rear (Figure 31). WARNING: open the clamp slightly wider than the diameter of the outer sleeve of the muffler – do not scrape it alo...

www.akrapovic.com Figure 32 22 Nm 16 ftlb 20 Figure 33 Align the muffler in respect to the motorcycle and tighten the muffler clamp to the bracket, using Akrapovič bolt, washers, and nut as shown (Figure 33). 16. Position the muffler correctly and slide it onto the outlet side of the link pipe. Atta...

Figure 34 2 Nm 1.4ftlb 21 Figure 35 Assemble the cowlings in the reverse order from the order in which they were removed (Figure 35). WARNING: tighten all cowling bolts to a recommended torque or check vehicle manufacturer manual! 18. 22 Nm 16 ftlb For optional carbon-fiber muffler bracket only: ali...

www.akrapovic.com 22 IT IS NORMAL IF WHITE SMOKE COMES OUT OF THE MUFFLER ON FIRST OPERATION. DO NOT STAND BEHIND THE MUFFLER ON FIRST OPERATION. DO NOT USE AUTOMOTIVE WHEEL CLEANERS OR ANY CLEANING PRODUCTS WHICH CONTAIN ACIDIC ADDITIVES TO CLEAN AKRAPOVIČ EXHAUST SYSTEMS. 1. Clean the titanium exh...