Page 2 - EFORE; WARNINGS RELATED TO YOUR PERSONAL SAFETY; WARNING; THIS MANUAL OR THE WARNING LABELS
829E O WNER /O PERATOR M ANUAL • 15 B EFORE U SING T HIS E QUIPMENT Berkel’s slicers are designed to slice meat and other food products safelyand efficiently. However, unless the operator is properly trained and super-vised, there is the possibility of a serious injury. It is the responsibility ofth...
Page 3 - ABLE; Cleaning Instructions
829E O WNER /O PERATOR M ANUAL • 1 T ABLE OF C ONTENTS Page General Safety Instructions ....................................................................................................... 2-3 Equipment Description .....................................................................................
Page 4 - PELIGRO; CUCHILLA FILOSA; para evitar serios accidentes a su; LA MçQUINA DEBE apoyarse sobre un nivel solido y plano.
PELIGRO CUCHILLA FILOSA para evitar serios accidentes a su persona siga las instrucciones de este manual y 1. NUNCA utlice esta mçquina sin previa instrucciùn y autorizaciùn de susupervisor. 2. LA MçQUINA DEBE apoyarse sobre un nivel solido y plano. 3. LOS PROTECTORES deben colocarse ANTES de enchuf...
Page 5 - SHARP KNIFE BLADE; to avoid serious personal injury
WARNING SHARP KNIFE BLADE to avoid serious personal injury follow all the instructions in this manual and 1. NEVER touch this machine without training and authorization by yoursupervisor. 2. MACHINE MUST BE on solid level support. 3. GUARDS MUST BE in place before plugging in and turning on machine....
Page 7 - To avoid serious personal injury, properly
829E O WNER /O PERATOR M ANUAL • 5 WARNING To avoid serious personal injury, properly install slicer in adequate work area • ALWAYS use a qualified technician for installation.• ALWAYS install slicer in work area with adequate light and space.• ONLY operate slicer on a solid, level support.• NEVER b...
Page 8 - Plug the power cord into a grounded 120V AC electrical outlet.; WHEN MOVING THE PRODUCT TABLE, GRASP
6 • 829E O WNER /O PERATOR M ANUAL 2. Plug the power cord into a grounded 120V AC electrical outlet. 3. Slide the product table back and forth holding on to the Product Table Handle. If there is any rough operation or obstruction, shut off, unplug power cord and call your Berkel serviceman. 4. Tuurn...
Page 9 - Remove the nuts and take the stones off the shafts.; CAUTION; Dirty Stones Cannot Sharpen!; IF THE SHARPENING STONES HAVE BECOME COATED WITH FOOD FATS
829E O WNER /O PERATOR M ANUAL • 7 4. Check the stones. If they do not turn freely, are greasy or are full of metallic build-up, they must be cleaned. (See “Cleaning the Sharpening Stones,” page 7). If the stones are cracked orchipped they must be replaced. 5. Oil the sharpener shafts. Place a few d...
Page 10 - Turn slicer OFF and unplug the power cord.
8 • 829E O WNER /O PERATOR M ANUAL Berkel recommends that a spare set of stones (Berkel Part #825-00112 be kept available forthorough cleaning procedures, and in case of breakage, so you will not lose your sharpening capabili-ties. C LEANING & S ANITIZING 1. Turn slicer OFF and unplug the power ...
Page 12 - Plug in the slicer and switch on the power.; Product not slicing properly thick and thin or irregular slices; sharpen a clean knife.
10 • 829E O WNER /O PERATOR M ANUAL 5. Loosen the sharpener locking knob, raise and rotate the sharpener until the stones sit with one on each side of the knife. Retighten the knob to hold the sharpener in its sharpening position. 6. Plug in the slicer and switch on the power. 7. Press the sharpenin...
Page 13 - Knife not sharpening; serviceman adjust them.; Electrical failure; white power ON light should be illuminated when the slicer is on.; Thickness control knob not operating gauge plate
829E O WNER /O PERATOR M ANUAL • 11 Knife not sharpening 1. Are sharpening procedures being followed exactly as explained in this manual (page 10). 2. Are sharpening stones clean? If not, clean according to instructions given in “Sharpener Maintenance” section (page 7). 3. Is the knife clean? If coa...
Page 16 - Warranty; BERKEL SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTY OF; Model 180 slicers carry a 90-day warranty.
BK46709 (December 2006) Warranty Effective: February 14, 2002 Berkel Company (“Berkel”) warrants to the Buyer of new equipment that said equipment,when installed in accordance with our instructions and subjected to normal use, is freefrom defects in material or workmanship for a period of one (1) ye...