Black Box LPJ008A-FM - Manuals

724-746-5500 | blackbox.com Page 8 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 2.4 Hardware Description 2.4.1 Front Panel Figure 2-1 shows the front panel of the 24-port PoE Gigabit Injector. Figures 2-2 and 2-3 show close-up views of front-panel components. Table 2-1 descr...

724-746-5500 | blackbox.com Page 10 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 2.5 Safety Procedures: General Precautions Please read the following precautions carefully before installing and connecting the system to a power source: NOTE: Only qualified and trained service...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 11 Chapter 3: Hardware Installation 3. Hardware Installation 3.1 Power Cord Requirements Power cords must meet the requirements for the country where you will use the PoE Injector. U.S. and Canada • The cord must have a minimum of 10-A rat...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 13 Chapter 3: Hardware Installation Figure 3-4. USB cable connected to PoE Gigabit Injector. AC power cord Connect the AC power cable to the AC power connector on the rear of the PoE Gigabit Injector and the power outlet. See Figure 3-5. I...

724-746-5500 | blackbox.com Page 14 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 3.5.2 Click System Reset on the Graphical User Interface (GUI) 1. AC LED remains green2. Ethernet LED remains off until the unit is connected3. 24 ports (with ports connected): same sequence as ...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 15 Chapter 4: Black Box GUI and USB Driver Installation 4. Black Box GUI and USB Driver Installation Locate and download the GUI Installation file from the included CD-ROM. 4.1 PC-to-PoE Gigabit Injector GUI Follow the Installation Wizard ...

724-746-5500 | blackbox.com Page 16 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 4.3 Device Manager: to View Port Properties When you are ready to begin, connect the proper end of the USB-to-Serial cable to your PoE Gigabit Injector and the other to an available USB port on ...

724-746-5500 | blackbox.com Page 18 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 4.4 USB Block Diagram USB device (PoE) internal function Connects USB port (PC) to PoE device via USB cable Internal USB device sends a signal to your PC, creating a “virtual COM port” (serial c...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 19 Chapter 5: GUI Operation 5. GUI Operation The firmware is supplied with a Graphical User Interface (GUI), which is used to configure and manage the PoE Gigabit Injector system. If you have successfully installed the Black Box GUI and US...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 21 Chapter 5: GUI Operation 5.3 GUI Port Description The Port Description panel shows 16 ports. On the 8- or 16-Port PoE Gigabit Injector models, the port numbers higher than the system port count will be shaded gray and disabled. Each sec...

724-746-5500 | blackbox.com Page 22 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors 5.4 GUI Parametric Information This section allows users to review, but not edit, parametric information for each port. Figure 5-7. Parametric information. The Port Parametric Information panel ...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 23 Chapter 6: Troubleshooting 6. Troubleshooting If you have problems with the PoE Gigabit Injector, verify the following: NOTE: The troubleshooting solutions provided can only solve minor problems. If your problem is not listed, contact B...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 25 Appendix A: Optional Ethernet Interface Figure A-2. Ethernet manager screen. 5. If your device is not found, check the connection and click “View”—> “Refresh.” See Figure A-3. Figure A-3. Refresh Ethernet manager screen.

724-746-5500 | blackbox.com Page 26 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors A.2 Advanced Setup Options For advanced setup configuration, click “Config”—>“Device Settings” OR type the IP address in your Internet browser. Your Internet browser will open with the follow...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 29 Appendix A: Optional Ethernet Interface Configuration Description Table A-1. Controller Setup. Item Default Settings Description Administrator Admin The login administrator is a user-defined name that is used at login. Write down your n...

724-746-5500 | blackbox.com Page 34 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors Figure A-14. Local Area Connection Properties/Internet Protocol Properties screen. A.5 Setup NIC PoE Gigabit Injector with Black Box GUI Locate the Black Box PoE GUI on your desktop or from your...

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com Page 37 Appendix B: SNMP MIB Controls Appendix B. SNMP MIB Controls Black Box registered Enterprise ID: 2.3.6.1.4.1.24852 SNMP Version: SNMPv3 TCP, UDP Port: 161 SNMP (Simple Network Management Protocol) Table B-1. SNMP MIB. OID Name Type Value...

724-746-5500 | blackbox.com Page 40 724-746-5500 | blackbox.com 802.3af and 802.3at PoE Gigabit Injectors Table B-1 (Continued). SNMP MIB. OID Name Type Value Description 2.3.6.1.4.1.24852.2.4.1.1.1~24 poeTrapsControlGroupIndex INTEGER Not-accessible Uniquely describes the (0.65535) group the trap c...

724-746-5500 | blackbox.com Page 42 802.3af and 802.3at PoE Gigabit Injectors Appendix C: Frequently Asked Questions Question: What happens if I forget my username and passwords for the Ethernet interface? Answer: Contact Black Box Technical Support at 724-746-5500 or [email protected]. Question: Wh...

724-746-5500 | blackbox.com About Black Box Black Box Network Services is your source for an extensive range of networking and infrastructure products. You’ll find everything from cabinets and racks and power and surge protection products to media converters and Ethernet switches all supported by fr...