Page 3 - Mini-Cat5 Extender Wallplate Transmitter; Trademarks Used in this Manual; FCC and Canadian Dept of Communications Radio
Mini-Cat5 Extender Wallplate Transmitter 1 Trademarks Used in this Manual BLACK BOX and its logo are registered trademarks of Black Box Corporation. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. FCC and Canadian Dept of Communications Radi...
Page 5 - Contents
Mini-Cat5 Extender Wallplate Transmitter 3 Contents 1. Introduction ....................................................................................... 4 1.1 General......................................................................................... 4 2. Installation ..........................
Page 6 - PC’s VGA video (RGBHV) at any resolution
Model AC504A-WP 4 1. Introduction 1.1 General The AC504A-WP is used to send PC Video or analog HDTV (component video) on UTP (Cat5/5e/6) cables. Power is also transmitted on the same Cat5 cable between the sender unit and the receiver. The AC504A-WP can extend the video up to 500 feet. The unit can ...
Page 7 - Extends high resolution video with no loss to 500 feet; Setup Connections
Mini-Cat5 Extender Wallplate Transmitter 5 Figure 2 – AC504A-WP Front 1.2 Features • Extends high resolution video with no loss to 500 feet • Differential signaling eliminates ground loops and noise • Handles resolutions up to 1600x1200 at any refresh rate • Slim single gang wall plate design • Reli...
Page 8 - Electrical Safety Note
Model AC504A-WP 6 4. Plug in the supplied Power supply to the Power Input jack on the rear of the sender unit. On the rear of the unit next to the RJ45 connector, there is a 2 pin screw terminal for power connection. You need to connect 9 vDC to these terminals. In your package there is either of th...
Page 9 - If the source is Component Video; Video Compensation Adjustment; Note dark line has a clean transition
Mini-Cat5 Extender Wallplate Transmitter 7 5. Apply a video source to the system and check for an image at each receiver, then set the compensation Potentiometer (pot) for best possible image. Note: If the source is Component Video (YPbPr) an HD15 to 3 RCA cable will be required for each HD15 connec...
Page 11 - Contacting Black Box; If you need to transport or ship your extender:
Mini-Cat5 Extender Wallplate Transmitter 9 3. Troubleshooting 1. Fuzzy, blurry, or ghosting image at remote location If you have a stable image but it looks blurry (object or character edges are smearing), adjust the compensation on the receiver. If you still have a fuzzy image, try reducing the ref...
Page 13 - EIA/TIA 568B WIRING STANDARD
Mini-Cat5 Extender Wallplate Transmitter 11 5. Appendix EIA/TIA 568B WIRING STANDARD PIN Wire Color 1 White w/ Orange Stripe 2 Orange 3 White w/Green Stripe 4 Blue 5 White w/Blue Stripe 6 Green 7 White w/Brown Stripe 8 Brown
Page 16 - © Copyright 2007. Black Box Corporation. All rights reserved.
© Copyright 2007. Black Box Corporation. All rights reserved. 1000 Park Drive Lawrence, PA 15055-1018 724-746-5500 Fax 724-746-0746