BILLY GOAT QB1104H - Manuals

Page 2 - Par t No. 430316 For m No. F083100A; DO NOT transpor t unit with fuel in tank.; VIBRATION; TABLE OF CONTENTS; SOUND; IN THE INTEREST OF SAFETY; cancer, birth defects or other reproductive harm.

Par t No. 430316 For m No. F083100A WARNING: DO NOT 1. DO NOT run engine in an enclosed area.Exhaust gases contain carbon monoxide, anodorless and deadly poison. 2. DO NOT place hands or feet near movingor rotating par ts. 3. DO NOT store, spill or use gasoline nearan open flame, or devices such as ...

Page 3 - Par t No. 430316 Form No. F083100A; For your safety and the safety of others, these; GENERAL SAFETY; PUT OIL IN ENGINE BEFORE STARTING; ASSEMBLY; Boxing Checklist; Parts Bag

Par t No. 430316 Form No. F083100A Page 3 of 12 For your safety and the safety of others, these directions should be followed: Use of Ear Protection is recommended whileoperating this machine. Do not operate this machine without first readingowner's manual and engine manufacturer's manual. Use of Ey...

Page 4 - CONTROLS; INSTRUCTION LABELS; OIL ALERT; Honda; DANGER; Honda; PATENT; WARNING; PULL THEN SLIDE TO LOCK

Par t No. 430316 For m No. F083100A Page 4 of 12 These labels should be included on your Blower. If any ofthese labels are damaged, replace them before putting thisequipment into operation. Item and part numbers are given tohelp in ordering replacement labels. 4 Check Owner's Manual 430316 Check War...

Page 5 - OPERATION; IF YOUR UNIT FAILS TO START:; See Troubleshooting on page 12.; STARTING; BLOWING OPERATION; Side Discharge Straight Position

Par t No. 430316 Form No. F083100A Page 5 of 12 HANDLING & TRANSPORTING: OPERATION 16 Using two people to lift machine is recommended. Lift holding thehandle and handle brace. Secure in place during transport. INTENDED USE: This machine is designed for cleaningoutdoor surfaces, where the debris ...

Page 6 - ADJUSTING AIR DIRECTOR; continued; If engine is to be unused for 30 days or more, prepare as follows:; Remove all gasoline from carburetor and fuel tank to prevent gum; STORAGE; Raise Lock Position

Par t No. 430316 For m No. F083100A Page 6 of 12 When you lock the lever, the default position of air director is in themiddle or straight out. If you want to raise or lower air director lockposition you must adjust the threaded fitting on the cable. ADJUSTING AIR DIRECTOR 16.4 This position directs...

Page 7 - MAINTENANCE; ing oil can help loosen a stuck impeller.; IMPELLER REMOVAL; Maintenance Operation; Check at regular intervals and maintain.; TIRE AIR PRESSURE; DO NOT pull or pry on impeller blades.

Par t No. 430316 Form No. F083100A Page 7 of 12 MAINTENANCE 17 Use only a qualified mechanic forany adjustments, disassembly or anykind of repair . DISCONNECT SPARK PLUG WIREBEFORE SERVICING UNIT. WARNING: TO AVOID PERSONAL INJURY, ALWAYSTURN MACHINE OFF, MAKE SURE ALL MOVINGPARTS COME TO A COMPLETE...

Page 8 - AIR FILTER COVER REMOVAL INSTRUCTION (BRIGGS AND STRATTON)

Par t No. 430316 For m No. F083100A Page 8 of 12 AIR FILTER COVER REMOVAL INSTRUCTION (BRIGGS AND STRATTON) Figure 1 Removing the air filter cover (for air filter change and throttle control installation)1. Disconnect spark plug wire.2. Remove the locknut and the screwcap holding the front par t of ...

Page 9 - AIR FILTER COVER REMOVAL INSTRUCTION (HONDA); Figure 1; THROTTLE CONTROL CABLE INSTALLATION; Figure 3

Par t No. 430316 Form No. F083100A Page 9 of 12 AIR FILTER COVER REMOVAL INSTRUCTION (HONDA) Figure 1 Removing the air filter cover (for air filter change and throttle control installation)1. Disconnect spark plug wire.2. Remove the wingnut on the top of the air cleaner cover (fig. 1).3. Remove the ...

Page 10 - PARTS DRAWING

Par t No. 430316 For m No. F083100A Page 10 of 12 PARTS DRAWING 18 QB884H, QB1004, QB1104H

Page 11 - Notes

Par t No. 430316 Form No. F083100A Page 11 of 12 Denotesparts foundin parts bagassembly. * Notes standardhardwarethat may bepurchasedlocally. 19 PARTS LIST QB8 84H QB1 004 QB1 104H PA R T NO QTY PA R T NO QTY PA R T NO QTY 1 EN GIN E - 11HP HON DA - - - - 400931 1 EN GIN E - 10 HP B RIGGS & ST R...

Page 12 - TROUBLESHOOTING; Before Requesting Service Review These Suggestions; Engine Service and Warranty; Contact your nearest engine manufacturer's authorized; Serial Plate; WARRANTY PROCEDURE

Par t No. 430316 For m No. F083100A Page 12 of 12 Clear clog. Solution Problem Possible Cause TROUBLESHOOTING Before Requesting Service Review These Suggestions Air intake or exhaust clogged. Abnormal vibration. Loose or out of balance impeller or loose engine. Check impeller and replace if required...