Page 2 - Projector Information
Copyright Copyright © 2003 by BENQ Corporation. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, che...
Page 3 - Table of Contents
Table of Contents iii Table of Contents BenQ PB7200/ PB7220/ PB7100 User’s Manual Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 5 - INTRODUCTION; Caution
Introduction 1 BenQ PB7200/ PB7220/ PB7100 User’s Manual INTRODUCTION Caution TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SER-VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. PLEASE READ THIS USER’S MANUAL BEFORE YOU OPERATE YOUR PROJECTOR. SAVE THIS USER’S MANUAL FOR F...
Page 6 - Shipping Contents; Alternative Accessories
Introduction 2 BenQ PB7200/ PB7220/ PB7100 User’s Manual Shipping Contents The projector is shipped with the cables required for connection to standard PC or laptop computers. Carefully unpack and verify that you have all the items shown below. If any of these items are missing, please contact perso...
Page 7 - Projector Description; Projector
Introduction 3 BenQ PB7200/ PB7220/ PB7100 User’s Manual Projector Description Projector External control panel (see next page) Audio jack Projection lens USB mouse connector Front adjuster S-Video jack IR remote sensor RS 232 control port Ventilation grill AC power cord inlet Speaker Main power swi...
Page 8 - External Control Panel
Introduction 4 BenQ PB7200/ PB7220/ PB7100 User’s Manual External Control Panel Power Presses the Power key to turn the projector on or off. Source Selects signal sources from among RGB-1, RGB-2, YP b P r, S-Video and Video. Left Exit Right Menu Menu will display the menu system on screen. Press Men...
Page 10 - Remote Control Description
Introduction 6 BenQ PB7200/ PB7220/ PB7100 User’s Manual Remote Control Description Power Menu 3 Left/ Keystone - 4 Right/ Keystone + Auto L-Click/ R-click Zoom in/ out Return PIP Source PIP Pos. PIP Size By pressing the PIP-Source, PIP-Pos and PIP-Size hotkeys, you can enable the PIP (Picture In Pi...
Page 11 - Remote Control Effective Range
Introduction 7 BenQ PB7200/ PB7220/ PB7100 User’s Manual Remote Control Effective Range The remote sensors are located on the front and the back of the projector. It can function in a range of 30 degrees horizontally and 30 degrees vertically relative to a line that is a right angle to the remote se...
Page 12 - INSTALLATION; Screen Size
Installation 8 BenQ PB7200/ PB7220/ PB7100 User’s Manual INSTALLATION Screen Size Place the projector at the required distance from the screen according to the desired picture size (see the table below). • PB7200/ PB7220 (XGA) screen size chart Distance from screen Diagonal measurement Distance from...
Page 13 - Connecting to Various Equipment; HDTV Equipment
Installation 9 BenQ PB7200/ PB7220/ PB7100 User’s Manual • PB7100 (SVGA) screen size chart Connecting to Various Equipment HDTV Equipment The projector is capable of displaying various High Definition TV display modes. Some of these sources are: Most of these sources will provide an analog component...
Page 16 - OPERATION; Start Up
Operation 12 BenQ PB7200/ PB7220/ PB7100 User’s Manual OPERATION Start Up 1. Plug the power cord into the projector and into a wall socket. 2. Turn on the main power switch. 3. Press and hold POWER to start the unit. The back-lit POWER key flashes green and stays green when the power is turned on. (...
Page 17 - Digital Keystone Correction; Auto Adjustment
Operation 13 BenQ PB7200/ PB7220/ PB7100 User’s Manual Digital Keystone Correction Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. To correct this, press 3 Left / Right 4 (hot key) on the control panel of the projector or KEYSTONE 3 / 4 o...
Page 18 - Source Selection
Operation 14 BenQ PB7200/ PB7220/ PB7100 User’s Manual Source Selection When several input sources are available, press the SOURCE key to make a selection from the control panel of the projector or the remote control. Blank Uses Blank to hide the screen image. You can unseal the image gradually by u...
Page 19 - Menu System
Operation 15 BenQ PB7200/ PB7220/ PB7100 User’s Manual Menu System Press Menu for the main menu, and then press 3 or 4 to select a sub-menu. Press Menu again to select items in the sub-menu. Menu Bar Sub-menu Display Image Source Control PIP PC KeystoneBrightnessContrastPhaseH Size Auto ResizeH Posi...
Page 25 - Shutdown
Operation 21 BenQ PB7200/ PB7220/ PB7100 User’s Manual Shutdown 1. Press and hold POWER and a warning message will appear. To turn off the projector, press and hold POWER again. 2. The fan will continue to run for approximately 90 seconds. 3. Turn off the main power switch. 4. Disconnect the power c...
Page 26 - MAINTENANCE; Lamp Information; Use and Replacement of the Lamp; Lamp Replacement
Maintenance 22 BenQ PB7200/ PB7220/ PB7100 User’s Manual MAINTENANCE Lamp Information Use and Replacement of the Lamp When the Lamp Indicator lights up red or a message appears suggesting the time of lamp replacement, please install a new lamp or consult your dealer. An old lamp could cause a malfun...
Page 28 - Resetting Lamp Hours; Temp Information; llustration
Maintenance 24 BenQ PB7200/ PB7220/ PB7100 User’s Manual Resetting Lamp Hours If you replace the lamp after 2000 hours of operation, please follow the instructions below within 10 minutes of powering on. Temp Information When the LED lights up, it is warning you of the following possible problems: 1...
Page 31 - Service Information; Accessories (included in the standard package)
Maintenance 27 BenQ PB7200/ PB7220/ PB7100 User’s Manual Service Information Accessories (included in the standard package) Alternative Accessories Optional Accessories (not included in the standard package) Ordering Parts or Getting Information For product information, product assistance, service i...
Page 32 - TROUBLESHOOTING; Common Problems & Solutions; NO POWER
Troubleshooting 28 BenQ PB7200/ PB7220/ PB7100 User’s Manual TROUBLESHOOTING Common Problems & Solutions NO POWER Try these solutions: • Make sure the power cord is inserted snuged into the AC adapter socket. • Make sure the power cord is inserted snuged into the power outlet. • Toggle the power...
Page 33 - REMOTE CONTROL DOES NOT WORK; Status Messages; Description
Troubleshooting 29 BenQ PB7200/ PB7220/ PB7100 User’s Manual REMOTE CONTROL DOES NOT WORK Try these solutions: • Replace the batteries with new ones. • Make sure there is no obstacle between the remote control and the projector. • Stand within 6 meters (19.5 feet) of the projector. • Make sure nothi...
Page 34 - SPECIFICATIONS; Projector Specifications; Technical Specifications; Electrical; Output
Specifications 30 BenQ PB7200/ PB7220/ PB7100 User’s Manual SPECIFICATIONS Projector Specifications Technical Specifications Note: All specifications are subject to change without notice. General Product name Personal Projector Model name PB7200 1024X768 XGAPB7220 1024X768 XGAPB7100 800X600 SVGA Opt...
Page 35 - Timing Chart; Resolution
Specifications 31 BenQ PB7200/ PB7220/ PB7100 User’s Manual Timing Chart Resolution H Sync (kHz) V Sync (Hz) Remark 640x350 31.5 70.1 640x400 37.9 85.1 VESA 720x400 31.5 70.0 720x400 37.9 85.1 VESA 640x480 31.5 60.0 VESA 640x480 37.9 72.8 VESA 640x480 35 66.7 Macintosh 640x480 43.3 85.0 VESA 800x600...
Page 36 - DIMENSIONS
Dimensions 32 BenQ PB7200/ PB7220/ PB7100 User’s Manual DIMENSIONS Unit: mm
Page 37 - WARRANTY; Limited Warranty
Warranty 33 BenQ PB7200/ PB7220/ PB7100 User’s Manual WARRANTY Limited Warranty BENQ warrants this product against any defects in material and workmanship, under normal usage and storage. Exclusion to Warranty: The lamps are considered a consumable item and are warranted for 90 days or 500 hours, wh...
Page 38 - SAFETY REGULATIONS; FCC Statement; EEC Statement
Safety Regulations 34 BenQ PB7200/ PB7220/ PB7100 User’s Manual SAFETY REGULATIONS FCC Statement CLASS A : This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. I...
