BenQ VP150X - Manuals

Introduction 1 INTRODUCTION Projector Features A. Image Resolution By using advanced intelligent compression technology, it is fully compatible with true XGA, and supports SXGA . Theadvanced intelligent compression technology enables the projector to present clear compression XGA images withoutline ...

2 English Description A FRONT Figure 1. Front view B RIGHT Figure 2. Right view C BOTTOM Figure 3. Bottom view Projecton Lens Ventilation Hole Lamp cover

Introduction 3 Installation A Image Size Adjustment z This projector is basically designed to project on a flat projection surface. z This projector can be focused from 1m–12.3m. z Refer to Figure. 4 to adjust the screen size. Figure 4. Positioning B Adjustable Feet Picture tilt and projection angle...

4 English Moving the Projector Use the carrying handle when moving the projector. Replace the lens cover and rotate the feet fully clockwise (to shorten the feet) when moving the projector to preventdamage it. Figure 6. Moving the projector Caution The carrying bag is supplied to protect the project...

6 English CONNECTION Connect the Projector to Computer Figure 8. Connect to PC Connect the Projector to Notebook Figure 9. Connect to notebook Computer Input Control Port Output Computer in Control Port VGA Cable (supplied) ADB Port Input Mouse Cablefor PS/2 Port (Supplied) Computer output Computer ...

Connection 7 Connect the Projector to Macintosh Figure 10. Connect to Macintosh Connect the Projector to Power Book Figure 11. Connect to Power Book Connect to Video/ S-Video Figure 12. Connect to Video, S-Video Computer Input Computer in VGA Cable (supplied) ADB Port Input Mouse Cablefor PS/2 Port ...

8 English OPERATION Turn On/Off Procedure A Power on Press the Standby/On key to turn on the lamp. The LED will blink green during warm up and then light solid green. z “INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE” will be displayed on the screen after theprojector identifies the input signal. z “S...

10 English The remote control allows you to operate the function keys on the projector and to emulate mouse function when theprojector is connected to a computer. Inserting Batteries in the Remote Control Be sure to follow instructions in placing batteries into the remote control units. z Push and s...

Operation 11 Remote Control Range The remote sensors are located on the back of the unit. It can function in a range 50 degrees horizontal and 30 degreesvertical relative to a line that is a right angle to the remote sensor. The distance between the remote control and remotesensor must be shorter th...

12 English 2. Lamp is not well attached If the LED blinks rapidly, it indicates that the lamp is not attached properly. 3. Temperature is too high If the internal temperature of the projector is too hot to operate safely, the LED will blink slowly for one minute andthen the lamp will turn off automa...

14 English OSD Main OSD Menu Press Menu and the main OSD menu structure will appear as shown at right (Figure 18). Whenever AVconnector is attached, 4 sub-pages appear in the menu:Display page, Image page, Control page and Sourcepage. Press the " ▲ " or " ▼ " key to enter Display pag...

Operation 15 B Image Page Select the Image sub-page and Auto Resize will be highlighted. There are five items on this page: Auto Resize, H. Phase, H. Size, H. Position, and V. Position (Figure 21). If the input is from video, s-video instead of PC, another different IMAGE sub-page including Image Ra...

Operation 17 Other Correspondent and Remote Functions Messages OSD FUNCTION Source The selected source will be displayed at the bottom right of thescreen for 3 seconds after selecting the source. Freeze The image will be frozen when the Freeze is pressed. A mark appears at the lower right of the scr...

18 English MAINTENANCE AND TROUBLESHOOTING A Lamp Replacement Refer to page 11. B Cleaning the Lens Follow the steps below to clean the projection lens: 1. Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth (abrasive cleaners, solvents orother harsh chemicals might scratch the le...

Specifications 19 SPECIFICATIONS A Optical LCD Panel 3 sheets of liquid crystal panels, 3 primary color lights shutter system Lens Manual zoom, manual focus (F=1.73 to 2.17 f=37.8 to 49 mm) Lamp 150W UHE Image size 19 to 310 Projection Distance 1 to 13 M B Electrical Inputs RGB (H:31.47 to 68.70 kHz...