Page 2 - Note: for 2001 and later BMWs see below; Plugging tool in properly:
IMPORTANT DISCLAIMER: This product was designed to provide a long service life and ease of use. As withany software-based device, there is a risk that a small number of unique ECU(Engine Control Unit) variants may not be compatible with this device. BavarianAutosport may not be held liable for any p...
Page 3 - Code Reader/Reset Tool Face; Shows menu selections,; Directions; reader is ready to use when it displays “Fc”.; Function Reference; Read Fault Codes
2001 on (located inside the BMW) To locate the diagnostic connector inBMWs built 2001 and later, open thedriver’s door, kneel down and look upat the underside of the dashboard.You will see the diagnostic connectornear the pedals, above the driver’sleft leg (see illustration). You will seea rectangul...
Page 4 - Using The Code Charts; TABLE 1: CHART LOCATOR
Using The Code Charts IMPORTANT: Skip to page 14 if the tool did not display “FF” for the code chart. 1. If the tool displays “FF” for the chart designator, find the car in Table 1 (below) by looking up the year, model and, if necessary, the VDS (Vehicle Description System) number found in the VIN (...
Page 7 - Use the following code; Chart 0b
54 Secondary air pump final stage 55 Secondary air valve final stage 5d EVAP emission control system 5E EVAP large leak 61 EVAP small leak 62 EVAP purge control valve circuit 65 DME, internal RAM failure 66 DME, external RAM failure 67 DME, ROM failure 68 Fault code memory error 6b Control unit supp...
Page 8 - Chart 0F
24 "Fuel trim, Ti additive, Cyl 5-8" 27 EWS message 28 "Catalyst efficiency, Cyl 1-4" 2D "Catalyst efficiency, Cyl 5-8"32 "Misfire detected, Cyl #1" 33 "Misfire detected, Cyl #2" 34 "Misfire detected, Cyl #3" 35 "Misfire detected, Cyl #4" 36 ...
Page 9 - Chart 1b
98 "Fuel Injector, Cyl #4" 99 "Fuel Injector, Cyl #8" 9A "Fuel Injector, Cyl #6" 9B "Fuel Injector, Cyl #3" 9C "Fuel Injector, Cyl #7" 9D "Fuel Injector, Cyl #2" A3 Throttle position / air mass plausibility A4 Ambient pressure sensor A5 "VANOS outp...
Page 16 - Common Problems / Troubleshooting; native connector configurations for the code reader/reset tool:
6.) Perform a power reset of all modules (entire car) NOTE: before doing this procedure, get your radio security code from the dealer. a) Disconnect the main car battery.b) Activate the emergency flasher lights (this will fully drain all power from all ECUs) and wait 5 minutes. c) Reconnect the main...
Page 18 - see Intervention above.
Warranty: Bavarian Autosport warrants, to the original purchaser, that your BMW code read-er/reset tool, hereinafter called “unit”, is free from any defects in material and work-manship for a period not exceeding two years from the date of purchase. If anysuch defect is discovered within the warrant...