Bertazzoni X906GEV - Manuals

5 WARNING: After completing the above-mentioned replacements, the technician must adjust the burners, as described in the paragraph below, seal any adjustment and pre-adjustment devices and apply the label on the appliance, to replace the existing one, corresponding to the new gas adjustment. This l...

6 WARNING: If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. For New Zealand - This cooking range must be connected to the supply by a supply cord fitted with an appropriately rated plug that is com...

7 To replace the power cable, lift the terminal board’s cover and replace the cable. To access the terminal board in cookers with a 3x2.5mm² cable, the back panel on the rear of the appliance must be removed. USE AND MAINTENANCE MANUAL WARNING: This appliance is not intended for use by persons (incl...

8 Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position. If the flame does not light after the first attempt, wait 5 minutes for the gas to dissipate before attempting to re-light the burner. Tips for using burners correctly: - Use suitable po...

9 then release the knob. Make sure that the burner remains on, otherwise repeat the operation. As for cookers without ignition trough knob, press the thermostat knob and the key with the spark symbol, wait about 10 seconds after the burner has been completely lit and then release the knob. Make sure...

11 - the symbol indicates that only the top external element (1200W) has been turned on; - the symbol indicates the only the bottom element (1800W) has been turned on; - the symbol indicates that only the grill element (1800W) has been turned on; - the symbol indicates that the top external element ...

12 Before cooking, allow the oven to reach the desired temperature setting waiting for the orange light to turn off. This type of oven is equipped with a circular element around which a fan has been installed that creates forced-air circulation in the horizontal direction. Thanks to this type of ope...

13 Grilling on the shelf : In this case, the shelf supplied is placed on level 1 or 2 and the foods to be grilled are placed on top, while the tray is inserted on the lower levels to collect the cooking juices. Then turn on the grill element switching the thermostat to the relative position (electri...

14 AFTER-SALES TECHNICAL SERVICE AND SPARE PARTS TECHNICAL SERVICE AND SPARE PARTS Before leaving the factory, this appliance was tested and adjusted by specialist skilled staff to give the best operating results. Any subsequent necessary repairs or adjustments must be carried out with the greatest ...